Setting the Clock
Setting the Clock
The Q pad is used to set the clock. The clock may be set for 12 or 24 hour time of day operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in_ or when the power supply to the range has been interrupted_ the time in the display wiil flash.
Press _. | The display will stop flashing. |
iNSTRUCTiONS | PRESS | DISPLAY |
To set the clock (example | below for 1:30) |
|
|
| ||||
1. | Press Q. | in the | display | (Fig. | 1). | (_) | ||
2. | Press ] | 3 0 pads to set the | time of | day to | 1:30 | (Fig. 2). Press STy. | ] 3 0 | |
| The time of day will appear in the display (Fig. 3). |
|
Changing between 12 or 24 hour time of day dlsplay
1.Press and hold (_) for 7 seconds until "2Hr" or "24Nr" appears in Q for 7 seconds
| the | display. |
|
|
|
|
|
|
|
|
|
|
| |
2. |
| Flex |
| switch between | the | 12 and 24 | hour | time of | day | display. | Flex | |||
Press cleo°to | Clean | |||||||||||||
| The | display |
| will show | either | "2Hr" | (Fig. | 4) | or | "24Nr" | (Fig. | 5). |
| |
3. | Press _ | to | accept | the change | or | press | _ | to reject | the | change. | or press @ |
4.Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was chosen_ the clock wiii now display time from 0:00 through 23:59 hours.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
13