Jet Tools JMS-12SCMS Positive Stop Miter Angle Adjustment, Quick-cam Miter Table Lock Operation

Positive Stop Miter Angle Adjustment

Referring to Figure 19:

1. Unlock the miter table by lifting up on the quick- cam miter table lock (A).

2. Raise the positive stop locking lever (C) up; at the same time grasp the miter handle (B) and rotate the miter table left or right to the desired angle.

3. Release the positive stop locking lever (C) and set the miter at the desired angle making sure the lever snaps into place.

Note: There are ten positive stops into which the lever will lock.

4. After the angle is selected, press down on the quick-cam miter table lock (A).

Quick-cam Miter Table Lock Operation

If a miter angle required is not one of ten positive stops, the miter table can be locked at any angle between these positive stops by using the quick- cam miter table lock.

Referring to Figure 19:			Figure 19
1.	Unlock the miter table by lifting up on the quick-
	cam miter table lock (A).
2.	Raise the positive stop locking lever (C) up; at
	the same time grasp the miter handle (B) and
	rotate the miter table left or right to the desired
	angle.
3.	Release the positive stop locking lever (C).	B	A

4.Press down on the quick-cam miter table lock

(A)until it locks the miter table in place.

Note: The quick-cam miter table lock should lock the table and prevent it from moving. If adjustment is needed, see Quick-cam Miter Table Lock Adjustment below.

C

Quick-cam Miter Table Lock Adjustment

Referring to Figure 20:

1.Place the quick-cam miter lock (A) in the down position to lock.

2.Loosen the lock nut (D) with a 13 mm wrench, then turn the stop nut (E) to extend the locking arm against the base of the miter saw.

3.Test the quick-cam miter lock (A) to verify that it locks the table securely into position.

4.Tighten the lock nut (D) to lock the miter locking mechanism into place.

19

D

Figure 20

E