Turbo Chef Technologies owner manual C3 Oven Assembly, Double Stacking Ovens

Page 10
DO NOT

6 I N S T A L L A T I O N

WARNING:Death, injury and equipment damage may result from improper positioning. It is the

operator’s responsibility to ensure the oven is properly positioned on countertop daily. TurboChef will not warrant any damage or injury to ovens that fall off countertops due to improper placement.

C3 OVEN ASSEMBLY

Double Stacking Ovens

Figure 1

1.Ensure the surface that will hold the stacked ovens can support the total weight (510 lbs. (231 kg)).

2.Allow each oven adequate time to cool and then unplug them.

NOTE: If you are stacking the ovens on a TurboChef oven cart, make sure that the bottom oven is bolted to the cart and the wheels are locked.

3.Attach the Stacking Bracket (TC3-0323) to the back of the bottom oven:

a.Remove the screws marked with gray arrows in Figure 1.

b.Align the holes on the Stacking Bracket with the holes on the oven and reinstall the screws.

c.Be sure to orient the bracket as shown in Figure 1.

4.Remove the legs of the oven that will be placed on top. This requires two or more persons—at least one person to lift and one person to unscrew the legs.

5.Remove the screws from the oven that will be placed on top, as marked with black arrows in Figure 1.

6.Place the oven on top of the oven with the stacking bracket attached.

WARNING: Do not attempt to lift the oven with fewer than 2 people.

WARNING: When lifting the oven, position at least one person on each side. Do not lift the oven from the front and back. Do not use the handle to lift the oven.

8.Align the holes on the Stacking Bracket with the holes on the top oven and reinstall the screws.

WARNING: Do not stack ovens over two-high.

Oven Assembly and Ceramic Platter Installation

Figure 3

1.Carefully remove the packing material from the ceramic cooking platter and Wave Guide Cap.

2.Open the oven door and place the Wave Guide Cap on top of the wave guide (center of cavity floor).

3.Slide the cooking platter along the side rails in the cook cavity (See Front & Back label on platter).

CAUTION: Equipment damage may occur from improper installation of the ceramic platter.

Install the ceramic platter with the rounded corners to rear of oven (the lip of the platter should face forward).

If door does not close with the platter installed,

force the door closed. Call TurboChef for assistance at 800.90TURBO or +1 214-379-6000.

Stacking Bracket

F I G U R E 1: Double Stacking Ovens

F I G U R E 2: Oven Leg Removal

Lip faces forward

F I G U R E 3: Oven Assembly and Ceramic Platter Installation

Image 10
Contents Accelerating the World of Cooking TM Page For service or information call Installing or servicing this equipment Table of Contents Important Safety Instructions IntroductionGrounding Instructions Power Supply Cord ReplacementRF Interference Considerations Oven Description and Specifications SpecificationsVentilation Requirements InstallationInstallation Delivery and LocationOven Assembly and Ceramic Platter Installation C3 Oven AssemblyDouble Stacking Ovens Built-In Installation G U R E 5 Installation Near Open Heat Source Product Recipes OperationGlossary of Terms ModesControl PAD To Power Up The Oven W E R U P Initial Power OnCooking Instructions 0030 Turning the Oven OFFDone Editing a Food ItemStart Screen ENABLING/DISABLING the Edit ModeCooking Options Start and Done Screens Done ScreenLoading a Menu from a Smart Card Saving a Menu to a Smart CardHandling Tips How to Develop Cook SettingsOperating Tips Do NotMaintenance CleaningTroubleshooting Removing Components for CleaningO B L E M a R E a F4 Monitor Catalytic Converter Limited Warranty I N T E N a N C E23 Warranty Service Limited WarrantyTurbochef Global Warranty System DisclaimerI N T E N a N C E Page Page For service or information