Craftsman 917.289360, YT 4000 To Replace Mower Blade Drive Belt, To Replace Motion Drive Belt

Page 24

TO REPLACE MOWER BLADE DRIVE BELT

The mower blade drive belt may be replaced without tools. Park the tractor on level sur-

face. Engage parking brake.

BELT REMOVAL -

1.Removemowerfromtractor (See"TO RE- MOVE MOWER"inthissectionofmanual).

2.Work belt off both mandrel pulleys and idler pulleys.

3.Putt belt away from mower.

BELT INSTALLATION -

1.Work belt around both mandrel pulleys and idler pulleys

2.Make sure belt is in all pulley grooves and inside all belt guides.

3.Install mower (See "To Install Mower" in this section of this manual).

MandrelIdler

Pulle_Pulle,

Mandrel

2.Pull belt toward front of tractor and roll belt onto engine pulley (E).

3.Putt belt toward rear of tractor. Carefully work belt down around transmission

cooling fan and onto the input pulley (D). Be sure belt is inside the belt keeper.

4.Install belt on centerspan idler (C).

5.Install belt through stationary idler (A) and clutching idler (B).

6.Make sure belt is in all pulley grooves and inside all belt guides and keepers.

7.Install mower (See "TO INSTALL MOW- ER" in this section of manual).

TO REPLACE MOTION DRIVE BELT

Park the tractor on level surface. Engage parking brake. For assistance, there is a

belt installation guide decal on bottom side of left footrest.

BELT REMOVAL -

1. Remove mower (See "TO REMOVE

MOWER" in this section of manual). NOTE: Observe entire motion drive belt and

position of all belt guides and keepers.

2.Remove beltfrom stationary idler (A) and clutching idler (B).

3.Remove belt from centerspan idler (C).

6.Pull belt slack toward rear of tractor.

Carefully remove belt upwards from transmission input pulley and over cool- ing fan blades (D).

4.Remove belt downward from engine

TO CHECK BRAKE

If tractor requires more than five (5) feet to

stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

1.Park tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake.

2.Disengage transmission by placing freewheel control in "transmission dis-

engaged" position. Pull freewheel control out and into the slot and release so it is

held in the disengaged position.

The rear wheels must lock and skid when

you try to manually push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a Sears or

other qualified service center.

pulley (E).

5.Slide belt toward rear of tractor, off the steering plate (F) and remove from tractor.

BELT INSTALLATION -

1. Install new belt from tractor rear to front,

over the steering plate

(F) and above

 

clutch brake pedal shaft

(G).

24

 

 

FRONT WHEEL TOE=IN/CAMBER

Your new tractor front wheel toe-in and cam- ber is set at the factory and is normal. The

front wheeltoe-in and camber are not adjust- able. If damage has occurred to affect the factory set front wheel toe-in or camber, con- tact a Sears or other qualified service center.

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Craftsman Craftsman Full Warranty TWO Years on Riding EquipmentGeneral Operation Service Safe Handling of Gasomne IV. TowingGeneralservice Sears Installation Service API-SG-SLU1R Customer ResponsibilitiesTools Required for Assembly Adjust SeatTo Check Battery To Remove Tractor from Carton Unpack CartonJchecklist Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL Belts@@@@ Know Your Tractor TractorReverse Operation System To SET Parking Brake StoppingTo Adjust Mower Cutting Height To Adjust Gauge WheelsTo Move Forward Backward To Operate MowerMents Before Starting the Engine Check Engine OIL Level ADD GasolineTo Start Engine Automatic Transmission Warm UPPurge TRANSMiSSiON Mowing TipsMaintenance ScheduleGeneral Recommendations Before Each USETires Operator Presence SystemBattery Transaxle CoolingTransaxle Pump Fluid BeltsEngine OIL Filter AIR FilterEngine Cooling System MufflerDeck Washout Port To iNSTALL Mower To Remove Mower03042rex Visual SIDE=TO-SIDE Adjustment FRONT-TO-BACK AdjustmentPrecision SIDE=TO=SIDE Adjustment To Level MowerTo Replace Mower Blade Drive Belt To Replace Motion Drive BeltTo Check Brake Front Wheel TOE=IN/CAMBERTransaxle Motion Control Lever Neutral Adjustment Replacing BatteryTo Remove Wheel for Repairs To Attach Jumper CablesTransmission REMOVAL/REPLACE= Ment Battery Fuel SystemEngine OIL CylindersProblem CauseCorrection Cause Correction PSIProblem Correction OFF= o DOS Aios Para EL Equipo Tractor Advertencia AdvertenoiaDvertencia Funcionamiento GeneralIV, Remolque MANIPULACI6N Segura DE LA GasolinaOperaciones DE Servicio Generales Edentemente Responsabilidades DEL Cmente LA ReparacionHerramientas NecesariasPara EL Montaje Antes DE Remover EL Tractor DE LA CorrederaRevision DE LA Preskn DE LAS Llantas Revision DE LA Nivelacion DELREVISI6N DE LA Posicion Adecuada Revision DEL Sistema DE FrenosEstra .NGU- R,PIDO Lento LacionMotor Motor Funcionamiento Atras ROSFamiliaricese CON SU Tractor SU TractorComo Usar SU Tractor Para Ajustar EL Freno DE Estaciona MientoParada Cuchillas DE LA Segadora IMPULSI6N DE RecorridoPara Moverse Haciaadelante Y Hacia Atras Para Ajustar LA Altura DE Corte DE LA SegadoraPara Ajustar LAS Ruedas CALIBRA- Doras Para Operar LA SegadoraMecanjsmo CronometroArranque CON Tiempo Templado Purgar LA Transmision Consejos Para SegarPrograma DE Mantenimento Recomendaciones GeneralesAntes DE Cada USO Tractor Operaoion DEL FrenoLlantas Funoionamiento ATR.&S ROSMotor Limpieza Puerto DE Lavado DE LA Cubierta Para Desmontar LA Cortadora Instale LA SegadoraFije LOS Brazos DE Suspension 03042tex Para Njvelar LA Segadora Regulacion Visual DE Lado a LadoRegulacion DE LA Precision DE Lado Ajuste DE Delante a ATR,SPara Cambiar LA Correa DE Impulsion DE LA Cuchilla Segadora REMOCI6N DE LA CorreaInstalacion DE LA Correa Para Reem Plazar LA Correa DE TransIMPRESI6N / Inclinacion DE LAS Ruedas Delanteras Regulacion DE LA Palanca DE ControlPara Remover LAS Ruedas Para Hacer Reparaciones Paraadj Untar LOS CAB LES DE EM Palm EMotor Motor Sistema DE Combustible Aoeite DEL MotorOtros IDENTIFICACI6N DE Problemas Yea JaseccJ6n apropJada en eJ manual a menos que CorreccionIdentificacion DE Problemas ApagaPage Page Gao MaHage home
Top Page Image Contents