Craftsman 917.289360, YT 4000 owner manual Battery, Fuel System, Engine OIL, Cylinders, Other

Page 27

Immediately prepare your tractor for storage at the end of the season or if the tractor will

not be used for 30 days or more.

_WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

When tractor is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire tractor (See "CLEANING" in the Maintenance section of this manual).

2.Inspectand reptace belts, ifnecessary (See bett replacementinstructionsinthe Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

*Fully charge the battery for storage.

*After a period of time in storage, battery may require recharging.

*To help prevent corrosion and power leak- age during long periods of storage, battery cables should be disconnected and bat-

tery cleaned thoroughly (see "TO CLEAN BATTERY AND TERMINALS" in the

Maintenance section of this manual).

*After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

*If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, ortank during storage. Also, alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during

storage. Acidic gas can damage the fuel system of an engine while in storage.

Empty the fuel tank by starting the engine and letting it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent

damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least

10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not

empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual).

CYLINDER(S)

1.Remove spark plug(s).

2.Pour one ounce of oil through spark plug hole(s) into cylinder(s).

3.Turn ignition key to start position for a few seconds to distribute oil.

4.Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can ifyour can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable protec- tive cover that does not retain moisture.

Do not use plastic. Plastic cannot breathe which allows condensation to form and will

cause your tractor to rust.

IMPORTANT: Never cover tractor while engine and exhaust areas are still warm.

27

Image 27
Contents Craftsman TWO Years on Riding Equipment Craftsman Full WarrantyGeneral Operation IV. Towing Service Safe Handling of GasomneGeneralservice Customer Responsibilities Sears Installation ServiceAPI-SG-SL U1RTo Remove Tractor from Carton Unpack Carton Tools Required for AssemblyAdjust Seat To Check BatteryCheck for Proper Position of ALL Belts JchecklistCheck Tire Pressure Check Deck Levelness@@@@ Know Your Tractor TractorReverse Operation System Stopping To SET Parking BrakeTo Operate Mower To Adjust Mower Cutting HeightTo Adjust Gauge Wheels To Move Forward BackwardMents Automatic Transmission Warm UP Before Starting the Engine Check Engine OIL LevelADD Gasoline To Start EngineMowing Tips Purge TRANSMiSSiONBefore Each USE MaintenanceSchedule General RecommendationsOperator Presence System TiresBelts BatteryTransaxle Cooling Transaxle Pump FluidMuffler Engine OIL FilterAIR Filter Engine Cooling SystemDeck Washout Port To Remove Mower To iNSTALL Mower03042rex To Level Mower Visual SIDE=TO-SIDE AdjustmentFRONT-TO-BACK Adjustment Precision SIDE=TO=SIDE AdjustmentFront Wheel TOE=IN/CAMBER To Replace Mower Blade Drive BeltTo Replace Motion Drive Belt To Check BrakeTo Attach Jumper Cables Transaxle Motion Control Lever Neutral AdjustmentReplacing Battery To Remove Wheel for RepairsTransmission REMOVAL/REPLACE= Ment Cylinders BatteryFuel System Engine OILProblem CauseCorrection PSI Cause CorrectionOFF Problem Correction= o DOS Aios Para EL Equipo Tractor Funcionamiento General AdvertenciaAdvertenoia DvertenciaIV, Remolque MANIPULACI6N Segura DE LA GasolinaOperaciones DE Servicio Generales Edentemente LA Reparacion Responsabilidades DEL CmenteAntes DE Remover EL Tractor DE LA Corredera HerramientasNecesarias Para EL MontajeRevision DEL Sistema DE Frenos Revision DE LA Preskn DE LAS LlantasRevision DE LA Nivelacion DEL REVISI6N DE LA Posicion AdecuadaFuncionamiento Atras ROS Estra .NGU- R,PIDO LentoLacion Motor MotorSU Tractor Familiaricese CON SU TractorIMPULSI6N DE Recorrido Como Usar SU TractorPara Ajustar EL Freno DE Estaciona Miento Parada Cuchillas DE LA SegadoraPara Operar LA Segadora Para Moverse Haciaadelante Y Hacia AtrasPara Ajustar LA Altura DE Corte DE LA Segadora Para Ajustar LAS Ruedas CALIBRA- DorasCronometro MecanjsmoArranque CON Tiempo Templado Consejos Para Segar Purgar LA TransmisionPrograma DE Mantenimento Recomendaciones GeneralesAntes DE Cada USO Funoionamiento ATR.&S ROS TractorOperaoion DEL Freno LlantasMotor Limpieza Puerto DE Lavado DE LA Cubierta Para Desmontar LA Cortadora Instale LA SegadoraFije LOS Brazos DE Suspension 03042tex Ajuste DE Delante a ATR,S Para Njvelar LA SegadoraRegulacion Visual DE Lado a Lado Regulacion DE LA Precision DE LadoPara Reem Plazar LA Correa DE Trans Para Cambiar LA Correa DE Impulsion DE LA Cuchilla SegadoraREMOCI6N DE LA Correa Instalacion DE LA CorreaParaadj Untar LOS CAB LES DE EM Palm E IMPRESI6N / Inclinacion DE LAS Ruedas DelanterasRegulacion DE LA Palanca DE Control Para Remover LAS Ruedas Para Hacer ReparacionesMotor Motor Sistema DE Combustible Aoeite DEL MotorOtros IDENTIFICACI6N DE Problemas Correccion Yea JaseccJ6n apropJada en eJ manual a menos queApaga Identificacion DE ProblemasPage Page Gao MaHage home