Jet Tools JMS-12SCMS manual Installing the Safety Hold-down Clamp, Power Cord Storage Clips

Installing the Safety Hold-down Clamp

1.Place the hold-down clamp assembly (A, Fig. 4) in a mounting hole located behind the right or left fence (B, C).

2.Thread the hold-down clamp knob (D) into the hole located at the rear of the saw base.

3.Tighten the hold-down clamp knob (D).

Figure 4

Power Cord Storage Clips

The slide carriage has two clips on the rear for cord storage when the machine is not in use.

To assemble:

Attach each storage clip (A, Fig. 5) to the rear of slide-bar seat (C) with one mounting screw (B).

Fi

Figure 5

Saw Blade Wrench

For convenience, storage clip (A, Fig. 6) is located at the left rear foot of the base for storing the blade wrench (B).

Figure 6

13