Grounding Instructions

I N T R O D U C T I O N 3

PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY

To reduce the risk of exposure to excessive microwave energy:

ox DO NOT attempt to operate this oven with the door open since open-door operation can result in harmful expo- sure to microwave energy. It is important not to defeat or tamper with the safety interlocks.

ox DO NOT place any object between the oven front face and the door or allow soil or cleaner residue to accumulate on the sealing surfaces.

ox DO NOT operate the oven if it is damaged. It is particularly important that the oven door close properly and that there is no damage to the door (bent), hinges and latches (broken or loosened), and door seals and sealing surfaces.

ox DO NOT have the oven adjusted or repaired by anyone except a factory authorized service technician.

This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord that has a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded. Consult a qualified electrician or serviceman if uncertain about the ability to follow grounding instructions or if doubt exists as to whether the appliance is properly grounded.

ox DO NOT use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the appliance.

Power Supply Cord Replacement

If the power supply cord is damaged, it MUST BE replaced by the manufacturer, its service agent, or a similarly qualified person in order to avoid a hazard.

WARNING: Improper grounding can result in a risk of electric shock.

RF INTERFERENCE CONSIDERATIONS

The C3 oven generates radio frequency signals. This device has been tested and determined to be in compliance with applicable portions of FCC part 18 requirements and to the protection requirements of Council Directive 89/336/EEC on the approximation of the laws of the Member States relating to electromagnetic compatibility at the time of manu- facture. However, some equipment with sensitivity to signals below these limits may experience interference.

If your equipment experiences interference,

oIncrease the physical separation between this oven and the sensitive equipment.

oIf the sensitive device can be grounded, do so following accepted grounding practices.

oIf battery powered microphones are being affected, insure that the batteries are fully charged.

oKeep sensitive equipment on separate electrical circuits if possible.

ox DO NOT route intercom wires, microphone wires, or speaker cables near oven.

SAVE THESE INSTRUCTIONS