CONTROLS : PLUG IT IN (wait one minute) and ENJOY!
FEATURES: | - Default SET temperature 57º F/14º C (ideal for wine storage). | DISPLAY: | KEYS |
| - Calibration option of the temperature sensor. |
| |
|
|
| |
| - Display of actual temperature by request. |
|
|
| - SET temperature range | 57 |
|
| - Digital temperature sensor. |
| |
|
|
| |
| - Dual display Fº/Cº. |
|
|
-Settings are stored in memory for power failures.
-Pre programed software will reach the quietest most efficient operation.
OPERATION: - The display will show the detected temperature until the temperature will fall within 3º of the SET POINT.
-If the temperature is above the default 57º F + 1º or other preset value, after a delay of 1 minute the fan will start, followed by the compressor within the next minute.
-The unit will cycle ON/OFF based on the temperature reading. Fan speeds are automatically set by the controller to achieve optimum performance.
-Minimum ON and OFF cycle times are imposed by software, to prevent "short cycling".
| CONTROLLER |
|
|
| ACTION |
| DISPLAY EXAMPLE | ||
| OPERATION |
|
|
|
|
|
| ||
|
|
|
|
| BEFORE | AFTER | |||
|
|
|
|
|
| ||||
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| ||
| TO DISPLAY: | Actual temperature: | PRESS |
|
| 57º | 56º | ||
|
| SET temperature: | PRESS |
|
| 70º | 57º | ||
|
|
|
|
|
|
|
| ||
| TO MODIFY SET | PRESS and RELEASE |
|
|
| 57º | 57º | ||
| TEMPERATURE | To increase: | PRESS | once per degree | 57º | 58º | |||
| (range is | ||||||||
|
|
|
|
|
|
|
| ||
To decrease: | PRESS | once per degree | 57º | 56º | |||||
|
| ||||||||
|
| The new value will be memorized and the controller will reset automatically. |
|
| |||||
|
|
|
|
|
| ||||
| TO CHAANGE FROM | PRESS and HOLD | until buzzer sounds in 5 seconds | 57º | 14º | ||||
|
|
|
|
|
|
|
| ||
| ºF to ºC: or ºC to ºF | The new value will be memorized and the controller will reset automatically. |
|
| |||||
|
|
|
|
|
|
| |||
| TO CALIBRATE: | PRESS and HOLD | while holding PRESS | and RELEASE | 57º | 57º | |||
|
| Wait 5 seconds |
|
|
| 57º | F0 | ||
|
| USE | or |
|
|
| F0 | F1 | |
|
|
| for each degree of offset |
|
| F0 | |||
NOTE: A negative offset 
will result in a warmer cabinet and a positive offset 
will result in a cooler cabinet. The new value will be memorized and the controller will reset automatically.
SAFETY FEATURES:
ALARM: - If the temperature exceeds 72º F the unit will shut down, a sound warning will start and the dispaly will blink AL alternating with the temperature reading.
-This function is disabled in the first 4 hours “ Cool Down” period or after any reset for another 4 hours.
-The unit will restart and continue the cooling and cycling if the temperature falls below 72º F.
TO RESET: - Unplug and re plug the unit.
~12~