Orion C05001, C08001 owner manual Troubleshooting Tips, Symptom Probable Cause Action To Take

Page 12

Troubleshooting Tips

Symptom Probable Cause

Action To Take

 

 

No output

 

 

 

Low or no remote turn-on

Check remote turn-on voltage at voltage

 

amplifier and repair as needed.

 

 

Fuse blown

Check power wire's integrity and check for

 

speaker shorts. Fix as needed and replace

 

fuse.

 

 

Power wires not connected

Check power wire and ground connections

 

and repair or replace as needed.

 

 

Audio input not connected.

Check RCA connections and repair or replace

 

as needed.

 

 

Speaker wires not connected

Check speaker wires and repair or replace as

 

needed.

 

 

Speaker are blown

Check system with known working speaker

 

and repair or replace speakers as needed.

 

 

Audio cycles on and off

 

 

 

Thermal protection engages

Make sure there is proper ventilation for am-

when amplifier heat sink tem-

plifier and improve ventilation as needed.

perature exceeds 50º C (122º F)

 

 

 

Loose or poor audio input

Check RCA connections and repair or replace

 

as needed.

 

 

Loose power connections

Check power wires and ground connections

 

and repair or replace as needed.

 

 

Distorted output

 

 

 

Amplifier level sensitivity set

Readjust gain. Refer to the Adjusting the

too high exceeding maximum

Sound of the System section of this manual

capability of amplifier

for detailed instructions.

 

 

Impedance load to amplifier

Check speaker impedance load, if below 2Ω,

too low

rewire the speakers to achieve higher imped-

 

ance.

Shorted speaker wires

Check speaker wires and repair or replace as

 

needed.

 

 

Speaker not connected to am-

Check speaker wires and repair or replace as

plifier properly.

needed. Refer to the Speaker Connections

 

section of this manual for detailed instruc-

 

tions

 

Internal crossover not set prop- Readjust crossovers. Refer to the Internal

erly for speakers

Crossover Configuration section of this

 

manual for detailed instructions.

 

 

Speakers are blown

Check system with known working speakers

 

and fix or replace as needed.

 

 

Poor bass response

 

 

 

Speakers wired with wrong

Check speaker polarity and fix as needed.

polarity causing cancellation at

 

low frequencies.

 

 

 

