Jet Tools JMS-12SCMS manual Introduction Specifications, Cutting Capacity

Introduction

This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and maintenance procedures for the JET Model JMS-12SCMS Dual Bevel Sliding Compound Miter Saw with laser. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown. This machine has been designed and constructed to provide years of trouble free operation if used in accordance with instructions set forth in this manual. If there are any questions or comments, please contact either your local supplier or Walter Meier. Walter Meier can also be reached at our web site: www.waltermeier.com.

Specifications

Model Number	JMS-12SCMS
Stock Number	707120
Motor	120V, 60Hz, 15A
No Load Speed (Arbor)	4200RPM
Motor Arbor Shaft Size	5/8"
Blade	12", 60T, carbide tipped
Blade Arbor Size	1" with 5/8" reducer
Miter Stops	ten at -45° to 60°
Bevel Stops	0°, 33.9°, 45° left and right
Base Dimensions	37-1/2” x 26-1/4”
Net Weight	72 lb.

The above specifications were current at the time this manual was published, but because of our policy of continuous improvement, Walter Meier (Manufacturing) Inc., reserves the right to change specifications at any time and without prior notice, without incurring obligations.

Cutting Capacity

Cut Type	Miter Angle	Bevel Angle	Cutting Capacity
Cross Cut	0º	0º	4" x 12-1/4"
Miter	45º Right & Left	0º	4" x 8-3/4"
Miter	60º Right	0º	4" x 6-1/4"
Bevel	0º	45º Left	2-1/2" x 12-1/4"
Bevel	0º	45º Right	1-3/4" x 12-1/4"
Compound Cut	45º Right & Left	45º Left	2-1/2" x 8-3/4"
Compound Cut	45º Right & Left	45º Right	1-3/4" x 8-3/4"
Compound Cut	60º Right	45º Right	1-3/4" x 6-1/4"
Vertical Capacity (Baseboard)	0º	0º	5-1/2"

Read and understand the entire contents of this manual before attempting assembly or operation! Failure to comply may cause serious injury!

8