REPLACING BATTERY
termi-
_sWARNING: Do not short battery
by allowing a wrench or any other object to contact both terminals at the same time.
Before connecting battery, remove metal
bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to
prevent sparking from accidental grounding.
1.Lift seat pan to raised position and open battery box door.
2.Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.
3.Install new battery with terminals in same position as old battery.
4.First connect RED battery cable to posi- tive (+) terminal with hex bolt and keps nut as shown. Tighten securely.
5.Connect BLACK grounding cable to negative
6.Close battery box door.
Seat |
|
Battery |
|
Box Door |
|
| Keps |
| /Nut |
| Hex |
| Bolt |
Positive |
|
(Red) |
|
Cable | Negative (Black) |
| Cable |
TO REPLACE HEADLIGHT BULB
1.Raise hood.
2.Remove bulb holder from the hole in the backside of the grill.
3.Replace bulb in holder and install bulb holder securely back into the hole in the backside of the grill.
4.Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring dia- gram in the Repair Parts manual.
TO REPLACE FUSE
Replace with 30 amp
TO REMOVE HOOD & GRILL ASSEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood at sides, tilt toward engine and tift off of tractor.
4.When replacing hood, be sure to recon- nect the headlight wire connector.
Headlight
Wire
Connector
ENGINE
TOADJUSTTHROTTLE CONTROLCABLE
The throttle control has been preset at the factory and adjustment should not be
necessary Check adjustment as described below before loosening cable. If adjustment is necessary, see engine manual.
TO ADJUST CHOKE CONTROL
The choke control has been preset at the fac- tory and adjustment should not be necessary. Ifadjustment is necessary, see engine manual.
TO ADJUST CARBURETOR
Your carburetor has been preset atth e factory and adjustment should not be necessary. However, minor adjustment may be required to compensate for differences in fuel, tem- perature, altitude or load. If the engine does need adjustment, see engine manual.
25