Craftsman 107.289920 manual Problem Cause Remedy, Will

Page 37

Whilenormalcareandregularmaintenancewillextend thelifeofyourequipment,prolongedorconstantuse mayeventuallyrequirethatservicebeperformedto allow itto continueoperatingproperlyThetroubleshooting. guidebelowliststhemostcommonproblems,theircaus- esandremedies.

Ifyouprefer,alloftheseprocedurescanbeperformed foryoubyaSearsParts& RepairCenterSeetheback. coverforimportantSearsParts& RepairCenterinforma- tion.

iTroubleshooting the Rider

AWARNING

To avoid serious injury, perform maintenance on the rider or mower only when the engine is stopped and the ground speed levers are set to PARK.

Always remove the ignition key, disconnect the spark plug wire and fasten it away from the plug before beginning the maintenance, to prevent accidental starting of the engine.

PROBLEM

CAUSE

 

 

 

REMEDY

 

 

 

 

 

 

 

 

Engine

will

Ground

speed levers not set to START/PARK.

Set to START/PARK.

 

 

 

 

 

not turnover

Mower

blade switch in ON position.

 

Place

in OFF

position.

 

 

 

 

ior start.

 

Ground

speed levers not set to START/PARK.

Set to START/PARK.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Choke

not in CLOSED position.

 

Move choke to CLOSED

position.

 

 

 

 

Ignition

switch not turned fully to START

position.

Turn ignition switch fully to START position.

 

 

 

Out of fuel.

 

 

 

Allow engine to cool, then refill the fuel tank.

 

 

 

Engine

flooded.

 

 

 

Set choke

to OPEN

position when cranking

engine.

 

 

Fuel is old or stale, or water

in fuel.

 

Drain

fuel

& replace

with fresh

fuel. Contact

Sears

 

 

 

 

 

 

 

Parts

& Repair.

 

 

 

 

 

 

 

 

Battery

terminals

require cleaning.

 

Clean

the

battery

terminals.

 

 

 

 

 

Battery

discharged

or dead.

 

 

Recharge

or replace.

 

 

 

 

 

 

 

Spark

plug(s) faulty, fouled or incorrectly

gapped.

Clean and gap or replace.

 

 

 

 

 

Wiring

loose or broken.

 

 

Visually check wiring & replace broken or frayed

 

 

 

 

 

 

 

wires. Tighten

loose

connections.

 

 

 

 

Solenoid or starter motor faulty.

 

Replace.

Contact

Sears

Parts

& Repair

 

 

 

 

Safety

interlock switch faulty.

 

 

Replace.

Contact

Sears

Parts

& Repair.

 

 

Engine

starts

Air filter plugged.

 

 

 

Service

pre-cleaner

and/or replace air filter

 

hard or

runs

 

 

 

 

 

element.

 

 

 

 

 

 

 

 

 

poorly.

 

Choke

not set to CLOSED position when

 

Set choke to CLOSED when cranking.

Set choke to

 

 

cranking the engine, OR choke not set to OPEN

OPEN

when

engine

is running.

Awarm

engine may

 

 

after engine starts,

 

 

not require

choking.

 

 

 

 

 

 

 

Spark

plug faulty, fouled, or incorrectly gapped.

Clean and gap or replace.

 

 

 

Engine

 

Low oil level.

 

 

 

Check/add

oil as required.

 

 

 

knocks.

 

Using wrong grade oil.

 

 

See "Change

Engine

Oil" in the Maintenance

 

 

 

 

 

 

 

 

Section.

 

 

 

 

 

 

 

 

 

Excessive oil

Engine

running too hot.

 

 

Clean engine cooling fins, blower screen and air

Iconsumption,

 

 

 

 

 

cleaner.

 

 

 

 

 

 

 

 

 

 

 

Using wrong weight oil.

 

 

See "Change

Engine

Oil" in the Maintenance

 

 

 

 

 

 

 

 

Section.

 

 

 

 

 

 

 

 

 

 

 

Too much oil in crankcase.

 

 

Drain

excess

oil.

 

 

 

 

 

 

Engine

 

Dirty air filter or pre-cleaner,

or both.

 

Service

or replace

as required.

See Maintenance

exhaust

is

 

 

 

 

 

Section.

 

 

 

 

 

 

 

 

 

black.

 

Choke

set to CLOSED when

engine is running.

Set choke to OPEN as soon as engine

starts.

