Kenmore 362.7562, 362.7262 Installing the Anti-Tip Device, Set of positions, Converting to LP gas

Page 46

STEP 9

installing the Anti-Tip Device

WARNING:

Range must be secured with an approved Anti-Tip device..

=Unless properly installed, the range could be tipped by you or a child standing, sitting or leaning on an open door.,

After installing the Anti-Tip device, verify that it is properly installed and engaged by removing the storage drawer and inspecting the rear leveling leg, Make sure it fits securely into the slot..

This range has been designed to meet all

recognized industry tip standards for all normal conditions.

The installation of the Anti-Tip device must meet all local codes for securing the appliance.

-The use of this device does not preclude tipping of the range when not properly installed,

°If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti-Tip device WB2X7909 Call 1-800-4-MY-HOME ®,

These Anti-Tip device installation instructions are for wood or concrete floors and walls., Any other type of construction may require special installation techniques to provide adequate fastening of the anti-tip device to the floor and wall.

1.Locate the device against the rear wall and either the right or left cabineL If the countertop overhangs the cabinet, offset the device from the cabinet by the amount of overhang. If there is no adjacent cabinet, position the edge of the device at the desired location of the range side panel.

2.Use the device as a

template and mark 2

AdjacentCabinetor

FinalLocationof Range

hole positions on the

st_e Panel_

i::

wall and 2 hole

:

_

...4Wall_oles

 

 

:

Wood FIooI::}_

/

positiOnSuseeitheronthethewoodfloor..

Holestk//;I:11t-_N_}

or concrete

floor

 

_x_ti

j))),El

 

 

DeviceSIdeJ4_!l>" (-'_-_///" /J

set of positions,

_if.__

 

co.='oto

depending

on your

%/_'///_/_

Floor

floor type

 

_

_

.eles

 

 

Rear Leveling

 

 

 

Legof Range

 

3.For wood construction, drill a 1/8"pilot hole in the center of each of the pre-marked wood floor and wall hole positions (a nail or awl may be used if a drill is not avaitable)_ Fasten the Anti-Tip device with the 4 screws provided.

Allachment10wall

J

_ J

J

 

Wall plate

H-,,

.....\\\\_\\",_',\\\\\\\".'&",'_J:

For concrete construction, you will need four

1A,,x 11/2"lag bolts and four i/2" OoDosleeve anchors (not provided). Drill the recommended size hole for the anchors into the concrete at the center of each pre- marked floor and wall hole position, Install the sleeve anchors into the drilled holes and then install the lag bolts through the device,, Do not overtighten the bolts.

,Slide the range against the wall, and check for proper installation by removing the storage drawer and inspecting the rear leveling leg, Make sure it fits securely into the slot on the Anti-Tip device,

WHEN ALL HOOKUPS ARE COMPLETED:

MAKE SURE ALL OF THE CONTROLS ARE LEFT IN THE OFF POSITION.

MAKE SURE THE FLOW OF COMBUSTION AND VENTILATION AIR TO THE RANGE IS

UNOBSTRUCTED,

Converting to LP gas

(or converting back to natural gas from LP)

This range leaves the factory set for use with natural gas. If you want to convert to LP gas, the conversion must be performed by a qualified LP gas installer_

The conversion instructions, sticker and LP orifices can be found attached to the range next to the pressure regulator,

Keep these instructions and the orifices in case you want to convert back to natural gas,. Conversion back to natural gas must be performed by a qualified installer,,

