Kenmore 790-9663 Operating the Triple Element some models, To Operate the Triple Surface Element

Page 13
Operating the Triple Element (some models)

Setting Surface Controls

•Operating the Triple Surface Radiant Control

Operating the Triple Element (some models)

The cooktop is equipped with a TRIPLE radiant surface element located at the right front cooktop position (See Fig. 1). Indicator lights on the control panel at that position are used to indicate what portions of the Triple radiant element will heat. The INNER light indicates that only the inner element will heat. The +MIDDLE light indicates that both inner and middle elements will heat together. The ALL light indicates that all 3 portions of the element will heat. You may switch between all of these different settings at any time during cooking.

To Operate the Triple Surface Element:

Fig. 1

Fig. 2

 

Fig. 3

Fig. 4

1.Place correctly sized cookware on the radiant surface element.

2.Touch and hold the To Operate the Triple Surface Element: pad for the Triple element position until a beep is heard. The display will show " - - ".

NOTE: Each time a pad is touched a beep will sound. If no further pads are touched within 10 seconds the request to power the element ON will clear.

3. Select the INNER (See Fig. 2), +MIDDLE (See Fig. 3) or ALL 3 elements

(See Fig. 4) to heat by pressing the Manual background pad once, twice or three times (See Figs. 4 & 5 show indicator lights with ALL 3 elements selected).

4. Touch the Triple element Manual background pad once to turn ON the power level Hi or

Manual background pad once for Lo (See Fig. 4). The Hot Surface indicator light will turn ON when the element becomes hot.

5. Each touch of the Manual background or Manual background pad will decrease or increase the power

level by 1/2 from 9.0 through 3.0. Simmer power levels between 3.0 and 1.0 will decrease or increase by .2 increments. Lo is the lowest power level available. Note: The power level may be adjusted at any time while the element is ON.

6. When cooking has been completed touch the

pad once to turn the

 

element OFF.

 

 

Each surface element provides a constant amount of heat at each setting. A

 

glowing red surface heating area extending beyond the bottom edge of the

 

cookware indicates the cookware is too small for the surface heating area.

Fig. 5

Note: The Hot Surface indicator light will remain ON if the cooktop is still

hot and will remain ON until the heating surface area has cooled sufficiently.

 

Note: If no element size is choosen when the Triple element is turned ON, the control will default to the inner coil only. See page 11, Fig. 1 for recommended surface cooking settings.

Manual background Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.

Manual background Do not place aluminum foil or plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the surface elements.