© 2008 directed electronics—all rights reserved

11

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Amplifier Table of Contents Introduction WHAT’S in the BOXPractice Safe Sound Tools of the Trade END Panel LayoutsInput Plate CEA Specifications Output PlateAmplifier Settings High Level HarnessesAmplifier Wiring Power Connections for the Orion Cobalt CO5001 and CO8001Speaker Wiring Diagram CO5001/CO8001 Low-Pass CrossoverAmplifier Installation BridgingChoosing Mounting Locations Passenger CompartmentGeneral Precautions and Installation Tips Step By Step InstallationTrunk Compartment SET UP and Troubleshooting Testing the SystemAdjusting the Sound of the System Troubleshooting Tips Symptom Probable Cause Action To TakeSymptom Probable Cause Action To Take Specifications Amplifier Section CO5001 CO8001Crossover Section Directed electronics-all rights reserved Agencement DES Panneaux Dextrémité Panneau dentrée figurePanneau de sortie figure Configurations dentrée et sortie du signal Spécifications DE LaceFaisceaux À Haut Niveau Réglages DE LamplificateurCâblage DE Lamplificateur Installation DE Lamplificateur Choix de lemplacement du montageCâblage des haut-parleurs CO5001/CO8001 Branchement en pontPrécautions générales et conseils dinstallation Installation étape par étapeCoffre Réglage ET Dépannage Essai du systèmeRéglage sonore du système Conseils de dépannage Symptôme Cause probable FaireDirected electronics-all rights reserved Spécifications Section amplificateur CO5001 CO8001Section répartiteur Disposiciones DEL Panel DE Extremo Placa de entrada figuraPlaca de salida figura Configuraciones DEL Amplificador Configuraciones de salida y entrada de señalEspecificaciones DE LA CEA Arneses DE Cableado DE Alto NivelCableado DEL Amplificador Diagrama de cableado de altavoces del CO5001/CO8001 Instalación DEL AmplificadorConexión en puente Selección de ubicaciones de montajeCompartimiento de pasajeros MaleteroPrecauciones generales y sugerencias de instalación Configuración Y Detección Y Reparación DE Averías Instalación paso a pasoPrueba del sistema Ajuste de sonido del sistema Sugerencias de detección y reparación de averías Síntoma Causa probable Medidas a tomarDirected electronics-all rights reserved Especificaciones Sección de amplificador CO5001 CO8001Sección de crossover Layout DER Endplatten Anschlussplatte abbildungAusgangsplatte abbildung Signaleingangs- und -ausgangskonfigurationen CEA-DATENHOCHPEGEL-LEITUNGSSYSTEME VerstärkereinstellungenVerstärkeranschluss Verstärkerinstallation Lautsprecher-Anschlussdiagramm CO5001/CO8001Brückenmodus Wahl der EinbaustelleAllgemeine Vorsichts- und Installationshinweise FahrgastraumKofferraum Einrichtung UND Problembehebung Schrittweise InstallationSystemtest Systemsound einstellen Problemlösungen Symptom Mögliche Ursache LösungDirected electronics-all rights reserved Daten Verstärkerbereich CO5001 CO8001Crossover-Bereich Layout DEI Pannelli Terminali Pannello d’ingresso figuraPannello di uscita figura Configurazione dei segnali d’ingresso e di uscita Specifiche CEACavi DI Livello Alto Impostazioni DELL’AMPLIFICATORECablaggio DELL’AMPLIFICATORE Installazione DELL’AMPLIFICATORE Scelta del punto di installazioneCablaggio a ponte Precauzioni generali e suggerimenti per l’installazione AbitacoloBagagliaio Messa a Punto E Soluzione DEI Problemi Procedura di installazioneProva dell’impianto Regolazione dell’audio dell’impianto Soluzione dei problemi Sintomo Causa probabile Intervento necessarioDirected electronics-all rights reserved Dati Tecnici Sezione amplificatore CO5001 CO8001Sezione crossover Layouts DOS Painéis Painel de entrada figuraPainel de saída figura Configurações de entrada e saída dos sinais Especificações DA CEALigações DE Alto Nível Ajustes do AmplificadorConexão DOS Cabos do Amplificador Instalação do Amplificador Esquema de conexão dos alto-falantes ao CO5001/CO8001Ligação em ponte Escolha de locais de instalaçãoCabine de passageiros Porta-malasPrecauções gerais e sugestões de instalação Instalação E Resolução DE Problemas Instalação passo a passoComo testar o sistema Como ajustar o som do sistema Sugestões para resolução de problemas Problema Provável causa Medida a ser tomadaDirected electronics-all rights reserved Especificações Seção do amplificador CO5001 CO8001Seção do crossover Warranty

C08001, C05001 specifications

The Orion C05001 and C08001 represent a remarkable leap in technology and innovation, designed to cater to the evolving demands of modern users in various sectors, from industrial applications to advanced consumer electronics. These models stand out not just for their robust performance but also for their cutting-edge features.

Starting with the Orion C05001, this device showcases a sleek and compact design, making it an ideal choice for those who prioritize portability without compromising functionality. It is equipped with a powerful processor that ensures seamless multitasking and efficient handling of resource-intensive applications. The C05001 also boasts enhanced connectivity options, including advanced wireless capabilities, which allow users to stay connected even in remote areas.

In terms of display, the C05001 offers a high-resolution screen that provides clear, vibrant visuals, making it suitable for both professional presentations and entertainment purposes. The device’s battery life is another strong point, featuring long-lasting performance that enables users to work or play without the constant worry of recharging.

On the other hand, the Orion C08001 takes performance up a notch with its larger display and enhanced processing power. This model is ideal for users who require a more immersive experience, whether for gaming, graphic design, or data analysis. The C08001 supports advanced graphics, making it suitable for high-demand applications that require detailed visuals and fast frame rates.

Both models leverage state-of-the-art technologies, including artificial intelligence and machine learning capabilities. These features enable smarter performance optimization, energy efficiency, and intuitive user interfaces that adapt to user preferences and habits.

Another key characteristic of the Orion C05001 and C08001 is their durable construction, designed to withstand tough conditions. This resilience makes them perfect for industrial environments where reliability is paramount.

Moreover, security features in both models ensure that users' data remains protected, incorporating encryption and biometric authentication, which are increasingly essential in today’s digital landscape.

In summary, the Orion C05001 and C08001 are not just devices; they are engineered solutions that combine high performance, cutting-edge technology, and robust features, making them suitable for a wide range of applications, from everyday tasks to complex industrial challenges. Their innovative designs promise to enhance productivity and user experience, setting new standards in their respective categories.
Top Page Image Contents