Cooling Unit Installation, Do not

STEP 5 : COOLING UNIT INSTALLATION

1GET HELP BEFORE INSTALLING AND KEEP CHILDREN CLEAR OF CELLAR CONSTRUCTION AREA.

Get helper to help guide unit, keep light cord clear of edge inside cellar and to prevent tipping of cellar. MAKE SURE INSULATION STRIP IS IN CORRECT ORIENTATION. Run light cord through Cut-out. Slide unit into the back

opening by angling unit A to allow light cord to clear and straighten to push in B . Screw allen bolts (I) through bottom flange holes. Make sure unit is level!

CHECK

INSULATION

STRIP CELLAR

INSIDE

SHELF

KEEP UNIT LEVEL

LEVEL TO

OPENING

DO NOT!!!

SIDE VIEW

STRAIGHTEN AND PUSH THROUGH

GET HELPER TO LIFT UNIT LEVEL AND PULL FROM INSIDE

CORD MUST

CLEAR OPENING

(I) x2 Flange

bolts in

cooling unit

box.

D	DO NOT OVER
	TIGHTEN

NOTE: If unit is operated according to specifications overflows will not occur. Excess condensation is only caused by extreme conditions. Unit will shut off at 72 °F and will restart when temperature drops or unit is repluged. (In this case insert 3/8” O.D. hose to drain hole, cut to appropriate length.)

Optional (not required) except as emergency drain.

~9~

Container