37

Image 37
Contents ZTS Page Craftsman Full Warranty Transporting and Storage General OperationChildren Towed Equipment RIDE-ON UnitsEmissions Ignition SystemDegrees MAX Only RiDE UP and Down HillService & Maintenance Service and MaintenanceSafe Handling of Gasoline Thrown Objects Hazard Safety & Operation DecalsEnglish and Spanish Installing the Seat Installing the SeatInstalling the Seat Safety Switch Installing the Seat Safety SwitchSetting Up the Ground Speed Control Levers Setting UP the Ground Speed Control LeversDeflector Hinge and Bracket Installing the Side Discharge DeflectorCheck the Tire Pressure Remove the Packaging MaterialsCheck Engine Oil Level CrateGround Control FunctionsLevers Parking Brake Lever Throttle/Choke Control Choke MaticGeneral Operating Safety Fuel Recommendations Checks Before StartingStopping the Rider & Engine Emergency StoppingStarting the Engine MowingForward Travel Practice Forward TravelReverse Travel Practice Reverse TravelExecuting Turns Practice Turning Around a Corner Practice Turning In PlaceExecuting an End-Of-Row Zero Turn Turning In PlaceInstalling the Mower Deck Mower Deck Removal & InstallationRemoving the Mower Deck Maintenance Maintenance ScheduleModels 26HP Briggs StrattonClean Debris from Rider and Engine Compartment Accessing the Engine CompartmentClean Debris from Engine Cooling Areas and AIR Filter Check Tire PressureRease LubricationBalancing the Blade Blade RemovalCheck Rider Safety System Cleaning the Battery and CablesAdjustment Nut Feeler Gauge Adjust PTO ClutchChange Engine OIL Check Engine OIL LevelChange Engine OIL & Filter Air Filter Removal Filter Cartridge Replace AIR FilterSpark Plug Gapping Clean Combustion ChamberSpeed Balancing Adjustment Ground Speed Control Lever AdjustmentCutting Height Adjustment PTO Clutch AdjustmentBattery Charging Brake AdjustmentEngine Adjustments Side to Side Leveling Mower Deck Leveling AdjustmentsTrunnion Jam Nuts Front To Back Leveling Mower Belt ReplacementMower Deck Washout Port A. Quick Disconnect Hose Mower Deck Washout PortAfter Storage Before StorageWill Problem Cause RemedyMower ZTS Page Garanta Completa DE Fabricacion PTS-1Transporte Y Almacenamiento Operacion GeneralEquipo Remolcado Unidades Monta Operacion EN CuestasEmisiones Sistema DE EncendidoDoblar a LO LARGo DE LA Manejo Seguro de la Gasolina Servicio Y MantenimientoServicio y Mantenimiento Calcomanias DE Seguridad Y OPERAClON Manual del Operador y Libro de Partes lngles/EspaSol LlavesIdentificaci6n Figura 1. Instalaci6n del asiento Instalacion DEL AsientoInstalacion DEL Interrupter DE Seguridad DEL Asiento 16-18 16-18 x 1-3/4 Figura 4. Bisagra del deflector y soporte de montaje Soporte Instalacion DEL Deflector DE Descarga LateralRevisar la Presi6n de las Mantas Leer el Manual del OperadorRevisar el Nivel de Aceite del Motor Llenar con Gasolina FrescaControl de Aceleracibn Estrangulador Choke-O-Matic Funciones DE ControlInterrupterde Transmisi6n Sesgadera EncendideInterruptor de Encendido Ajuste de Altura de Corte de laInterruptor de Cuchillas de la Palancas de Desembrague deVerificaciones Antes DE Arrancar Advertencia RemolquesDetener EL Montable Y EL Motor Paro DE EmergenciaArrancar EL Motor Podar EL C¢SPEDTraslado sin prob- lemas Practica DE ManejoManejo Hacia AdelanteEjecutar Vueltas Practica de dar Vuelta en una EsquinaEjecutar un Giro Cero al Final de la Fila Practica de Vuelta en el LugarRemocion E Instalacion DE LA Cubierta DE LA Sesgadora Retirar LA Plataforma DELMaintenimiento DEL Motor Programa DE MantenimientoAntes de Cada AnualLimpiar Despojos DEL Tractor Y DEL Compartimiento DEL Motor Ganar Acceso AL Compar Timiento DEL MotorFiltro DE Aire Verificar Presion DE LAS LLAN- TASLubricacibn de la Podadora LubricacionAceite Figura 24. Remoci6n del Aspa Limpiar Cubierta Y VERIFICAR/ Reemplazar Aspas DE PodadoraLos ojos Limpiar Baterja Y CablesRevisiones de Seguridad de Operacibn VERIFICAR/AJUSTAR Embrague DEL PTO Verifique EL Nivel DE Aceite DEL Motor Y EL Filtro Verifique EL Nivel DE Aceite DEL MotorFigura 33. Remoci6n del Filtro de Aire Cartucho del filtro Reemplazar EL Filtro DE AireIntervalo de servicio Cada 100 a 400 horas Reemplace LA Bujia DE EncendidoAjuste DE Embrague DEL PTO Ajuste DE Palanca DE Control DE VelocidadPara Ajustar la Altura de las Palancas de Control Recarga DE LA Baterja Ajuste DE LOS FrenosAjustes DEL Motor Nivelado de un Lado a Otro Ajuste DE Nivel DE LA Cubierta DE LA PodadoraFigura 42. Orientar las Aspas de Adelante hacia Atrs Nivelado FrontoposteriorPuerto DE Deslave DE LA Plataforma DEL Cortaci Sped Tipo MotorModelo Liquido para PotenciaenAceite ConsumoImpulsa Gadora es deRepairParts 3159 ZTS 6000=14 ZTS Body & Seat GroupFrame, Body & Seat Group Body Seat Group Engine Group 26HP Briggs & Stratton Engine Group 26HP Briggs Stratton ZTS 6000 Footnotes QTY DescriptionTransmission Group Hydro Seal KIT REF no PARTNO. QTY. DescriptionControls Group QTY. Description GroupControls Group REF no Partno QTY. Description Electrical Group Electrical Group Lift Group Lift Group Wheel & Tire Group Wheel & Tire Group REARVl EW Ansi 21 16 Mower Deck Clutch & Support Group ZTS 6000REF no Part NO. QTY Mower Deck ClutchMower Deck Housing & Arbor Group ZTS 6000 REF no Mower Deck Housing Arbor GroupZTS 107.289920 445877-0132-B1 6000 107.289920 ZTSZTS 6000 445877-0132-B1 6000 107.289920 445877-0132-B1 883 918 793147 796647690971 793146633 690951 51A 690950654 690958 690718968i 467 163 691001197 697820 573216 188 265 267 2O9 ,9 211 1005 526 .,i 474 696458 691053691283 494439Carburetor Overhaul KIT 883 690970 868 690968693997 276Standard Hardware Sizing Hardware identification& TorqueSpecificationsAcuerdo de Proteccion de Reparaciones Repair Protection AgreementsServicio de Instalacion de Sears MY-HOME