46

Image 46
Contents GAS Range Sears, Roebuck and Co Safety InstructionsCare & Maintenance Injury to PersonsImportant Safety Notice Using Your Range Do not leave any Baking, Broiling and Roasting =lnlnl Lighting Instructions How to Select Flame SizeBefore Lighting a Burner To Light a Surface BurnerWok This Way Top-of-Range CookwareDo not use a flat-bottomed Wok on a support ring OV N Contr LS Tini E Contr ILS OVENLIGHTPad.Pressthispadto turntheoven +ightonoroff Electronic Ignition Before Using Your OvenPower Outage Oven VentsOven Shelves Shelves have Shelf PositionsOven Moisture To remove a shelfType Food How to Set Your Range for BakingBaking PositionAluminum Foil Preheating Pan PlacementBaking Baking PansType of Margarine Will Affect Baking Performance Adjust the Oven Thermostatw Do It Yourself?To Adjust the Thermostat You may feel that your new oven cooks differentlyDual Shelf Cooking RoastingFrozen Roasts Ieg or loin Roasting GuideMeat To 5 lbs To 8 ibs 1o4 to To 3.6 kg Poultry To 5 Ibs Over 5 Ibs To 2.3 kgUse of Aluminum Foil BroilingOven door should be closed during broiling Broiling Guide Oven door must be closed during broilingTimed Baking and Roasting How to Time Bake or RoastHow to Set Immediate Start Automatic Stop InsteadHow to Set Delay Start and Automatic Stop Timed Baking and RoastingTo Set the Clock To Set the TimerTo Turn Off the Clock Display Press the Kitchen Timer ON/OFF pad twice To Cancel the TimerTo Reset the Timer End of Cycle Tones on some modelsHour Shut-Off How to Set for Regular Baking/Roasting How to Exit the Sabbath Feature Operating the Self-Cleaning Oven Do not use abrasives or oven cleaners CleanTo Stop a Clean Cycle How to Set the Oven for CleaningAfter a Clean Cycle Operating the Self-Cleaning Oven How to Set Delay Start of CleaningBurner Caps Sealed Burner AssembliesBurner Heads Drip pansTo get rid of burned-on Burner GratesOven Air Vents Do not store flammable materials in an oven orOven BroilerGrid BottomOven Light Replacement Lift-Off Oven DoorItsa good idea to wipe the control panel after each Lower Control Panel Front Manifold Panel and KnobsRemovable Storage Drawer To remove the storage drawerCommonwealth of Massachusetts Extinguish any open flame30* ==2 cm \ ScmTo wall on either 46 1/2 118.1 cm76.2 cm 25cmT wallImportant Safety Instructions Tools YOU will Need Connect the Range to Gas Provide Adequate Gas SupplyGas Pipe and Electric Outlet Locations Flexible Connector Hookup Rigid Pipe ProvidedGrounding--IMPORTANT Please read carefully Ground Fault Circuit InterruptersElectrical Connections METHODiSeal the Openings Temporary MethodCheck Ignition of Surface Burners Adjust Broil and Oven Burner AirAdjustment Shutters If Necessary Check Ignition of Oven BurnerRaise InstalledLeveling Range To remove the oven bottomSet of positions Installing the Anti-Tip DeviceConverting to LP gas Possible Cause Problem Burning or Oily OdorOven Door WIt.L Sears Installation Service Items, in the USA call 1-800-4-MY-HOME e

362.7262, 362.7562 specifications

The Kenmore 362.7562 and 362.7262 are reputable models within the Kenmore brand, known for their reliability and performance in the kitchen space. With a focus on user convenience and high efficiency, these models stand out due to their thoughtful design and advanced technological features.

One of the main features of both models is their spacious capacity. With ample interior space, they are designed to accommodate large meal preparations, making them ideal for families and home cooks who entertain frequently. The arrangement of shelves and compartments allows users to maximize storage while ensuring easy access to ingredients and dishes.

Both the 362.7562 and 362.7262 offer advanced cooking technologies. A key aspect is the state-of-the-art convection cooking feature that ensures even heat distribution. This technology allows food to cook more uniformly and significantly reduces cooking times. Furthermore, the models include multiple cooking modes, such as baking, broiling, and roasting, catering to various meal preferences.

To enhance the cooking experience, these models also incorporate smart features. With options for programmable cooking settings, users can easily set cooking times and temperatures. Some models even feature touchpad controls and a digital display, making it simple to monitor cooking progress and adjust settings on the fly. Additionally, the intuitive design of the controls ensures that even those less familiar with cooking appliances can operate them with ease.

Energy efficiency is another significant characteristic of the Kenmore 362.7562 and 362.7262. Engineered with energy-saving technologies, these models help reduce electricity consumption, which is not only good for the environment but also beneficial for reducing utility bills. The eco-friendly design aligns with the growing consumer emphasis on sustainability.

Cleaning and maintenance are also simple with these models. They often include self-cleaning features, allowing users to keep their ovens spotless with minimal effort. The easy-to-clean surfaces and well-placed components ensure that any spills or splatters can be managed quickly, preserving the aesthetic appeal of the kitchen.

In summary, the Kenmore 362.7562 and 362.7262 are well-equipped kitchen appliances that blend advanced technology, user-friendly controls, and energy efficiency. Their spacious design and thoughtful features make them a practical choice for anyone looking to enhance their culinary experience. With these models, Kenmore continues to deliver on its promise of providing high-quality, reliable home appliances.