Kenmore 790.4659 Adjusting the Oven Temperature, Setting Oven Controls cont’d, To set Warm & Hold

Page 18
Setting the Warm & Hold™ Feature

Setting Oven Controls (cont’d)

Setting the Warm & Hold™ Feature

The WarmHold& pad turns ON the Serve Warm & Hold feature and will maintain an oven temperature of 170° F (77°C). The Warm & Hold feature will keep oven baked foods warm for serving up to 3 hours after cooking has finished. After 3 hours the Warm & Hold feature will shut the oven OFF automatically. The Warm & Hold feature may be used without any other cooking operations or can be used after cooking has finished using TIMED BAKE or DELAY START BAKE.

To set Warm & Hold:

1.Arrange interior oven racks and place baked food in oven. If the food is already in the oven go to step 2.

2.Press WarmHold& . " — —" will appear in the display and the Warm & Hold indicator light above the pad will turn ON. Note: If no further pads are touched within 6 seconds the request to turn ON Warm & Hold will be cleared.

3.Press To set Warm & Hold: or To set Warm & Hold to turn ON automatically: to start.

4.To turn Warm & Hold OFF at any time press STOPClear . The Warm & Hold indicator light above the pad will turn OFF.

To set Warm & Hold to turn ON automatically:

1.Arrange interior oven racks and place food in oven. Set the oven properly for Timed Bake or Delay Start Bake.

2.Press WarmHold& . " — —" will appear in the display and the Warm & Hold indicator light above the pad will turn ON.

3.To turn Warm & Hold OFF at any time press STOPClear . The Warm & Hold indicator light above the pad will turn OFF.

Adjusting the Oven Temperature

Your oven control has been precisely set at the factory. This setting may differ from your previous oven however, so your recipe times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe times, you can adjust the control so that the oven cooks hotter or cooler than the temperature displayed.

To Adjust Oven Temperature:

1.Press Bake.

2.Set the temperature to 550°F (287°C) by pressing and holding the Adjusting the Oven Temperature.

3.Within 2 seconds, press and hold Bake until the 2 digit display appears. Release Bake. The display now indicates the

amount of degrees offset between the original factory temperature setting and the current temperature setting. If the oven control has the original factory calibration, the display will read "0."

4.The temperature can now be adjusted up or down 35°F or 19°C, in 5°F or 1°C steps by pressing and holding the To Adjust Oven Temperature:

or Manual background. Adjust until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign (-) will appear before the number to indicate that the oven will be cooler by the displayed amount of degrees.

5.When you have made the desired adjustment, press STOPClear to go back to the time of day display.

Note: Oven temperature adjustments made will not change the Self-Cleaning feature temperature.

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents 790.46585 Electric RangeEstufa eléctrica Slide-in modelsSerial Plate Location Table of ContentsProduct Record Kenmore WarrantyRead all instructions before using this appliance Important Safety InstructionsENGLISH Install anti-tip device packed with rangeFOR COOKTOPSWITH COIL ELEMENTS ONLY IMPORTANT INSTRUCTIONS FOR USING YOUR COOKTOPIMPORTANT INSTRUCTIONS FOR USING YOUR OVEN FOR GLASS COOKTOPS ONLYIMPORTANT INSTRUCTIONS FOR CLEAN- ING YOUR RANGE SAVE THESE SAFETY INSTRUCTIONSSELF-CLEANING OVENS IMPORTANT SAFETY NOTICEPROTECTION AGREEMENTS Your Electric Range featuresFeatures RangeModels with Ceramic Glass Cooktop Setting Surface ControlsModels with Coil Surface Elements Setting Surface ControlsSurface Cooking Settings Setting Surface Controls cont’dModels with Ceramic Glass Cooktop cont’d Recommended Settings for Single andOperating the Dual Surface Radiant Element Selecting Surface Cooking CookwareCookware Material types To Operate the Dual Surface ElementAir Circulation in the Oven Before Setting Oven ControlsArranging Oven Racks Oven Vent Location -Models with Coil ElementsTemperature conversion Control Pad FunctionsFor a silent control panel BakeTo Change the Minute Timer while it is in use Setting Oven ControlsTo Set the Minute Timer To Set the ClockTo Set or Change the Temperature for Baking Setting Oven Controls cont’dTo set Control for Oven Lockout feature To Set Control for Continuous Bake or 12 Hour Energy SavingTo Set the Timed Bake and Delay Start Features When the Set Bake Time Runs OutTo Change the Oven Temperature or Bake Time after Baking has Started when cooking time Baking problems and solutionsBaking Problems Oven Baking InformationBroil Rack Position Table Refer to Figure To Set for BroilingTo Operate the Oven Light Rack PositionTo Adjust Oven Temperature Adjusting the Oven TemperatureSetting the Warm & Hold Feature To set Warm & HoldWhat to Expect during Cleaning Self-CleaningSelf-Cleaning Oven Adhere to the following cleaning precautionsStopping or Interrupting a Self-Cleaning Cycle Self-Cleaning cont’dSelf-Clean Time Length When the Self-Clean Cycle is CompletedHow to Clean General Care & CleaningCleaning Various Parts of Your Range SurfacesDaily Cleaning For normal soil General Care & Cleaning cont’dPorcelain Enamel Cooktop Cleaning Instructions CLEANING AGENTSCleaning Recommendations for the Ceramic Glass Cooktop To Raise the Top for CleaningCeramic Glass Cooktop Cleaning & Maintenance Plastic or foods with a high sugar contentSpecial Door Care Instructions - Most oven doors contain glass Care and Cleaning of Stainless Steel Stainless Steel models onlyRemoving and Replacing the Oven Door Do not use the following on the ceramic glass cooktopBE IN PLACE WHEN THE OVEN IS IN USE To Replace the Light Bulb Storage DrawerChanging Oven Light Removing and Replacing Storage DrawerSolutions to Common Problems Before you callPOSSIBLE CAUSE/SOLUTION accessible for serviceScratches or abrasions on Self-cleaning cycle doescleaning cycle cooktop surfaceYour Home Sears Parts & Repair Service CenterGet it fixed, at your home or ours Our Home
Top Page Image Contents