Craftsman 107.289920 manual Checks Before Starting, Fuel Recommendations

Page 17

CHECKS BEFORE STARTING

Check that the crankcase oil is filled to full mark on dipstick.

Fill the fuel tank with fresh fuel.

FUEL RECOMMENDATIONS

For daily operation: Use only unleaded gasoline with a pump sticker octane rating of 87 or higher. Gasohol (up to 10% ethyl alcohol, 90% unleaded gasoline by volume) is approved as a fuel. Methyl Teriary Butyl Ether (MTBE) and unleaded gasoline blends (up to a maximum of 15% MTBE by volume) are approved as a fuel. No other gaso-

line/alcohol or gasoline/ether blends are approved. Do not use fuel additives other than fuel stabilizer.

For storage: CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract mois- ture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

To avoid engine problems always use fuel stabilizer, especially before storage of 30 days or longer. Use fresh fuel next season. See STORAGE instructions for addi- tional information.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur. To add fuel:

1.Remove the fuel cap (B, Figure 7).

2.Fill the tank. Do not overfill. Leave room in the tank for fuel expansion.

3.Install and hand tighten the fuel cap.

Figure 7. Pre-Start Checks

A. Fuel Tank Cap

WARNING

Never operate on slopes greater than 17.6 percent (10 °) which is a rise of 3-1/2 feet (106 cm) vertically in 20 feet (607 cm) horizontally.

Select slow ground speed before driving onto a slope. Use extra caution when operating on slopes with a rear-mounted grass catcher.

Mow across the face of slopes, not up and down.

Use caution when changing directions and DO NOT START OR STOP ON A SLOPE.

,WARNING

Never allow passengers to ride on the unit.

Before leaving the operator's position for any reason, engage the parking brake, disengage the PTO, stop the engine and remove the key.

To reduce fire hazard, keep the engine, rider and mower free of grass, leaves and excess grease.

Do not stop or park rider over dry leaves, grass or combustible materials.

Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is still hot from recent operation. Do not allow open flame, smoking or matches in the area.

Avoid over-filling and wipe up any spills.

WARNING - TRAILERS

Do not load this zero-turnrider on a trailer or truck using two separate ramps. Only use a single ramp that is at least one foot wider than the width of the rear wheels of this rider.This rider has a zero turning radius and the wheels could fall off the ramps, or the rider could tip over injuring the operator or bystanders.

