Jet Tools JMS-12SCMS Assembly, Unlocking the Slide Carriage, Releasing the Cutting Head, Locking

Assembly

Unlocking the Slide Carriage

Loosen the slide carriage lock knob (A).

When transporting or storing the miter saw, the slide carriage (B) should always be locked in position.

Releasing the Cutting Head

When not in use, lock the cutting head in the down position. Failure to comply can cause serious injury or damage equipment.

Unlocking

1.Push down on the switch handle (page 10).

2.Pull out the hold-down latch (A, Fig. 2).

3.Raise the cutting head to the up position.

Locking

Note: When not in use, lock the cutting head in the down position.

1.Push the cutting head down

2.Press the hold-down latch (A, Fig. 2) in to lock.

Important: Always use the carrying handles when lifting or moving to avoid damage to the machine.

Figure 1

Figure 2

Installing the Dust Bag

1.Squeeze the metal collar wings (B, Fig. 3) of the dust bag (A, Fig. 3).

2.Place the dust bag neck opening around the exhaust port (C, Fig. 3), and release the collar wings (B).

To empty the dust bag, remove from exhaust port,
open zipper on underside of bag and empty into
waste container.
Note: Check and empty bag frequently. Do not wait	Fif
for it to get full.
	Figure 3

12