Craftsman 917.273648 manual To SET Parking Brake, Stopping, Engine, To Move Forward and Backward

The operation

of any

tractor

can

result in

foreign objects thrown

into

the

I

eyes,

which

can result

in severe

eye damage.

Always

wear

safety

glasses

I

or

eye

shields

while operating

your

tractor

or

performing

any

adjustments

I

or

repairs.

We

recommend

standard

safety

glasses or

a wide vision

safety I

mask

worn

over spectacles.

I

HOW TO USE YOUR TRACTOR

TO SET PARKING BRAKE

Your tractor is equipped with an operator presence sensing switch. When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine.

1.Depress clutch/brake pedal all the way down and hold.

2.Pull parking brake lever up and release pressure from clutch/brake pedal. Pedal should remain in brake position.

Make sure parking brake will hold trac-

tor secure.

Push in to Attachment Clutch

"Disengage" Switch Pull out to

Control

"Brake" Position

Key

Motion

Clutch/Brake "Disengaged" Control Lever

Pedal Position Parking Brake

"Engaged" Position

STOPPING

MOWER BLADES -

•To stop mower blades, push attachment clutch switch in to disengaged position.

GROUND DRIVE -

•To stop ground drive, depress clutch/ brake pedal all the way down.

•Move motion control lever to neutral (N)

position.

IMPORTANT: The motion control lever does not return to neutral (N) position when the clutch/brake pedal is depressed.

ENGINE -

•Move throttle control between half and

full speed (fast) position.

NOTE: Failure to move throttle control between half and full speed (fast) posi- tion, before stopping, may cause engine to "backfire".

•Turn ignition key to "STOP" position and remove key. Always remove key when

leaving tractor to prevent unauthorized

use.

•Never use choke to stop engine.

IMPORTANT: Leaving the ignition switch in any position other than "STOP" will

cause the battery to discharge and go dead.

NOTE: Under certain conditions when tractor is standing idle with the engine running, hot engine exhaust gases may cause "browning" of grass. To eliminate this possibility, always stop engine when

opping tractor on grass areas.

CAUTION: Always stop tractor com- pletely, as described above, before leaving the operator's position.

TO USE THROTTLE CONTROL Always operate engine at full throttle.

•Operating engine at less than full throttle reduces the battery charging rate.

•Full throttle offers the best bagging and mower performance.

TO MOVE FORWARD AND BACKWARD

The direction and speed of movement is controlled by the motion control lever.

1.Start tractor with motion control lever in neutral (N) position.

2.Release parking brake.

3.Slowly move motion control lever to desired position.

TO ADJUST MOWER CUTTING HEIGHT

The position of the attachment lift lever determines the cutting height.

•Grasp lift lever.

•Press plunger with thumb and move lever to desired position.

The cutting height range is approxi- mately 1-1/2 to 4". The heights are mea- sured from the ground to the blade tip with the engine not running. These heights

are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed.

•The average lawn should be cut to ap- proximately 2-1/2 inches during the cool season and to over 3 inches during hot months. For healthier and better look- ing lawns, mow often and after moder- ate growth.

•For best cutting performance, grass over 6 inches in height should be mowed twice. Make the first cut rela-

tively high; the second to desired height.

13