Craftsman 917.270961 manual Purge Transmission

Page 16

•Insert key into ignition and turn key clockwise to =START" position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute.

If the engine does not start after several attempts, push choke control

in, wait a few minutes and try again. If engine still does not start, pull the choke control out and retry.

WARM WEATHER STARTING (50 ° F and above)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50 ° F and below)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. Continue to push the choke control in small steps allowing the engine to accept small changes in speed and load, until the choke control is fully in. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Place the motion control lever in

neutral. Release the parking brake and let the clutch/brake

slowly return to operating position.

•Allow one minute for transmission to warm up. This can be done during the engine warm up period.

•The attachments can be used during the engine warm-up period after the

transmission has been warmed up and may require the choke control be pulled out slightly.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32

F)the carburetor fuel mixture may need to be adjusted for best engine perfor- mance. See "TO ADJUST CARBURE-

TOR" in the Service and Adjustments section of this manual.

PURGE TRANSMISSION

A CAUTION: Never engage or disen-

gage freewheel lever while the engine is running.

To ensure proper operation and perfor- mance, it is recommended that the

transmission be purged before operating

tractor for the first time. This procedure will remove any trapped air reside the

transmission which may have developed during shipping of your tractor. IMPORTANT: Should your transmission require removal for service or replace- ment, it should be purged after reinstalla- tion before operating the tractor.

•Place tractor safely on level surface with engine off and parking brake set.

•Disengage transmission by placing freewheel control in freewheeling position (See "TO TRANSPORT" in this section of manual).

•Sitting in the tractor seat, start engine. After the engine is running, move throttle control to slow position. With motion control lever in neutral (N) position, slowly disengage clutch/ brake pedal.

•Move motion control lever to full

forward position and hold for five (5) seconds. Move lever to full reverse

position and hold for five (5) seconds.

Repeat this procedure three (3) times.

NOTE: During this procedure there will be no movement of drive wheels. The air

is being removed from hydraulic ddve system.

•Move motion control lever to neutral

(N)position. Shut- off engine and set parking brake.

•Engage transmission by placing freewheel control in driving position (See "TO TRANSPORT" in this section of manual).

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents £RAFTZMANo Parts Ordering Back Cover General OperationService Slope OperationDo not ChildrenTIONI!! Become AWARE!!! Your Safety is Involved Machine. Tall grass can hide obsta- clesProduct Specifications Steering Wheel Before Removing Tractor From Skid Attach Steering WheelHOW to SET UP Your Tractor Check BatteryInstall Seat To Drive Tractor OFF SkidTo Convert to Bagging or Discharging Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsAll assembly instructions have been completed While Learning HOW to USE YoufH L Knowyourtractor HOW to USE Your Tractor To Adjust Gauge Wheels To Operate MowerTo Operate on Hills To TransportBefore Starting the Enigne Check Engine OIL Level To Start EngineADD Gasoline Purge Transmission Mowing Tips Mulching Mowing TipsLubrication Chart Maintenance ScheduleGeneral Recommendations Before Each USETires Operator Presence SystemTocleanbatteryandterminals Clean AIR ScreenClean AIR INTAKE/COOUNG Areas To Service PRE-CLEANERSpark Plugs IN-LINE Fuel FilterCleaning To Install MowerTo Level Mower Housing TractorSIDE-TO-SIDE Adjustment To Level Mower HousingFRONT-TO-BACK Adjustment Belt Installation To Adjust BrakeTo Replace Mower Blade Drive Belt Belt RemovalTo Adjust Steering Wheel Alignment Transaxle Motion Control Lever Neutral AdjustmentTransmission REMOVAL/REPLACE- Ment Front Wheel TOE-IN/CAMBERTo Start Engine with a Weak Battery Replacing BatteryTo Replace Headlight Bulb Interlocks and RelaysTo Remove Hood and Grill Assembly To Adjust CarburetorTo Adjust Throttle Control Cable To Adjust Choke ControlIdle Speed Lever =---,f \Idle Mixture Screw Engine Fuel System CylindersOther EngineoilTroubleshooting Chart ProblemCause CorrectionChart Cause ProblemCorrection Problemcause SlowSchematic Tractor -. Model NumberTractor - Model Number Electrical Tractor - Model Number Electrical KEYTractor - Model Number Chassis and Enclosures Tractor - Model Number 917.270961 Chassisand Enclosures IL=Y Part DesciiptionTractor - Model Number Ground Drive Tractor --MODEL Number Ground Drive KEY Part DescriptionTractor - Model Number 917.270961 Steering Assembly Tractor --MODEL Number Steering Assembly 12000029Tractor - Model Number EngineOptional Equipment Engine Part Description Tractor - Model Number Seat Assembly Part KEY Part Description DESCRIP/1ONTractor --MODEL Number DecalsWheels & Tires Part NO. noTractor - Model Number Liftassembly Tractor - Model Number Lift Assembly Mowerdeck Mower Deck Part NO. no Arm, Suspension, RearTractor - Model Number Hydro Gear Transaxle - Model Number Tractor - Model Number Hydro Gear Transaxle . Model Number KL=Y PAR Description61SA 392,32 Gasket SET KEY Part NO. no KEY Part Description263060 Page Page Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across HillPartsDirect sM

917.270961 specifications

The Craftsman 917.270961 is a remarkable lawn tractor designed for both efficiency and ease of use, making it an excellent choice for homeowners with medium to large yards. This powerful riding mower features a robust 19 horsepower Kohler engine, ensuring reliable performance and the capability to handle various terrains. With a 42-inch cutting deck, it provides a comfortable balance between maneuverability and cutting swath, making it suitable for a wide range of applications.

One of the standout features of the Craftsman 917.270961 is its automatic transmission. This technology allows for a smooth and seamless driving experience, enabling the operator to enjoy effortless control while mowing. With variable speed options, users can easily adjust the pace to suit their mowing style and the conditions of their yard, making it adaptable to various tasks.

The lawn tractor is equipped with a dual-blade system, ensuring a clean and even cut every time. This feature not only enhances the appearance of your lawn but also promotes healthy grass growth. Moreover, the deck is designed with an integrated washout port, facilitating easy cleaning after use and reducing the buildup of grass clippings.

Comfort is another priority in the design of the Craftsman 917.270961. The ergonomic seat is adjustable, allowing users of varying heights to find a comfortable position. The steering wheel is also designed for ease of handling, minimizing fatigue during longer mowing sessions.

For added convenience, this lawn tractor comes with an easy-to-read dashboard that displays essential information such as speed, fuel level, and engine temperature, keeping the user informed about the machine's performance at all times. Furthermore, the large-capacity fuel tank minimizes the need for frequent refueling, allowing for extended mowing sessions without interruptions.

Safety features are integrated throughout the Craftsman 917.270961, including an engine cutoff switch that activates when the operator leaves the seat. This ensures peace of mind while operating the mower, especially in landscapes with obstacles.

Overall, the Craftsman 917.270961 stands out as an efficient, comfortable, and versatile lawn tractor. With its solid engine performance, user-friendly design, and advanced mowing technologies, it is a reliable choice for homeowners aiming to maintain a pristine lawn with ease.
Top Page Image Contents