Sears 917.275223 To Replace Fuse, To Replace Headlight Bulb, To Adjust Attachment Lift Spring

Page 30

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause y tractorto run poorly,stop running, or preventit from starting.

• Check widng. See electrical wiring

diagram in the Repair Parts section,

TO REPLACE FUSE

Replace with 30 amp automotive-type plug4n fuse. The fuse holder is located behind the dash.

REPLACING BAT'rERY

_kCAUTION: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch

bands, dags, etc.

Positive terminal must be connected first to prevent sparking from ecoldental grounding.

1.Lift hood to raised position.

2.Remove terminal guard.

3.Disconnect BLACK battery cable then

RED battery cable and carefully remove battery from tractor.

4.Install new battery with terminals in same position as old battery.

5.Reinstall terminal guard.

6.First connect RED battery cable to positive (+) battery terminal with hex belt and keps nut as shown. Tighten securely.

7.Connect BLACK grounding cable to negative (-) battery terminal with remaining hex belt and keps nut.

Tighten securely

8.Close terminal access doors.

9.Close hood.

Terminal

Keps.

Hex Bolt

Access

 

 

Door

 

 

Terminal

 

(Red)

 

 

Cable

 

 

3lack)

 

 

Cable

TO REPLACE HEADLIGHT BULB

1.Raise hood.

2.Pull bulb holder out of the hole in the backside of the grill.

3.Replace bulb in holder and push bulb holder securely back into the hole In the backside of the grill.

4.Close hood.

TO ADJUST ATTACHMENT LIFT SPRING

1._Arniteholding spring bashing with wrench, loosen jam nut.

Turn adjustment bolt clockwise to extend spdng and reduce llft effort heavier attachments.

Turn adjustment bolt countemlockwi for lighter attachments.

2.Retighten jam nut against spring bushing.

IMPORTANT: Do not adjust for maxi-

mum spring tension when using light attachments such as a mower. Adjust li

lever spdng to aid in liftingattachment. Do not overpower spdng. When remo_ ing attachment, always adjust spring tension to its lowest position,

AdjustmentBolt

_ Spring

Jam Nut

TO REMOVE HOOD AND GRILL ASSEMBLY

1.Raise hood.

2.Unsnap headlight wire connector.

3.Stand in front of tractor. Grasp ho< at sides, tit+,toward e_jine and lift _. of tractor.

4.To replace, reverse above preced=.

