STEP 2 : CABINET ASSEMBLY
2
PANEL EDGE
CAM in LOCKED
POSITION
METAL
METAL
Use allen key provided or #3 phillips screwdriver.
1Attach TOP and Bottom to Back by CAREFULLY aligning edge holes over Cam Pins and gently push together to avoid damaging cam pins. DO
NOT BANG OR SLAP PANELS TOGETHER!!!
BOTTOM | PANEL |
|
����
2Insert Cam, push all the way in under panel level (may
require some force) and make sure Arrow points to outside edge.
Gently push down to bring panels together before you tighten the Cam. Start with cams at each end.
Cam Arrow faces away from outside edge when tightened.
BOTTOM | PANEL |
|
~5~
3 | Insert Center COUPLER | |
| BAR | by guiding edge |
| holes | over bottom |
| Cam Pins. Lightly push | |
| out top panel edge to | |
| allow Cam Pins to go in | |
| Coupler Bar. Insert and | |
| tighten Cams. | |
3 |
|
COUPLER |
|
INSIDE |
|
CABINET | BAR |
|