Keys
Slope Sheet
For Future Use | I |
(2) Keys
Your new tractor has been assembled at the factory with the exception of those parts left unassembted for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard wrench sizes are listed.
(1)5/16" wrench Utility knife
(2)7/16" wrenches Tire pressure gauge
(2)1/2" wrenches Pliers
(1) 9/16" wrench | (1) 3/4" wrench |
(1) 3/4" socket with drive ratchet
When right or left hand is mentioned in this manual, it means when you are inthe operating position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
1.Cut along dashed lines on all four pan- els of carton. Remove end panels and lay side panels flat.
2.Remove protective materials from trac- tor hood and grille.
IMPORTANT: Check for and remove any staples in skid that may puncture tires where tractor is to roll off skid.
CHECK BATTERY
1. Lift seat pan to raised position and open battery box door.
NOTE: If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at
SeN
Label
Bakery box
ADJUST SEAT
1.Sit in seat.
2.Lift up adjustment lever (A) and slide seat until a comfortable position is reached which allows you to press
clutch/brake pedal all the way down.
3. Release lever to lock seat in position.