Sears 917.275223 To Adjust Attachment Clutch, To Replace Motion Drive Belt, Belt Removal

Page 28

TO ADJUST ATTACHMENT CLUTCH

The electric clutch should provide years of service. The clutch has a buiti-in brake

that stopsthe pulley within 5 seconds. Eventually, the internal brake will wear which may cause the mower blades to not engage, or,to not stop as required• Adjustments should be made by your nearest authorized service canter/ department.

1.Make sure attachment clutch and ignition switches ere in "OFF" position.

2.Adjust the three nylon lecknuts until space between clutch plate end rotor measures .012" at all three slot

locations cut in the side of brake plate• NOTE: After installing a new electric clutch, run tractor at full throttle and engage and disengage electric clutch 10 cycles to wear in clutch plate.

Rotor-_._ Clutch_atei_.012-

Plate

NylonLocknut(3) /

TO REPLACE MOTION DRIVE BELT

Park the tractor on level surface. Engage parking brake. For ease of service there is a belt installation guide decal on bottom of left footrest.

1.Remove mower (See "TO REMOVE

MOWER" in this section of this manual.)

BELT REMOVAL -

2.Create slack in belt by removing retainer spring from dave belt tension handle.

3.Remove belt from all idler pulleys, trancaxle pulley and then from engine pulley.

BELT INSTALLATION -

1.Install new belt around engine pulley first, then around transaxle pulley and lastly into all the idler pulleys.

2.Check to be sure belt is positioned correctly and is on proper side of all belt keepers.

3.Engage the drive belt tension handle and replace the retainer spring.

4.Reinstall mower.

Retainer

Spring

Ddve Bel

Tension

Handle

Engine Pulley

Transaxle PuUey

iv/Belt Keeper

--Flat Idler

B_eSper

• C utcning

Keeper V-Idler Clutch ng Fiat Idler

Idler

TRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT

The motion control lever has been preset at the factory and adjustment should not be necessary.

1.Park Tractor on level surface. Stop tractor by turning ignition key to "OFF" position and engage parking brake.

2.Loosen the adjustment bolt in front of the dght rear wheel.

3.Move motion control lever to the neutral position.

4.Tighten the adjustment bolt.

TRANSMISSION REMOVAL/REPLACE- MENT

Should your transmission require removal for service or replacement, it should be purged after reinstallation and before operating the tractor, See "PURGE TRANSMISSION" in the Operation section of this manual.

