Jura Capresso IMPRESSA XS90, 95 Cup illumination, Adjusting your machine to the water hardness

Page 8

Place a receptacle under the 2-stage frothing jet (24) and press

one of the Steam keys .

The system now fills up automatically. A little water will leak from the frothing jet.

SYSTEM FILLING

HEATING UP

PRESS RINSE

Place a cup under the height-adjustable coffee spout (18).

Press Rinse .

MACHINE RINSING

Now the water lines are flushed with fresh water. A little water will leak from the coffee spout (18).

SELECT PRODUCT

You can now make a product of your choice by pressing the corresponding key.

If FILL BEANS appears on the display, press one of the coffee product keys again. The grinder is not yet completely filled with coffee beans.

For a perfect frothing result, adjust the height-adjustable coffee spout (18) to the size of your cup (Fig. 4).

3.1 Cup illumination

The cup illumination puts your coffee in a good light, making it a treat for the eyes as well.

When you switch on the IMPRESSA or press any key, the cup illu- mination is activated for 1 minute.

4. Adjusting your machine to the water hardness

The IMPRESSA heats up water. As a result, calcification occurs during normal use. This is indicated automatically. The IMPRESSA must therefore be adjusted to the hardness of the water used. Use the supplied test sticks to determine the water hardness or contact your local waterworks.

1° German hardness is equivalent to 1.79° French hardness.

The water hardness programming step is no longer displayed if the filter is activated.

The IMPRESSA is preset to 16°dH. This setting can be changed. To do so, proceed as follows:

SELECT PRODUCT

Open the programming door (3). Press the Rotary Switch (4) until you hear an acoustic signal.

FILTER NO

Turn the Rotary Switch (4) until the following message is dis- played:

HARDNESS

16°dH

Now press the Rotary Switch (4) to start programming.

16°dH

Now turn the Rotary Switch (4) until the required water hardness is set.

20°dH (example)

Confirm the selected setting by pressing the Rotary Switch (4).

HARDNESS

20°dH (example)

8

Image 8

Contents Impressa XS90/95 Page Page Description of the machine Contents Safety information 1.1 Warnings PrecautionsBefore you begin Checking electrical fuseAdjusting the grinding gear Power switchFilling the water tank Filling the bean tankAdjusting your machine to the water hardness Cup illuminationChanging the filter Using a Claris plus filter cartridgeInstalling the filter Rinsing the machine Making coffee Espresso, 2 espressos, 1 coffee, 2 coffeesMaking coffee with pre-ground coffee powder Machine Rinsing Select ProductMaking coffee à la carte Making hot waterDrawing off steam Frothing milkFrothing one portion of milk with the 2-stage frothing jet Frothing milk With the 2-stage frothing jet Draw OFF Steam Cleaning the Professional-Cappuccino Frother and jetSwitching the Impressa off Maintenance ProgrammingProgramming the filter Programming the amount of powder for coffee and espresso Powder Quantity Water QuantitySelect Water Quantity Temperature Programming the water portionProgramming the steam portion PortionEconomy mode Economy Mode Economy Select ProductSetting the time Programming the automatic switch-on time Time Unit onProgramming the automatic switch-off time Programming the languageProgramming the display InformationMaintenance Filling the water tank Lock functionsLocking/releasing the drawing of coffee à la carte Locking the programming functionEmptying the coffee grounds Emptying the drip trayDrip tray missing Removing stones from the grinding gearEmptying the system Prompt to run cleaning cyclePrompt to decalcify General cleaning instructions CleaningDecalcifying Disposal Tips for perfect coffee Fill Water Tank Rinse Water Tank Press SteamProblems Problem Cause RemedyTechnical data Legal information