H°°p_adlightWlm

ector

3O

Image 30
Contents Garden Tractor Limited 90 DAY Warranty on Battery Storage General OperationMow only in daylight or good artificial light I1. Slope OperationIV. Service Machine. Tall grass can hide obstaclesCancer and birth defects or other repro- ductive harm Speedmph Reverse Gasoline 3.5 GallonsAndtype Regular Repair AgreementRetainer Shoulder Bolt Steedng Sleeve SteedngWheellnse17132 x 1-3/16 x 12 Gauge Washers X 3/4 x 14 GaVideo Cassee Keys Slope Sheet Before Removing Tractor from Skid Attach Steering Wheel Tools Required for AssemblyTo Removetractor from Carton Unpack Carton Teenng Steering Wheel Adapter Sleeve Tabs ExtensionHowto SET Upyourtractor Check Battery Install SeatBolt Assemble Gaugewheelsto Mower Deck Slide mower under tractor withCheck Tire Pressure Check Mower LevelnessCheck for Proper Position of ALL Belts Charged, Minimum 1 hour at 6 amps DampedENG,NEONENO,NEOFF.LRESSUREL,OHTSOND.P T Attachment Clutch Switch KnowyourtractorLift Stopping To Adjust Mower Cutting HeightHowto Useyourtractor To SET Parking Brake Ground DriveDeflector Shield To Adjust Gauge WheelsTo Operate Mower To Operate on HillsBefore Starting the Engine Check Engine OIL Level To TransportTowing Carts and Other ATTACH- Ments ADD GasolineAutomatictransmission Warm UP Tion of clippings and more uniform cutting Lubrication Chart General RecommendationsBefore Each USE Tires TractorBrake Operation Operator Presence SystemTransaxle Cooling To Clean Battery and TerminalsBelts Transaxle Pump FluidTo Service PRE-CLEANER Clean AIR ScreenClean AIR Intakeicooling Areas To Service CartridgeSIDE-TO-SIDE Adjustment To Install MowerTo Level Mower Housing Ractor To Remove MowerFRONT-TO-BACK Adjustment Mower Drive Belt InstallationTo Replace Mower Drive Belt Mower Drive Belt Removal Electric Clutch To Replace Mower Blade Drive BeltTransaxle Motion Control Lever Neutral Adjustment To Adjust Attachment ClutchBelt Installation To Replace Motion Drive BeltTo Adjust TOE-IN To Adjust Steering Wheel ALIGN- MentFront Wheel TOE-IN Adjustment BatteryTo Replace Fuse To Adjust Attachment Lift SpringTo Remove Hood and Grill Assembly To Replace Headlight BulbTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor Preliminary SettingAdjusting screw in or out until correct idle is attained Recheck idle speed. Readjust if necessaryEngine OIL 1RACTOREngine Fuel System CyundersTroubleshooting Chart ProblemWom. bent or loose blade Mower deck not level CauseCutting too much grass/too fast Throttle in Choke position CorrectionWet grass Mower deck not level Troubleshooting Chart Problem Cause CorrectionFaulty alternator Freewheel control in disengaged position OFFTRACTOR- Model Number Schematic Electrical TRACTORMODELNUMBER917-.275223 TRACTORMODELNUMBER917-.275223 Electrical TRACTOR- MODELNUMBER917.275223 Chassisandenclosures TRACTORMODELNUMBER917-.275223 Chassisandenclosures TRACTOR- MODELNUMBER917.275223 Grounddrive KEY Part NO. NO.DESCRIPTION TRACTOR- Model Number Steering KEY pART TRACTORMODELNUMBER917-.275223 Engine TRACTOR- Model Number Seatassembly TRACTORMODELNUMBER917-.275223 Decals TRACTOR- MODELNUMBER917.275223 LiFTASSEMBLY Ili TRACTOR- Model NU Mber Mowerdeck TRACTOR- MODELNUMBER917.275223 TRANSAXLE-MODELNUMBER311.3500 Screw Cylinder Head Valvi & Breather EADNALVE/BREATHER KEY IiI 24-164-06-S ECONTROLSp KEY Part NO. NO.DESCRIPTION Crankshaft Exhaust J Fuel System Not Illustrated Page Suggested Guide for Sighting Slopes for Safe Operation Part 0o..-7278

917.275223 specifications

The Sears 917.275223 is a robust lawn tractor that has earned a reputation among homeowners for its reliable performance and durability. Designed primarily for residential use, this lawn tractor features a user-friendly design that caters to both seasoned gardeners and those new to lawn care.

One of the standout characteristics of the Sears 917.275223 is its powerful engine, typically a Briggs & Stratton engine that delivers the necessary torque to tackle tough mowing conditions. This engine is known for its reliability and ease of starting, ensuring that homeowners can quickly get to work without frustration. Paired with a smooth-cutting deck, the tractor can efficiently handle various grass types and terrains with ease.

The cutting deck, often sized at 42 inches, provides a wide swath, allowing users to cover substantial ground in less time. Equipped with adjustable cutting heights, the Sears 917.275223 ensures a customizable mowing experience, which is beneficial for maintaining a healthy lawn. The ease of adjustment means users can switch between different grass and lawn types without hassle.

In terms of technology, the Sears 917.275223 often features a hydrostatic transmission. This technology allows for seamless speed adjustments without the need for manual gear changes, which is particularly advantageous when navigating uneven terrain or around landscaping features. The ease of steering is complemented by comfortable controls, putting everything within easy reach for the operator.

Another notable feature of this tractor is its ergonomic design. The seat is designed for comfort during longer mowing sessions, while the overall layout promotes ease of use. The placement of the foot pedals and steering wheel ensures that operators can maneuver and control the vehicle effortlessly.

The Sears 917.275223 is also designed with durability in mind. Constructed with high-quality materials, it can withstand the rigors of frequent lawn care tasks. Additionally, maintenance is simplified for the user, with easily accessible components for oil changes, belt adjustments, and other routine tasks.

In summary, the Sears 917.275223 lawn tractor combines a powerful engine, user-friendly technology, adjustable cutting options, and durable construction, making it a favorite among homeowners looking to maintain their lawns efficiently. With its thoughtful design and reliable performance, it stands as an excellent choice for both novice and experienced users alike.