Sears 917.275223 To Adjust Steering Wheel ALIGN- Ment, Front Wheel TOE-IN Adjustment, Rear Wheel

Page 29

TO ADJUST STEERING WHEEL ALIGN- MENT

If steering wheel crossbars are not hodzontal (left to right) when wheels are positioned straight forward, remove steedng wheel and reassemble per instructionsin the Assembly section of this manual.

FRONT WHEEL TOE-IN ADJUSTMENT

Front wheel toe-in is required for proper steedng operation. Toe-in was set at the factory and adjustment should not be necessary. If parts in the front axle or steering mechanism have been replaced or damaged, check toe-in and adjust if

3, Repair tire and reassemble,

4.Replace washers and snap retaining ring securely in axle groove.

5.Replace axle cover,

REAR WHEEL -

1.Block rear axle securely.

2.Remove five (5) hub bolts to allow wheel removal.

3.Repair tire and reassemble. Replace and tighten hub bolts securely.

NOTE: To seal tire punctures and prevent fiat tires due to slow leaks, tire sealant may be purchased from your local parts

dealer. Tire sealant also prevents tire dry rot and corrosion.

necessary.

TO CHECK TOE-IN -

1.Position front wheels straight ahead.

2.Measure distance between wheels at front and rear of tires (dimensions "A"

and "B").

•Front dimension "A" should be 1/8" to 1/4" less than rear dimension "B".

Washers

Retaining_ .__

Ring\ I\ _1_,

Axle \ I\ m_r/fF _,_

TO ADJUST TOE-IN -

1.Loosen jam nuts at adjusteleet sleeves on tie rod.

2.Adjust tie rod until dimension "A" is 1/8" to 1/4" less than dimension "B'.

3.Tighten jam nuts securely,

FRONT WHEEL CAMBER

The front wheel camber is not adjustable on your tractor, If damage has oocurrod to affect the front wheel camber, contact your nearest authorized sewica center/ department.

;leeves

Jam Nuts

TO REMOVE WHEEL FOR REPAIRS

FRONT WHEEL-

1.Block up axle securely,

2.Remove axle cover, retaining ring and washers to allow wheel removal.

To START ENGINE WITH A WEAK

BATTERY

A

4_ICAUTION: Lead-acidbafiedesgenerate e_plosivegases. Keep sparks,flame and smotdngmaterialsawayfrom batteries. Always wear eye protectionwhenaround bettedes.

ifyourbatteryis tnoweak lo startthe engine,it slxx_ be recharged. (See "BATTERY" in _]e MAINTENANCE sectionof this manual).

If "jumpercables"are usedfor emergency sta_ng, fogow thisprocedure:

IMPORTANT: Yourt'actoris equippedwitha 12 voltnegativegroundedsystem.The other

vehicalmust also be a 12 voltnegative grounded system.Do not useyourtractor batteryto start othervehicles.

TO ATTACHJUMPER CABLES -

1, Connect each end of the RED cable to the POSITIVE (+) terminal of each battery, taking care not to short against chassis.

2.Connect one end of the BLACK cable to the NEGATIVE (-) terminal of fully charged battery.

3.Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER-

1.BLACK cable first from chassis and then from the fully charged battery.

2.RED cable last from beth batteries.

