Craftsman 917.289360, YT 4000 Engine OIL Filter, AIR Filter, Engine Cooling System, Muffler

Page 19

5.Re-attach oil drain extension to engine blower housing.

6.Refill enginewith oilthrough oilfill dipstick tube. Pour slowly. Do not overfill. For ap-

proximate capacity see "PRODUCT SP- ECIFICATIONS" section of this manual.

7.Use gauge on oil fill cap/dipstick for checking level. For accurate reading, tighten dipstick cap securely onto the tube before removing dipstick. Keep oil at "FULL' line on dipstick. Tighten cap onto the tube securely when finished.

ENGINE OIL FILTER

Replace the engine oil filter every season or every other oil change if the tractor is used more than 100 hours in one year.

AIR FILTER

Your engine will not run properly using a dirty air filter. Service air cleaner more often under

dusty conditions. See Engine Manual.

CLEAN AiR SCREEN

Air screen must be kept free of dirt and chaff to prevent engine damage from overheating. Clean with a wire brush or compressed airto remove dirt and stubborn dried gum fibers.

ENGINE COOLING SYSTEM

To ensure proper cooling, make sure the grass screen, cooling fins, and other exter- nal surfaces of the engine are kept clean at all times.

Every 100 hours of operation (more often

under extremely dusty, dirty conditions), remove the blower housing and other cooling

shrouds. Clean the cooling fins and external surfaces as necessary. Ensure the cooling shrouds are reinstalled.

NOTE: Operating the engine with a blocked grass screen, dirty or plugged cooling fins, and/or cooling shrouds removed wilt cause engine damage due to overheating.

MUFFLER

inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fire hazard and/or damage.

SPARK PLUG(S)

Replace spark plug(s) atthe beginning of each mowing season or after every 100 hours of operation, whichever occurs first. Spark plug type and gap setting are shown in"PRODUCT SPECIFICATIONS" section of this manual.

IN=LINE FUEL FILTER

The fuel filter should be replaced once each season. If fuel filter becomes clogged, ob- structing fuel flow to carburetor, replacement is required.

1.With engine coot, remove filter and plug fuel line sections.

amp

2.Place newfuetfilter in position in fuel line with arrow pointing towards carburetor.

3.Be sure there are no fuel line leaks and clamps are properly positioned.

4.Immediately wipe up any spilled gasoline.

CLEANING

Clean engine, battery, seat, finish, etc. of all foreign matter.

Clean debris from steering plate. Debris can restrict clutch/brake pedal shaft movement, causing belt slip and loss of drive.

_, CAUTION: Avoid all pinch points and movable parts

Clutch/brake pedal

Clean

'top

Steering

 

 

 

CAUTION:

Steering System,

Dash,

_

Pinch

Fender and Mower

bigotShown

 

Points

Keep finished surfaces and wheels free of all gasoline, oil, etc.

Protect painted surfaces with automo- tive type wax.

We do not recommend using a garden hose or pressure washer to clean your tractor unless the engine and transmission are

covered to keep water out. Water in engine or transmission will shorten the useful life of

your tractor. Use compressed air or a leaf

blower to remove grass, leaves and trash from tractor and mower.

19

Image 19
Contents Craftsman TWO Years on Riding Equipment Craftsman Full WarrantyGeneral Operation IV. Towing Service Safe Handling of GasomneGeneralservice Customer Responsibilities Sears Installation ServiceAPI-SG-SL U1RTo Remove Tractor from Carton Unpack Carton Tools Required for AssemblyAdjust Seat To Check BatteryCheck for Proper Position of ALL Belts JchecklistCheck Tire Pressure Check Deck Levelness@@@@ Tractor Know Your TractorReverse Operation System Stopping To SET Parking BrakeTo Operate Mower To Adjust Mower Cutting HeightTo Adjust Gauge Wheels To Move Forward BackwardMents Automatic Transmission Warm UP Before Starting the Engine Check Engine OIL LevelADD Gasoline To Start EngineMowing Tips Purge TRANSMiSSiONBefore Each USE MaintenanceSchedule General RecommendationsOperator Presence System TiresBelts BatteryTransaxle Cooling Transaxle Pump FluidMuffler Engine OIL FilterAIR Filter Engine Cooling SystemDeck Washout Port To Remove Mower To iNSTALL Mower03042rex To Level Mower Visual SIDE=TO-SIDE AdjustmentFRONT-TO-BACK Adjustment Precision SIDE=TO=SIDE AdjustmentFront Wheel TOE=IN/CAMBER To Replace Mower Blade Drive BeltTo Replace Motion Drive Belt To Check BrakeTo Attach Jumper Cables Transaxle Motion Control Lever Neutral AdjustmentReplacing Battery To Remove Wheel for RepairsTransmission REMOVAL/REPLACE= Ment Cylinders BatteryFuel System Engine OILCause ProblemCorrection PSI Cause CorrectionOFF Problem Correction= o DOS Aios Para EL Equipo Tractor Funcionamiento General AdvertenciaAdvertenoia DvertenciaMANIPULACI6N Segura DE LA Gasolina IV, RemolqueOperaciones DE Servicio Generales Edentemente LA Reparacion Responsabilidades DEL CmenteAntes DE Remover EL Tractor DE LA Corredera HerramientasNecesarias Para EL MontajeRevision DEL Sistema DE Frenos Revision DE LA Preskn DE LAS LlantasRevision DE LA Nivelacion DEL REVISI6N DE LA Posicion AdecuadaFuncionamiento Atras ROS Estra .NGU- R,PIDO LentoLacion Motor MotorSU Tractor Familiaricese CON SU TractorIMPULSI6N DE Recorrido Como Usar SU TractorPara Ajustar EL Freno DE Estaciona Miento Parada Cuchillas DE LA SegadoraPara Operar LA Segadora Para Moverse Haciaadelante Y Hacia AtrasPara Ajustar LA Altura DE Corte DE LA Segadora Para Ajustar LAS Ruedas CALIBRA- DorasCronometro MecanjsmoArranque CON Tiempo Templado Consejos Para Segar Purgar LA TransmisionRecomendaciones Generales Programa DE MantenimentoAntes DE Cada USO Funoionamiento ATR.&S ROS TractorOperaoion DEL Freno LlantasMotor Limpieza Puerto DE Lavado DE LA Cubierta Instale LA Segadora Para Desmontar LA CortadoraFije LOS Brazos DE Suspension 03042tex Ajuste DE Delante a ATR,S Para Njvelar LA SegadoraRegulacion Visual DE Lado a Lado Regulacion DE LA Precision DE LadoPara Reem Plazar LA Correa DE Trans Para Cambiar LA Correa DE Impulsion DE LA Cuchilla SegadoraREMOCI6N DE LA Correa Instalacion DE LA CorreaParaadj Untar LOS CAB LES DE EM Palm E IMPRESI6N / Inclinacion DE LAS Ruedas DelanterasRegulacion DE LA Palanca DE Control Para Remover LAS Ruedas Para Hacer ReparacionesMotor Aoeite DEL Motor Motor Sistema DE CombustibleOtros IDENTIFICACI6N DE Problemas Correccion Yea JaseccJ6n apropJada en eJ manual a menos queApaga Identificacion DE ProblemasPage Page Gao MaHage home