Jet Tools JMS-12SCMS manual Bevel Detent Pin for Crown Moldings, Compound Cuts

33.9° Bevel Detent Pin for Crown Moldings

Note: A bevel detent pin is incorporated into this machine for quick bevel adjustments when the desired bevel angle is 33.9°.

Referring to Figure 27 (except where indicated):

1.Push the bevel detent stop pin (E) in.

2.Loosen the bevel lock handle (A).

3.Rotate the cutting head (D, Fig. 28) until the bevel detent pin (E) stops the bevel angle at 33.9° on the bevel scale (F).

4.Tighten the bevel lock handle (A) before you make your cut.

Compound Cuts

Referring to Figure 27:

Setting the bevel angle

1.Extend the fence by sliding it out to the required location or remove the right sliding fence if necessary. (See Sliding Fence or Removing or Installing the Sliding Fence on page 22).

2.Loosen the bevel lock handle (A).

3.Set the desired bevel angle; then lock the bevel lock handle (A).

Setting the miter angle

4.Set the desired miter angle and lock into position. See Miter Cut.

5.Unlock the miter table by lifting up on the quick- cam miter table lock (D).

6.Raise the positive stop locking lever (C) up, at the same time grasp the miter handle (B) and rotate the miter table left or right to the desired angle.

7.Release the positive stop locking lever (C).

8.Lock the miter table by pressing down on the quick-cam miter table lock (D).

90º Crosscut – Narrow Boards

For 90º crosscut operations on small workpieces (refer to Figure 29):

1.Slide the cutting head assembly completely toward the rear of the unit and tighten the carriage lock knob (F).

2.Position the cutting head to the 0° bevel position and lock the bevel lock handle (C).

3.Position the table to the 0° miter angle and lock the quick cam miter table lock (D).

24

Figure 27

Figure 28