Turbo Chef Technologies C3 owner manual F4 Monitor

20 M A I N T E N A N C E

P R O B L E M A R E A	P O S S I B L E C A U S E (S )	S U G G E S T E D R E M E D Y
O R F A U L T C O D E
F2 Low Temp	o Oven power interrupted.	o Verify wall circuit breaker is on. Reset
		breaker and then power oven back on.
	o Cooking platter restricting air flow.	o Remove cooking platter and verify that holes
		are not clogged with debris.
	o Air nozzles on top of cooking	o Remove cooking platter and filter (left rear
	chamber are clogged.	section of oven cavity) and clean.
	o Catalytic converter is clogged	o Verify food items are not directly cooked on
	and restricting proper air flow	the cooking platter, as excess grease particles
	circulation in the oven.	may accumulate on the catalytic converter.
		Reference “Catalytic Converter” (page 21).
	o Circuit breaker tripped.	o Refer to Troubleshooting steps (page 18)
		prior to calling for service.
	o Blower motor not running.	o Refer to Troubleshooting steps (page 18)
		prior to calling for service.
F3 Mag Curr	o Circuit breaker tripped.	o Place the oven into “Oven Off” mode
		for 2 minutes, disconnect the plug for
		minimum of 2 minutes, re-plug and
		then press “Oven On” key.
	o Microwave circuit defective.	o Refer to Troubleshooting steps (page 18)
		prior to calling for service.
F4 Monitor	o Oven cook door was opened while	o Refer to Troubleshooting steps (page 18)
	oven was cooking.	prior to calling for service.
	o Oven cook door switches are out	o Refer to Troubleshooting steps (page 18)
	of order.	prior to calling for service.
F5 Mag Temp	o Blockage of cool air into the oven.	o Check for paper towels or anything that
		may be obstructing cool air into the oven.
	o Rear cooling fan exhaust guard	o Check rear fan to see if it is free of debris.
	is clogged.	Clean as required.
		o Refer to Troubleshooting steps (page 18)
		prior to calling for service.
F6 EC Temp	o Blockage of cool air into the oven.	o Check for paper towels or anything that
		may be obstructing cool air into the oven.
	o Rear cooling fan exhaust guard	o Check rear fan to see if it is free of debris.
	is clogged.	Clean as required.
		o Refer to Troubleshooting steps (page 18)
		prior to calling for service.

Note: All Fault Codes listed in bold will terminate a Cook Cycle upon discovery.

Note: Any fault occurrence during Cook mode will be logged in the Fault Counter.

Note: F6 fault code will not terminate a cook cycle, however it will alert the user of a possible air circulation problem.