TO REMOVE WHEEL FOR REPAIRS
1.Block up axle securely.
2.Remove axle cover, retaining ring and washers to allow wheel removal (rear wheels have a square key - Do not lose).
3.Repair tire and reassemble.
NOTE: On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.
4.Replace washers and snap retaining ring securely in axle groove.
5.Replace axle cover.
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, purchase and usetire sealant from Sears. Tire sealant also prevents tire dry rot and corrosion.
Washers
Retaining
Rin(
Axle
Cover
Square
Key _
(Rear
TRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT
The motion control lever has been preset atthe factory; adjustment should not be necessary.
1.Loosen adjustment bolt in front of the right rear wheel, and lightly tighten.
2.Start engine and move motion control lever until tractor does not move forward
or backward.
3.Hold motion control lever in that position and turn engine off.
4.While holding motion control lever in place, loosen the adjustment bolt.
5.Move motion control lever to the neutral (lock gate) position.
6.Tighten adjustment bolt securely.
Motion Control | Neutral |
Lever | Lock |
| Gate |
Y
Adjustment Bolt NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position.
After above adjustment is made, if the trac- tor still creeps forward or backward while motion control lever is in neutral position, follow these steps:
1.Loosen the adjustment bolt.
2.Movethe motion control lever 1/4 to 1/2 inch in the direction it is trying to creep.
3.Tighten adjustment bolt securely.
4.Start engine and test.
5.If tractor still creeps, repeat above steps until satisfied.
TO START ENGINE WITH WEAK BATTERY
,_WARNING:
ate explosive gases. Keep sparks, flame and smoking materials away from batteries.
Always wear eye protection when around batteries.
If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the
MAINTENANCE section of this manual).
If "jumper cables" are used for emergency starting, follow this procedure:
IMPORTANT: Your tractor is equipped with a 12 volt system. The other vehicle must also be a 12 volt system. Do not use your tractor battery to start other vehicles.
TO ATTACH JUMPER CABLES -
1.Connect one endofthe RED cable to the
POSITIVE (+) terminal of each battery(A-
B), taking care not to short against tractor chassis.
2.Connect one end of the BLACK cable
to the NEGATIVE
Weak or | Fully |
Dead | Charged |
Battery | Battery |
3.Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER-
1.BLACK cable first from chassis and then from the fully charged battery.
2.RED cable last from both batteries.
REPLACING BATTERY
n_asWARNING: Do not short battery termi- by allowing a wrench or any other object
to contact both terminals at the same time.
Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from accidental grounding.
1.Lift seat pan to raised position.
25