Craftsman 917.270961 To Level Mower Housing, SIDE-TO-SIDE Adjustment, FRONT-TO-BACK Adjustment

Page 23

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure

tires are propedy inflated (See =PROD-

UCT SPECIFICATIONS" section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT

Raise mower to its highest position.

At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance "A" on both sides of mower should be the same or within 1/4" of each other.

If adjustment is necessary, make adjustment on one side of mower only.

To raise one side of mower, tighten lift link adjustment nut on that side.

To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE:Each full turn of adjustment nut will change mower height about 1/8".

Recheck measurements after adjust- ing.

Bottom edge of

Bottom edge of

m°we_°und

Suspension

Before making any necessary adjust. ments, check that both front links are

equal in length. Both links should b_ approximately 10-3/8 =.

If links are not equal in length, adjust one link to same length as other link.

To lower front of mower loosen nut =E

on both front links an equal number < turns.

When distance =D" is 1/8" to 112" Iow_ at front than rear, tighten nuts "P against trunnion on both front links.

To raise front of mower, loosen nut =F from trunnion on both front links.

Tighten nut "E" on both front links an equal number of turns.

When distance "D" is 1/8" to 1/2" Iow_ at front than rear, tighten nut "P against trunnion on beth front links.

Recheck side-to-side adjustment.

,Mandrel

"D""D"

Both Front Links Should be Equal in Length

Lift Link Adjustment Nut

 

Nut

=E"

 

 

 

 

 

FRONT-TO-BACK ADJUSTMENT

 

 

IMPORTANT:

Deck must be level side-to

 

 

side. If the following front-to-back

 

 

adjustment is necessary, be sure to

 

 

adjust both

 

front links equally

so mower

 

Front Links

will stay level side-to-side;

 

 

 

To obtain the best cutting results, the

 

 

mower housing should be adjusted so

 

 

that the front

is approximately

1/8" to 1/2"

 

 

lower than

the rear when the

mower iS In

 

 

its highest

position.

 

 

 

Check adjustment on right side of tractor. Measure distance =D" directly in front and behind the mandrel at bottom edge of mower housing as shown,

23

Image 23
Contents £RAFTZMANo General Operation Parts Ordering Back CoverChildren ServiceSlope Operation Do notMachine. Tall grass can hide obsta- cles TIONI!! Become AWARE!!! Your Safety is InvolvedProduct Specifications Steering Wheel Attach Steering Wheel Before Removing Tractor From SkidTo Drive Tractor OFF Skid HOW to SET UP Your TractorCheck Battery Install SeatCheck for Proper Position of ALL Belts To Convert to Bagging or DischargingCheck Tire Pressure Check Deck LevelnessWhile Learning HOW to USE Youf All assembly instructions have been completedH L Knowyourtractor HOW to USE Your Tractor To Transport To Adjust Gauge WheelsTo Operate Mower To Operate on HillsADD Gasoline To Start EngineBefore Starting the Enigne Check Engine OIL Level Purge Transmission Mulching Mowing Tips Mowing TipsBefore Each USE Lubrication ChartMaintenance Schedule General RecommendationsOperator Presence System TiresClean AIR Screen TocleanbatteryandterminalsIN-LINE Fuel Filter Clean AIR INTAKE/COOUNG AreasTo Service PRE-CLEANER Spark PlugsTractor CleaningTo Install Mower To Level Mower HousingFRONT-TO-BACK Adjustment To Level Mower HousingSIDE-TO-SIDE Adjustment Belt Removal Belt InstallationTo Adjust Brake To Replace Mower Blade Drive BeltFront Wheel TOE-IN/CAMBER To Adjust Steering Wheel AlignmentTransaxle Motion Control Lever Neutral Adjustment Transmission REMOVAL/REPLACE- MentInterlocks and Relays To Start Engine with a Weak BatteryReplacing Battery To Replace Headlight BulbTo Adjust Choke Control To Remove Hood and Grill AssemblyTo Adjust Carburetor To Adjust Throttle Control CableIdle Speed Lever =---,f \Idle Mixture Screw Engineoil Engine Fuel SystemCylinders OtherCorrection Troubleshooting ChartProblem CauseCorrection ProblemChart Cause Slow ProblemcauseTractor -. Model Number SchematicTractor - Model Number Electrical KEY Tractor - Model Number ElectricalTractor - Model Number Chassis and Enclosures IL=Y Part Desciiption Tractor - Model Number 917.270961 Chassisand EnclosuresTractor - Model Number Ground Drive KEY Part Description Tractor --MODEL Number Ground DriveTractor - Model Number 917.270961 Steering Assembly 12000029 Tractor --MODEL Number Steering AssemblyOptional Equipment EngineTractor - Model Number Engine Part Description Part KEY Part Description DESCRIP/1ON Tractor - Model Number Seat AssemblyPart NO. no Tractor --MODEL NumberDecals Wheels & TiresTractor - Model Number Liftassembly Tractor - Model Number Lift Assembly Mowerdeck Arm, Suspension, Rear Mower Deck Part NO. noTractor - Model Number Hydro Gear Transaxle - Model Number KL=Y PAR Description Tractor - Model Number Hydro Gear Transaxle . Model Number61SA 392,32 Gasket SET KEY Part Description KEY Part NO. no263060 Page Page Only Ride UP and Down Hill Not Across Hill Suggested Guide for Sighting Slopes for Safe OperationPartsDirect sM

917.270961 specifications

The Craftsman 917.270961 is a remarkable lawn tractor designed for both efficiency and ease of use, making it an excellent choice for homeowners with medium to large yards. This powerful riding mower features a robust 19 horsepower Kohler engine, ensuring reliable performance and the capability to handle various terrains. With a 42-inch cutting deck, it provides a comfortable balance between maneuverability and cutting swath, making it suitable for a wide range of applications.

One of the standout features of the Craftsman 917.270961 is its automatic transmission. This technology allows for a smooth and seamless driving experience, enabling the operator to enjoy effortless control while mowing. With variable speed options, users can easily adjust the pace to suit their mowing style and the conditions of their yard, making it adaptable to various tasks.

The lawn tractor is equipped with a dual-blade system, ensuring a clean and even cut every time. This feature not only enhances the appearance of your lawn but also promotes healthy grass growth. Moreover, the deck is designed with an integrated washout port, facilitating easy cleaning after use and reducing the buildup of grass clippings.

Comfort is another priority in the design of the Craftsman 917.270961. The ergonomic seat is adjustable, allowing users of varying heights to find a comfortable position. The steering wheel is also designed for ease of handling, minimizing fatigue during longer mowing sessions.

For added convenience, this lawn tractor comes with an easy-to-read dashboard that displays essential information such as speed, fuel level, and engine temperature, keeping the user informed about the machine's performance at all times. Furthermore, the large-capacity fuel tank minimizes the need for frequent refueling, allowing for extended mowing sessions without interruptions.

Safety features are integrated throughout the Craftsman 917.270961, including an engine cutoff switch that activates when the operator leaves the seat. This ensures peace of mind while operating the mower, especially in landscapes with obstacles.

Overall, the Craftsman 917.270961 stands out as an efficient, comfortable, and versatile lawn tractor. With its solid engine performance, user-friendly design, and advanced mowing technologies, it is a reliable choice for homeowners aiming to maintain a pristine lawn with ease.