Craftsman 917.273642 manual Automatic Transmission Warm UP, Purge Transmission

Page 16

WARM WEATHER STARTING (50 ° F and above)

7.When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and

allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50 ° F and below)

7.When engine starts, allow engine

to run with the throttle control in the

choke position until the engine runs roughly, then move throttle control to fast position. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

Before driving the unit in cold weather,

the transmission should be warmed up as follows:

1.Be sure the tractor is on level ground.

2.Place the motion control lever in neutral. Release the parking brake and let the clutch/brake slowly return to operating position.

3.Allow one minute for transmission to warm up. This can be done during

the engine warm up period.

• The attachments can also be used dur- ing the engine warm-up period after the transmission has been warmed up.

NOTE: If at a high altitude (above 3000

feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance.

(See "TO ADJUST CARBURETOR" in the Service and Adjustments section of this manual.)

PURGE TRANSMISSION

_iCAUTION: Never engage or disengage freewheel lever while the engine is run- ning.

To ensure proper operation and per-

formance, it is recommended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the trans- mission which may have developed during shipping of your tractor.

IMPORTANT: Should your transmission require removal for service or replace- ment, it should be purged after reinstall- ation before operating the tractor.

1.Place tractor safely on level surface with engine off and parking brake set.

2.Disengage transmission by placing

freewheel control in "transmission dis- engaged" position (See "TO TRANS- PORT" in this section of manual).

3.Sitting in the tractor seat, start engine. After the engine is running, move throttle control to slow position. With motion control lever in neutral (N) position, slowly disengage clutch/brake pedal.

4.Move motion control lever to full

forward position and hold for five (5) seconds. Move lever to full reverse

position and hold for five (5) seconds. Repeat this procedure three (3) times.

NOTE: During this step there will be no movement of drive wheels. The air is being removed from hydraulic drive system.

5.Move motion control lever to neutral

(N)position. Shutoff engine and set parking brake.

6.Engage transmission by placing freewheel control in "transmission

engaged" position (See "TO TRANS- PORT" in this section of manual).

7.Sitting in the tractor seat, start engine. After the engine is running, move throttle control to half (1/2) speed.

With motion control lever in neutral (N) position, slowly disengage clutch/brake pedal.

8.Slowly move motion control lever for- ward, after the tractor moves approxi- mately five (5) feet, slowly move motion control lever to reverse position. After the tractor moves approximately five

(5) feet return the motion control lever to the neutral (N) position. Repeat this procedure with the motion control lever three (3) times.

Your transmission is now purged and ready for normal operation.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Criiftsmhn Limitedwarrantyon Craftsmanridingequipment General Operation III. Children Service Safe Handling of GasolineII. Slope Operation General Service Customer Responsibilities Sears Installation ServiceRepair Protection Agreements For Future Use HOW to SET UP Your Tractor Check Battery Adjust SeatTo Drive Tractor OFF Skid Unpack CartonReposition Right Rear Gauge Wheel DischargingCheck for Proper Position ALL Belts Check Brake SystemChecklist @@@@ Tractor To Adjust Mower Cutting Height To SET Parking BrakeStopping To USE Throttle ControlTo Adjust Gauge Wheels To Operate MowerTo Operate on Hills To TransportBefore Starting the Engine Check Engine OIL Level Towing Carts and Other Attach MentsADD Gasoline Automatic Transmission Warm UP Purge TransmissionMulching Mowing Tips Mowing TipsMaintenance Schedule General RecommendationsBattery TractorOperator Presence System Blade CareTransaxle Pump Fluid Engine LubricationEngine OIL Filter AIR FilterEngine Cooling System MufflerDisengaged To Install MowerTo Remove Mower SIDE-TO-SIDE Adjustment with Bubble Level To Level Mower HousingFRONT-TO-BACK Adjustment Both Front Links Must be Equal Length To Check and Adjust BrakeTo Replace Mower Blade Drive Belt Lever Neutral Adjustment ReplacementTo Replace Motion Drive Belt Transaxle Motion ControlReplacing Battery To Adjust Steering Wheel AlignmentTo Remove Wheel for Repairs To Adjust Throttle Control Cable To Replace Headlight BulbInterlocks and Relays To Replace FuseTo Adjust Carburetor Preliminary SettingFinal Setting Acceleration TestEngine Fuel System Engine OILCylinders OtherCause Correction ProblemStart Loss of power CauseProblemcause CorrectionSchematic Tractor - Model NumberElectrical Electrical KEY Part DescriptionTractor - Model Number 917,273642 Chassis and Enclosures Part Description Tractor - Model Number Ground Drive Tractor -- Model Number Ground Drive KEY Part DescriptionTractor - Model Number 917.273642 Steering Assembly KEY Part Description Tractor - Model Number 917,273642 EngineTractor - Model Number Seat Assembly KEY PartDecals Wheels Tires KEYTractor - Model Number 917,273642 Lift Assembly 144 ,.....4s Tractor - Model Number 917,273642 Mower DeckTractor - Model Number Mower Deck STDPage Tractor - Model Number Hydro Geartransaxle -- Model Number 750x.625783J Tractor Model Number Briggs ENGINE-MODEL Number 31P777, Type Number 0348-E1105137 276 Dimensions Given in U.S. inches Page Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXYour Home

917.273642 specifications

The Craftsman 917.273642 is a riding lawn mower designed to combine efficiency, power, and user comfort for homeowners managing sizable lawn areas. This model stands out as an essential gardening tool, specifically engineered to make mowing tasks simpler and more enjoyable.

One of the main features of the Craftsman 917.273642 is its robust 19.5 HP Briggs & Stratton engine. This powerful engine ensures reliable starting and sufficient power to tackle tough grass and larger terrains. The mower also incorporates a smooth-running automatic transmission, allowing users to shift seamlessly between different speeds while maintaining control and stability.

Another key characteristic of this riding mower is its 42-inch cutting deck. This mid-sized deck provides an optimal balance between cutting efficiency and maneuverability, especially in tight spots or around obstacles. The deck is equipped with a six-position height adjustment system, enabling users to customize the cutting height according to the specific requirements of their lawn.

The Craftsman 917.273642 also features an innovative debris management system with side discharge capability, allowing clippings to be expelled directly to the side, providing a cleaner cut and reducing the need for bagging. For added convenience, the model is equipped with optional mulching capabilities, enabling users to finely chop grass clippings and return them to the lawn as natural fertilizer.

User comfort is paramount in the design of the Craftsman 917.273642. The mower incorporates a spacious and ergonomically designed seat, featuring a high back for enhanced support, ensuring users can operate the machine for extended periods without discomfort. The easy-to-reach controls are strategically located on the dashboard, allowing for a user-friendly experience.

In addition to its impressive features, the Craftsman 917.273642 comes with durability in mind. The heavy-duty steel frame and reinforced deck ensure that the mower can withstand the rigors of frequent use while providing a long life span.

Overall, the Craftsman 917.273642 is more than just a lawn mower. It represents a blend of modern technology, user-centric design, and the durability that the Craftsman brand is well known for, making it a valuable addition to any homeowner's gardening toolkit. Whether you have a small yard or a larger landscape, this riding mower is designed to meet your landscaping needs with precision and ease.
Top Page Image Contents