13

ENGLISH

Page 12 Page 14
Image 13
Page 12 Page 14
Contents p/n 316417277 ENGLISH ESPAÑOLElectric Range Estufa eléctricaOne Year Limited Warranty Kenmore Elite Appliance WarrantyFIVE-YEAR LIMITED WARRANTY Disclaimer of implied warranties limitation of remediesENGLISH Important Safety InstructionsDo not use the oven or warmer drawer if equipped for storage Never Use Your Appliance for Warming or Heating the RoomIMPORTANT INSTRUCTIONS FOR USING YOUR OVEN IMPORTANT INSTRUCTIONS FOR USING YOUR COOKTOPSELF CLEANING OVENS IMPORTANT INSTRUCTIONS FOR CLEANING YOUR RANGEAcuerdos de protección Master Protection AgreementsSears Installation Service Master Protection AgreementsYour Electric Range Features Include Range FeaturesYour Electric Range Features Include cont’d Before Setting Oven ControlsOven Vent Location Removing & Replacing Oven RacksBaking Layer Cakes with 1 or 2 Oven Racks Types of Oven RacksAir Circulation in the Oven Flat Handle Oven RackTo Set the Cooktop Lockout Feature Before Setting Surface ControlsTo turn the Cooktop Lockout Feature ON To turn the Cooktop Lockout Feature OFFThe available ESEC Window Display Settings Setting Surface ControlsHot Surface Indicator Lights Cooktop Sabbath Day Feature and Sb MessageSetting Recommended Surface Cooking SettingsOperating Single Radiant Surface Elements To Operate the Single Radiant Surface ElementsTo Operate the Double Surface Elements Operating the Double Element some modelsDo not place aluminum foil or plastic items such as salt To Operate the Triple Surface Element Operating the Triple Element some modelsTo Operate the Bridge Surface Element Operating the Bridge Element some modelsOperating the Warmer Warm & Ready Zone Settings TableWarmer Zone Temperature Selection To Set the Warmer Zone ControlSensaCook some models Surface CookingCleaning section Using proper cookwareCookware Material Types Arranging Warmer Warm & Ready Drawer Rack PositionsWarmer Drawer Humidity Controller Feature Warmer Warm & Ready Drawer & Bread Proofing Indicator LightsNote The Warmer Drawer will not operate during the Self-Clean cycle Warmer Drawer Recommended Food Settings TableWarmer Drawer Food Temperature Settings Setting Warmer Drawer ControlsTo Set the Warmer Drawer & Bread Proofing Controls Preparing Bread Dough for the Warmer DrawerMinimum & Maximum Control Pad Settings Electronic Oven Control Pad FeaturesFEATURE MIN. TEMP. /TIMESetting the Clock Setting Oven ControlsSetting Silent Control Operation INSTRUCTIONS To set the clock example below forSetting Timer Setting Continuous Bake or 12 Hour Energy SavingTo set the Timer example for 5 minutes To cancel the Timer before the set time has run outINSTRUCTIONS To activate the Oven Lockout feature Setting Oven Lockout FeatureSetting Temperature Display - Fahrenheit or Celsius To reactivate normal oven operationWhen the Cook Time finishes To Set the Recipe Recall FeatureTo store a typical cookie recipe example for baking at 375F for 9 minutes and to shut-off automatically INSTRUCTIONSTo set the Preheat temperature for 350F Setting PreheatTHE OVEN Setting Bake Using the Air Guard feature some modelsTo set the Bake Temperature to 350F To change the Bake Temperature example changing from 350 to 425FCook Time feature When the Cook Time finishes Setting Cook TimeTo program the oven to begin baking immediately and to shut off automatically example below toDelay Start feature When the set bake time runs out Setting Delay StartRecommended Broiling Times and Searing Grill To set the oven to broil at the default setting 550FRoasting Rack Instructions Setting the Food Categories FeaturesBenefits of Convection Roast RecommendedProper Meat Probe placement Using and Setting Meat ProbeImportant things to consider To use the Meat Probe Using and Setting the Meat Probe cont’dto stop Convection Bake or cancel Convection Bake Setting Convection BakeTips for Convection Bake To set the oven for Convection Bake and temperature to 350FTo Set Add 1 Minute Feature To set the Convection Convert featureINSTRUCTIONSPRESSDISPLAY optional Setting the Slow Cook FeatureTo Set the Sabbath Feature for use on the Jewish Sabbath & Holidays To set Warm & Hold Setting the Warm & Hold FeatureTo set Warm & Hold to turn ON automatically To Remove and Replace Warmer Warm Ready Drawer Warmer Drawer RemovalTo Remove Warmer Drawer To Replace Warmer DrawerSelf-Cleaning Oven Self-CleaningAdhere to the following cleaning precautions 200 thru 400 usingFig. 1 number pads Self- CleaningINSTRUCTIONS PRESSStopping or Interrupting a Self-Cleaning cycle When the Self-Clean cycle is doneTo adjust the oven temperature lower To adjust the oven temperature higherAdjusting Oven Temperature How to Clean General Care & CleaningSurfaces Glass control panelCleaning Recommendations for the Ceramic Glass Cooktop Cooktop Cleaning & MaintenancePlastic or foods with a high sugar content For light to moderate soilDo not use the following on the ceramic glass cooktop Removing & Replacing the Lift-Off Oven DoorSpecial Caution for Aluminum Use on the Ceramic Cooktop To Remove Oven DoorChanging Oven Lights Care & Cleaning of Stainless Steel some modelsReplacing the upper oven interior light bulbs Before You Call POSSIBLE CAUSE/SOLUTIONOCCURRENCE Meat too close to the element. Reposition the rack to provide proper clearance between Slow Cook Turkey Breast Recipes for Slow CookParmesan Green Beans and Potatoes Orange Surprise Cake
Top Page Image Contents