17

Image 17
Contents ZTS Page Craftsman Full Warranty Transporting and Storage General OperationChildren Towed Equipment RIDE-ON UnitsEmissions Ignition SystemDegrees MAX Only RiDE UP and Down HillSafe Handling of Gasoline Service and MaintenanceService & Maintenance Thrown Objects Hazard Safety & Operation DecalsEnglish and Spanish Installing the Seat Installing the SeatInstalling the Seat Safety Switch Installing the Seat Safety SwitchSetting Up the Ground Speed Control Levers Setting UP the Ground Speed Control LeversDeflector Hinge and Bracket Installing the Side Discharge DeflectorCheck the Tire Pressure Remove the Packaging MaterialsCheck Engine Oil Level CrateGround Control FunctionsLevers Parking Brake Lever Throttle/Choke Control Choke MaticGeneral Operating Safety Fuel Recommendations Checks Before StartingStopping the Rider & Engine Emergency StoppingStarting the Engine MowingForward Travel Practice Forward TravelReverse Travel Practice Reverse TravelExecuting Turns Practice Turning Around a Corner Practice Turning In PlaceExecuting an End-Of-Row Zero Turn Turning In PlaceRemoving the Mower Deck Mower Deck Removal & InstallationInstalling the Mower Deck Maintenance Maintenance ScheduleModels 26HP Briggs StrattonClean Debris from Rider and Engine Compartment Accessing the Engine CompartmentClean Debris from Engine Cooling Areas and AIR Filter Check Tire PressureRease LubricationBalancing the Blade Blade RemovalCheck Rider Safety System Cleaning the Battery and CablesAdjustment Nut Feeler Gauge Adjust PTO ClutchChange Engine OIL & Filter Check Engine OIL LevelChange Engine OIL Air Filter Removal Filter Cartridge Replace AIR FilterSpark Plug Gapping Clean Combustion ChamberSpeed Balancing Adjustment Ground Speed Control Lever AdjustmentCutting Height Adjustment PTO Clutch AdjustmentEngine Adjustments Brake AdjustmentBattery Charging Trunnion Jam Nuts Mower Deck Leveling AdjustmentsSide to Side Leveling Front To Back Leveling Mower Belt ReplacementMower Deck Washout Port A. Quick Disconnect Hose Mower Deck Washout PortAfter Storage Before StorageWill Problem Cause RemedyMower ZTS Page Garanta Completa DE Fabricacion PTS-1Transporte Y Almacenamiento Operacion GeneralEquipo Remolcado Unidades Monta Operacion EN CuestasEmisiones Sistema DE EncendidoDoblar a LO LARGo DE LA Servicio y Mantenimiento Servicio Y MantenimientoManejo Seguro de la Gasolina Calcomanias DE Seguridad Y OPERAClON Identificaci6n LlavesManual del Operador y Libro de Partes lngles/EspaSol Figura 1. Instalaci6n del asiento Instalacion DEL AsientoInstalacion DEL Interrupter DE Seguridad DEL Asiento 16-18 16-18 x 1-3/4 Figura 4. Bisagra del deflector y soporte de montaje Soporte Instalacion DEL Deflector DE Descarga LateralRevisar la Presi6n de las Mantas Leer el Manual del OperadorRevisar el Nivel de Aceite del Motor Llenar con Gasolina FrescaControl de Aceleracibn Estrangulador Choke-O-Matic Funciones DE ControlInterrupterde Transmisi6n Sesgadera EncendideInterruptor de Encendido Ajuste de Altura de Corte de laInterruptor de Cuchillas de la Palancas de Desembrague deVerificaciones Antes DE Arrancar Advertencia RemolquesDetener EL Montable Y EL Motor Paro DE EmergenciaArrancar EL Motor Podar EL C¢SPEDTraslado sin prob- lemas Practica DE ManejoManejo Hacia AdelanteEjecutar Vueltas Practica de dar Vuelta en una EsquinaEjecutar un Giro Cero al Final de la Fila Practica de Vuelta en el LugarRemocion E Instalacion DE LA Cubierta DE LA Sesgadora Retirar LA Plataforma DELMaintenimiento DEL Motor Programa DE MantenimientoAntes de Cada AnualLimpiar Despojos DEL Tractor Y DEL Compartimiento DEL Motor Ganar Acceso AL Compar Timiento DEL MotorFiltro DE Aire Verificar Presion DE LAS LLAN- TASAceite LubricacionLubricacibn de la Podadora Figura 24. Remoci6n del Aspa Limpiar Cubierta Y VERIFICAR/ Reemplazar Aspas DE PodadoraRevisiones de Seguridad de Operacibn Limpiar Baterja Y CablesLos ojos VERIFICAR/AJUSTAR Embrague DEL PTO Verifique EL Nivel DE Aceite DEL Motor Y EL Filtro Verifique EL Nivel DE Aceite DEL MotorFigura 33. Remoci6n del Filtro de Aire Cartucho del filtro Reemplazar EL Filtro DE AireIntervalo de servicio Cada 100 a 400 horas Reemplace LA Bujia DE EncendidoPara Ajustar la Altura de las Palancas de Control Ajuste DE Palanca DE Control DE VelocidadAjuste DE Embrague DEL PTO Ajustes DEL Motor Ajuste DE LOS FrenosRecarga DE LA Baterja Nivelado de un Lado a Otro Ajuste DE Nivel DE LA Cubierta DE LA PodadoraFigura 42. Orientar las Aspas de Adelante hacia Atrs Nivelado FrontoposteriorPuerto DE Deslave DE LA Plataforma DEL Cortaci Sped Tipo MotorModelo Liquido para PotenciaenAceite ConsumoImpulsa Gadora es deRepairParts =14 ZTS 60003159 ZTS Body & Seat GroupFrame, Body & Seat Group Body Seat Group Engine Group 26HP Briggs & Stratton Engine Group 26HP Briggs Stratton ZTS 6000 Footnotes QTY DescriptionTransmission Group Hydro Seal KIT REF no PARTNO. QTY. DescriptionControls Group QTY. Description GroupControls Group REF no Partno QTY. Description Electrical Group Electrical Group Lift Group Lift Group Wheel & Tire Group Wheel & Tire Group REARVl EW Ansi 21 16 Mower Deck Clutch & Support Group ZTS 6000REF no Part NO. QTY Mower Deck ClutchMower Deck Housing & Arbor Group ZTS 6000 REF no Mower Deck Housing Arbor GroupZTS 107.289920 445877-0132-B1 6000 107.289920 ZTSZTS 6000 445877-0132-B1 6000 107.289920 445877-0132-B1 883 918 793147 796647690971 793146633 690951 51A 690950654 690958 690718968i 467 163 691001197 697820 573216 188 265 267 2O9 ,9 211 1005 526 .,i 474 696458 691053691283 494439Carburetor Overhaul KIT 883 690970 868 690968693997 276Standard Hardware Sizing Hardware identification& TorqueSpecificationsServicio de Instalacion de Sears Repair Protection AgreementsAcuerdo de Proteccion de Reparaciones MY-HOME