Turbo Chef Technologies C3 owner manual O B L E M a R E a

M A I N T E N A N C E 19

The following is a list of all error fault/codes and possible problems that the oven may experience. Please attempt the recommended action before calling for service.

T A B L E 1: Error Codes/Faults, Possible Causes and Suggested Remedies

P R O B L E M A R E A	P O S S I B L E C A U S E (S )	S U G G E S T E D R E M E D Y
O R F A U L T C O D E
No power to oven	o Oven not plugged in.	o Plug oven in.
	o Main circuit breaker tripped.	o Verify wall circuit breaker is on. Reset
		breaker and then Power oven back on.
Oven does not	o Oven is in off mode.	o Press the “Oven On” Key.
warm up	o Door is not closed.	o Close the cook chamber door.
	o Oven has been switched off at the	o Turn the oven to OFF mode, leave for
	main circuit breaker.	2 minutes. Unplug the oven, leave for
		2 minutes, re-plug, switch on isolator/Main
		Supply & then switch on oven.
	o Cooking platter is not in the oven	o Place cooking platter in oven correctly.
	correctly.
Display Reads	o Cook chamber door open.	o Open and close door several times.
“Oven Door Open”	o Cooking platter not in oven correctly.	o Place cooking platter in oven correctly.
and Alarm sounds.	o Platter is in oven correctly, but oven	o Check for food particles where platter sits
	reads “Oven Door Open.”	and around door.
Oven Does Not	o Oven is not clean. Large deposits	o Clean the oven.
Cook Properly	of grease, carbon or food debris will
	dilute the microwave.
	o Incorrect Group and Item name	o Check with the cook time sheet.
	selected for the product or Incorrect
	Cook Time selected for the product.
	o Product was not cooked at correct	o Ensure that the product was in the correct
	programming temperature.	state before being placed in the oven
	For example: frozen or chilled.
	o Wave Guide Cap or cooking	o Change the Wave Guide Cap and
	platter soaked or badly chipped.	cooking platter.
	Absorbed moisture or grease, apart
	from cooking will seriously affect	o Change Cook Chamber Filter.
	the durability of the platter or
	block the holes in the platter.
F1 Blower	o Oven power interrupted	o Verify wall circuit breaker is On. Reset
		breaker and then Power oven back on. Place
		the oven into “Oven Off” for 2 minutes,
		disconnect the plug for minimum of 2 min-
		utes, re-plug and press “Oven On” key.