Creating a New Wash Protocol
To specify a Move cycle:
1.Display the header information for the selected wash protocol, as outlined on page 41. The display will read:
Select option
MOVE PURGE
2. Select MOVE. The display will read:
Start strip? | 1 |
|
|
3.Using the keypad, enter the strip number where the move cycle should start.
4.Press ENTER. The display will read:
End strip? 12
5.Using the keypad, enter the strip number where the move cycle should end.
6.Press ENTER. The display will read:
Cycles? 1
7.Using the keypad, enter the number of the specified move cycles that are to be sequentially performed.
Note: Between 1 and 9 Move cycles can be specified.
8. Press ENTER. The display will read:
Select option
ASPIRATE DISPENSE
9.Specify Aspirate, Dispense, Soak and Fill operations in the sequence as they are to be carried out, as described in the following sections.
10.When all of the operations for the Move cycle have been sequentially specified, specify End Loop to designate the end of the Move cycle.
Opsys MW™ User’s Guide | 47 |