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Garden Tractor Limited 90 DAY Warranty on Battery Mow only in daylight or good artificial light General OperationStorage I1. Slope OperationMachine. Tall grass can hide obstacles IV. ServiceCancer and birth defects or other repro- ductive harm Andtype Regular Gasoline 3.5 GallonsSpeedmph Reverse Repair Agreement17132 x 1-3/16 x 12 Gauge Steedng Sleeve SteedngWheellnseRetainer Shoulder Bolt Washers X 3/4 x 14 GaVideo Cassee Keys Slope Sheet To Removetractor from Carton Unpack Carton Tools Required for AssemblyBefore Removing Tractor from Skid Attach Steering Wheel Teenng Steering Wheel Adapter Sleeve Tabs ExtensionBolt Howto SET Upyourtractor Check BatteryInstall Seat Slide mower under tractor with Assemble Gaugewheelsto Mower DeckCheck for Proper Position of ALL Belts Check Tire PressureCheck Mower Levelness Damped Charged, Minimum 1 hour at 6 ampsENG,NEONENO,NEOFF.LRESSUREL,OHTSOND.P T Lift Attachment Clutch SwitchKnowyourtractor Howto Useyourtractor To SET Parking Brake To Adjust Mower Cutting HeightStopping Ground DriveTo Operate Mower To Adjust Gauge WheelsDeflector Shield To Operate on HillsTowing Carts and Other ATTACH- Ments To TransportBefore Starting the Engine Check Engine OIL Level ADD GasolineAutomatictransmission Warm UP Tion of clippings and more uniform cutting Before Each USE Lubrication ChartGeneral Recommendations Brake Operation TractorTires Operator Presence SystemBelts To Clean Battery and TerminalsTransaxle Cooling Transaxle Pump FluidClean AIR Intakeicooling Areas Clean AIR ScreenTo Service PRE-CLEANER To Service CartridgeTo Level Mower Housing To Install MowerSIDE-TO-SIDE Adjustment Ractor To Remove MowerTo Replace Mower Drive Belt Mower Drive Belt Removal FRONT-TO-BACK AdjustmentMower Drive Belt Installation To Replace Mower Blade Drive Belt Electric ClutchBelt Installation To Adjust Attachment ClutchTransaxle Motion Control Lever Neutral Adjustment To Replace Motion Drive BeltFront Wheel TOE-IN Adjustment To Adjust Steering Wheel ALIGN- MentTo Adjust TOE-IN BatteryTo Remove Hood and Grill Assembly To Adjust Attachment Lift SpringTo Replace Fuse To Replace Headlight BulbTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control Preliminary SettingRecheck idle speed. Readjust if necessary Adjusting screw in or out until correct idle is attainedEngine Fuel System 1RACTOREngine OIL CyundersProblem Troubleshooting ChartCutting too much grass/too fast Throttle in Choke position CauseWom. bent or loose blade Mower deck not level CorrectionFaulty alternator Freewheel control in disengaged position Troubleshooting Chart Problem Cause CorrectionWet grass Mower deck not level OFFTRACTOR- Model Number Schematic Electrical TRACTORMODELNUMBER917-.275223 TRACTORMODELNUMBER917-.275223 Electrical TRACTOR- MODELNUMBER917.275223 Chassisandenclosures TRACTORMODELNUMBER917-.275223 Chassisandenclosures TRACTOR- MODELNUMBER917.275223 Grounddrive KEY Part NO. NO.DESCRIPTION TRACTOR- Model Number Steering KEY pART TRACTORMODELNUMBER917-.275223 Engine TRACTOR- Model Number Seatassembly TRACTORMODELNUMBER917-.275223 Decals TRACTOR- MODELNUMBER917.275223 LiFTASSEMBLY Ili TRACTOR- Model NU Mber Mowerdeck TRACTOR- MODELNUMBER917.275223 TRANSAXLE-MODELNUMBER311.3500 Screw Cylinder Head Valvi & Breather EADNALVE/BREATHER KEY IiI 24-164-06-S ECONTROLSp KEY Part NO. NO.DESCRIPTION Crankshaft Exhaust J Fuel System Not Illustrated Page Suggested Guide for Sighting Slopes for Safe Operation 0o..-7278 Part

917.275223 specifications

The Sears 917.275223 is a robust lawn tractor that has earned a reputation among homeowners for its reliable performance and durability. Designed primarily for residential use, this lawn tractor features a user-friendly design that caters to both seasoned gardeners and those new to lawn care.

One of the standout characteristics of the Sears 917.275223 is its powerful engine, typically a Briggs & Stratton engine that delivers the necessary torque to tackle tough mowing conditions. This engine is known for its reliability and ease of starting, ensuring that homeowners can quickly get to work without frustration. Paired with a smooth-cutting deck, the tractor can efficiently handle various grass types and terrains with ease.

The cutting deck, often sized at 42 inches, provides a wide swath, allowing users to cover substantial ground in less time. Equipped with adjustable cutting heights, the Sears 917.275223 ensures a customizable mowing experience, which is beneficial for maintaining a healthy lawn. The ease of adjustment means users can switch between different grass and lawn types without hassle.

In terms of technology, the Sears 917.275223 often features a hydrostatic transmission. This technology allows for seamless speed adjustments without the need for manual gear changes, which is particularly advantageous when navigating uneven terrain or around landscaping features. The ease of steering is complemented by comfortable controls, putting everything within easy reach for the operator.

Another notable feature of this tractor is its ergonomic design. The seat is designed for comfort during longer mowing sessions, while the overall layout promotes ease of use. The placement of the foot pedals and steering wheel ensures that operators can maneuver and control the vehicle effortlessly.

The Sears 917.275223 is also designed with durability in mind. Constructed with high-quality materials, it can withstand the rigors of frequent lawn care tasks. Additionally, maintenance is simplified for the user, with easily accessible components for oil changes, belt adjustments, and other routine tasks.

In summary, the Sears 917.275223 lawn tractor combines a powerful engine, user-friendly technology, adjustable cutting options, and durable construction, making it a favorite among homeowners looking to maintain their lawns efficiently. With its thoughtful design and reliable performance, it stands as an excellent choice for both novice and experienced users alike.
Top Page Image Contents