28

Image 28
Contents Garden Tractor Limited 90 DAY Warranty on Battery General Operation Mow only in daylight or good artificial lightStorage I1. Slope OperationIV. Service Machine. Tall grass can hide obstaclesCancer and birth defects or other repro- ductive harm Gasoline 3.5 Gallons Andtype RegularSpeedmph Reverse Repair AgreementSteedng Sleeve SteedngWheellnse 17132 x 1-3/16 x 12 GaugeRetainer Shoulder Bolt Washers X 3/4 x 14 GaVideo Cassee Keys Slope Sheet Tools Required for Assembly To Removetractor from Carton Unpack CartonBefore Removing Tractor from Skid Attach Steering Wheel Teenng Steering Wheel Adapter Sleeve Tabs ExtensionInstall Seat Howto SET Upyourtractor Check BatteryBolt Assemble Gaugewheelsto Mower Deck Slide mower under tractor withCheck Mower Levelness Check Tire PressureCheck for Proper Position of ALL Belts Charged, Minimum 1 hour at 6 amps DampedENG,NEONENO,NEOFF.LRESSUREL,OHTSOND.P T Knowyourtractor Attachment Clutch SwitchLift To Adjust Mower Cutting Height Howto Useyourtractor To SET Parking BrakeStopping Ground DriveTo Adjust Gauge Wheels To Operate MowerDeflector Shield To Operate on HillsTo Transport Towing Carts and Other ATTACH- MentsBefore Starting the Engine Check Engine OIL Level ADD GasolineAutomatictransmission Warm UP Tion of clippings and more uniform cutting General Recommendations Lubrication ChartBefore Each USE Tractor Brake OperationTires Operator Presence SystemTo Clean Battery and Terminals BeltsTransaxle Cooling Transaxle Pump FluidClean AIR Screen Clean AIR Intakeicooling AreasTo Service PRE-CLEANER To Service CartridgeTo Install Mower To Level Mower HousingSIDE-TO-SIDE Adjustment Ractor To Remove MowerMower Drive Belt Installation FRONT-TO-BACK AdjustmentTo Replace Mower Drive Belt Mower Drive Belt Removal Electric Clutch To Replace Mower Blade Drive BeltTo Adjust Attachment Clutch Belt InstallationTransaxle Motion Control Lever Neutral Adjustment To Replace Motion Drive BeltTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN AdjustmentTo Adjust TOE-IN BatteryTo Adjust Attachment Lift Spring To Remove Hood and Grill AssemblyTo Replace Fuse To Replace Headlight BulbTo Adjust Throttle Control Cable To Adjust CarburetorTo Adjust Choke Control Preliminary SettingAdjusting screw in or out until correct idle is attained Recheck idle speed. Readjust if necessary1RACTOR Engine Fuel SystemEngine OIL CyundersTroubleshooting Chart ProblemCause Cutting too much grass/too fast Throttle in Choke positionWom. bent or loose blade Mower deck not level CorrectionTroubleshooting Chart Problem Cause Correction Faulty alternator Freewheel control in disengaged positionWet grass Mower deck not level OFFTRACTOR- Model Number Schematic Electrical TRACTORMODELNUMBER917-.275223 TRACTORMODELNUMBER917-.275223 Electrical TRACTOR- MODELNUMBER917.275223 Chassisandenclosures TRACTORMODELNUMBER917-.275223 Chassisandenclosures TRACTOR- MODELNUMBER917.275223 Grounddrive KEY Part NO. NO.DESCRIPTION TRACTOR- Model Number Steering KEY pART TRACTORMODELNUMBER917-.275223 Engine TRACTOR- Model Number Seatassembly TRACTORMODELNUMBER917-.275223 Decals TRACTOR- MODELNUMBER917.275223 LiFTASSEMBLY Ili TRACTOR- Model NU Mber Mowerdeck TRACTOR- MODELNUMBER917.275223 TRANSAXLE-MODELNUMBER311.3500 Screw Cylinder Head Valvi & Breather EADNALVE/BREATHER KEY IiI 24-164-06-S ECONTROLSp KEY Part NO. NO.DESCRIPTION Crankshaft Exhaust J Fuel System Not Illustrated Page Suggested Guide for Sighting Slopes for Safe Operation Part 0o..-7278

917.275223 specifications

The Sears 917.275223 is a robust lawn tractor that has earned a reputation among homeowners for its reliable performance and durability. Designed primarily for residential use, this lawn tractor features a user-friendly design that caters to both seasoned gardeners and those new to lawn care.

One of the standout characteristics of the Sears 917.275223 is its powerful engine, typically a Briggs & Stratton engine that delivers the necessary torque to tackle tough mowing conditions. This engine is known for its reliability and ease of starting, ensuring that homeowners can quickly get to work without frustration. Paired with a smooth-cutting deck, the tractor can efficiently handle various grass types and terrains with ease.

The cutting deck, often sized at 42 inches, provides a wide swath, allowing users to cover substantial ground in less time. Equipped with adjustable cutting heights, the Sears 917.275223 ensures a customizable mowing experience, which is beneficial for maintaining a healthy lawn. The ease of adjustment means users can switch between different grass and lawn types without hassle.

In terms of technology, the Sears 917.275223 often features a hydrostatic transmission. This technology allows for seamless speed adjustments without the need for manual gear changes, which is particularly advantageous when navigating uneven terrain or around landscaping features. The ease of steering is complemented by comfortable controls, putting everything within easy reach for the operator.

Another notable feature of this tractor is its ergonomic design. The seat is designed for comfort during longer mowing sessions, while the overall layout promotes ease of use. The placement of the foot pedals and steering wheel ensures that operators can maneuver and control the vehicle effortlessly.

The Sears 917.275223 is also designed with durability in mind. Constructed with high-quality materials, it can withstand the rigors of frequent lawn care tasks. Additionally, maintenance is simplified for the user, with easily accessible components for oil changes, belt adjustments, and other routine tasks.

In summary, the Sears 917.275223 lawn tractor combines a powerful engine, user-friendly technology, adjustable cutting options, and durable construction, making it a favorite among homeowners looking to maintain their lawns efficiently. With its thoughtful design and reliable performance, it stands as an excellent choice for both novice and experienced users alike.