Weed Eater WELRVBA30 warranty Reglas DE Seguridad Storage, Mower, Battery, Other

Page 25

REGLAS DE SEGURIDAD

STORAGE

SERVICIO GENERAL

•Nunca opere la máquina en un área cerrada.

•Mantenga todas las tuercas y pernos apretados para asegurarse de que el equipo se encuentra en condiciones de trabajo seguras.

•Nunca manipule los dispositivos de seguridad. Revise con regularidad que operen bien.

•Mantenga la máquina libre de cualquier acumu- lación de césped, hojas u otra basura. Limpie los derrames de aceite o combustible y retire cualquier basura que contenga combustible. Permita que la máquina se enfríe antes de almacenarla.

•Si usted golpea un objeto extraño, deténgase e inspeccione la máquina. Repárela, de ser necesario, antes de volver a empezar.

•Nunca haga ajustes o reparaciones con el motor en funcionamiento.

•Revise los componentes del colector de césped y la canaleta de descarga con frecuencia y sustituya con repuestos recomendados por el fabricante cuando sea necesario.

•La cuchilla de la cortadora de césped tiene filo. Envuelva la cuchilla o use guantes y tenga precaución extrema cuando les dé servicio.

•Revise la operación del freno con frecuencia. Ajuste y dé servicio según sea necesario.

•Conserve o cambie las etiquetas de seguridad e instrucciones según sea necesario.

•Asegúrese de que el área esté libre de curio- sos antes de operar la máquina. Detenga la máquina si alguien entra en el área.

•Nunca transporte pasajeros.

•No corte en reversa, a menos que sea absolu- tamente necesario. Siempre mire hacia abajo y hacia atrás antes y cuando vaya en reversa.

•Al cargar o descargar la máquina, no sobrepase el ángulo máximo recomendado de 15°.

Immediately prepare your riding mower for storage at the end of the season or if the riding mower will not be used for 30 days or more.

WARNING: Never store the riding mower with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before stor- ing in any enclosure.

MOWER

Remove deck from mower for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire riding mower (See “CLEAN- ING” in the Maintenance section of this manual).

2.Inspect and replace belt, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•If battery is removed from riding mower for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage. Also, alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

•Empty the fuel tank by starting the engine and letting it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable al- ternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

1.Remove spark plug(s).

2.Pour one ounce of oil through spark plug hole(s) into cylinder(s).

3.Turn ignition key to “START” position for a few seconds to distribute oil.

4.Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your riding mower indoors and cover it to give protection from dust and dirt.

•Cover your riding mower with a suitable protective cover that does not retain mois- ture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your riding mower to rust.

IMPORTANT: Never cover riding mower while engine and exhaust areas are still warm.

32

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents 10.24.11 CL Parts and ServiceWarranty Table of ContentsIdentificación DE Problemas Safety RulesAlways wear eye protection when operat- ing machine General OperationIII. Children IV. Service Safe Handling of GasolineGeneral Service Almacenamiento Safety RulesMotor Unassembled Parts Product SpecificationsCustomer Responsibilities Tools Required for Assembly ASSEMBLY/PRE-OPERATIONHOW to SET UP Your Riding Mower To Remove Riding Mower from CartonTo Adjust Seat Install SeatFront and Back Lumbar SupportServicio Y Ajustes Limpieza OperationBatería Cambio DE Aceite DEL Motor Know Your Riding MowerEnfriamiento DEL Transeje Cinta ENHOW to USE Your Riding Mower Mantenimiento To Attach Deflector Reverse Operation System ROSTo Operate on Hills To TransportBefore Starting the Engine Antes DEL Arranque DEL MotorTo Start Engine Funcionamiento Atrás ROS Mowing TipsColocación DEL Deflector Operación EN ColinasGeneral Recommendations MaintenanceBefore Each USE Cómo Usar LA Cortadora DE Césped Engine Conozca SU Cortadora DE CéspedOperación CleaningLista DE Revisión Service and AdjustmentsRiding Mower SIDE-TO-SIDE Adjustment To Level Mower HousingFRONT-TO-BACK Adjustment Para Instalación DEL AsientoRetiro DE LA Cortadora DE Césped DE LA Caja DE Cartón ENSAMBLADO/PREOPERACIÓNPartes no Ensambladas Reglas DE Seguridad Storage BatteryMower OtherReglas DE Seguridad Troubleshooting ChartIII. Niños IV. ServicioII. Operación EN Pendientes Operación GeneralUse siempre protección ocular cuando opere la máquina Tabla DE Contenido Operación Solución DE ProblemasGarantía Only Ride UP and Down HILL, not Across Hill Degrees MAX
Related manuals
Manual 8 pages 63.88 Kb

WELRVBA30 specifications

The Weed Eater WELRVBA30 is an innovative lawn care tool designed for homeowners seeking efficient and reliable trimming solutions. This versatile electric string trimmer boasts a range of features, technologies, and characteristics tailored to enhance lawn maintenance while providing ease of use and environmental sustainability.

One of the standout features of the WELRVBA30 is its powerful 30cc 2-cycle engine, which ensures robust performance while trimming grass and weeds in various terrains. This engine delivers ample power and torque, allowing the user to tackle thick underbrush and overgrown areas with ease. The design is lightweight and well-balanced, making it highly maneuverable for extended periods.

Equipped with a cutting width of 16 inches, the trimmer allows for efficient coverage of larger areas at once. This generous cutting diameter means less time spent trimming and more time enjoying your well-maintained lawn. Additionally, the adjustable handle provides comfort and control, catering to users of different heights and preferences.

The WELRVBA30 features a dual-line bump feed system, enabling quick and easy line advancement. Simply bump the trimmer head against the ground, and new line extends automatically, minimizing downtime during use. This feature is particularly useful for large jobs and allows users to maintain productivity without frequent interruptions.

Durability is a hallmark of the WELRVBA30, which is built with high-quality materials designed to withstand the rigors of outdoor use. The trimmer's heavy-duty cutting head can handle tough vegetation, while the robust housing provides protection and longevity.

For environmental consciousness, the Weed Eater WELRVBA30 operates on a low-emission engine, significantly reducing harmful pollutants while providing excellent fuel efficiency. This aligns with the growing demand for eco-friendly lawn care solutions.

In summary, the Weed Eater WELRVBA30 is an exceptional tool that combines power, efficiency, and user-friendly features. Its robust engine, adjustable functionalities, and durable construction make it an ideal choice for homeowners looking to maintain their lawns with ease. Whether tackling small patches of grass or large, unruly areas, this trimmer ensures that the job is done efficiently and effectively.
Top Page Image Contents