Sears 917.257462 manual Lawn Rider, To Remove Mower See Fig, To Install Mower See Fig

Page 18

SERVICE AND ADJUSTMENTS

CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

Depress clutch/brake pedal fully and set parking brake.

iPlace gearshift lever in "NEUTRAL" position.

Place attachment clutch in "DISENGAGED position.

•Turn Ignition key "OFF" and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

LAWN RIDER

TO REMOVE MOWER (See Fig. 21)

Mower will be easier to remove from the right side of unit.

•Park tractor on a level surface and engage parking brake.

•Remove key from ignition.

•Be sure that mower clutch lever is in "DISENGAGED" position.

•Lower mower deck to lowest cutting position.

•Remove retainer spring and washer that holds mower clutch spring to the mower clutch arm.

•Disconnect mower clutch spring from mower clutch arm.

•Remove retainer springs and washers from mower stabilizer link.

•Remove retainer springs and washers from rear lift links.

•Remove retainer spring and washer from front lift link.

•Withdraw front lifts links, rear lift links and mower stabilizer link from axle brackets.

•Remove belt from engine pulley.

•Raise mower lift handle to transport position.

•Turn front tires to left.

•Slide mower deck out on right side of tractor.

 

 

AXLE

 

MOWER

BRACKET

 

CLUTCH

ENGINE

 

 

PULLEY

MOWER

 

RETAINER

CLUTCH

 

SPRING

SPRING

BELT

 

MOWER

STABlUZER

UNK

REAR UFT

LINKS

FRONT LIFT UNK

TO INSTALL MOWER (See Fig. 21)

•Reverse removal instructions.

MOWER UPSTOP ADJUSTMENT (See Fig. 22)

•Raise mower lift lever to highest (transport) position.

•Measure distance from top of mower deck to lower flange of chassis (dim. "A").

•Dim. "A" should be 3-3/8 to 3-1/2 inches.

To adjust dim. "A", if required, lower mower to lowest position. Remove washer and retainer spring in trun- nion, then withdraw trunnion pin from bracket. Loosen lower trunnion Iocknut and rotate trunnion counter- clockwise on lift link to increase dim. "A" or clockwise on lift link to decrease dim. "A".

•Tighten lower trunnion Iocknut.

NOTE: Each full turn of trunnion will change dim. "A" by 1/16 inch. Re-insert trunnion into bracket with pin pointing to L.H. side of unit. Re-install washer and retainer spring.

•Raise lift lever to highest position and recheck dim. "A". Repeat adjustment if necessary.

LOWER FLANGE

TOP OF MOWER DECK

RETAINER SPRING

WASHER

BRACKET

FRONT UFT TRUNNION

FIG. 22

FIG. 21

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Sears HP Electric Start 36 Mower Speed Lawn RiderII. Slope Operation Safety is InvolvedSafe Operation Practices for Ride-On Mowers III. ChildrenMaintenance Agreement Product SpecificationsFull 90 DAY Warranty on Battery Customer ResponsibilitiesPerformance MaintenanceEngine Sparkplug Muffler AIR Filter Stabilizer Blades BeltsTable of Contents Contents of Hardware Pack Before Rolling Unit OFF Skid Tools Required for AssemblyTo Remove Unit from Carton Unpack CartonAssembly HOW to SET UP Your TractorChecklist All assembly instructions have been completedOperation Know Your Lawn RiderSee Figs To USE Throttle Control See FigTo Move Forward and Backward To SET Parking Brake See FigTo Operate Mower See Figs To Adjust Mower Cutting HeightBefore Starting the Engine To TransportImportant When Operating in Temperatures Mowing TipsADD Gasoline General Recommendations MaintenanceLubrication Chart Before Each USEBlade Removal See Fig Lawn RiderBlade Care Brake OperationAIR Filter See Fig To Clean Battery and TerminalsEngine Transaxle CoolingMuffler CleaningAIR Screen See Fig Spark PlugsLawn Rider To Install Mower See FigMower Upstop Adjustment See Fig To Remove Mower See FigService and Adjustments To Level Mower Housing See FigViewed from Front of Tractor Keeper To Adjust Brake See FigTo Adjust Steering Wheel Alignment To Replace Motion Drive Belt See FigTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigTo Remove Hood See FIG To Replace FusePreliminary Setting To Adjust Carburetor See FigTo Adjust Throttle Control Cable EngineTractor BatteryOther Fuel SystemTroubleshooting Points Problem Cause CorrectionProblem Cause CorrectionSchematic KEY Part Description NO. no Wheels TiresDecals USAElectrical Electrical KEY Part DescriptionStandard Hardware - Purchase Locally Hood UNCStandard Hardware - Purchase Locally Frame 129965 Case, BatteryFender / Chassis 19132012 WasherSeat Locknut, Hex, Larg, Flange1011 DashStandard Hardware Purchase Locally Steering Wheel KEY Part NO. no DescriptionLower, Steering Sector Gear / Axle Support Link, DragBolt, Hex 25/32 x 1-5/8 x 16 Gauge Front AxleCap, Spindle Standard Hardware Purchase Locally122504X Brake / Rear Mower Lift AssemblyKEY Hardware Shown LargerEngine / Throttle Standard Hardware PurchaseArm, Ground Drive Clutch Ground DriveKeeper, Ground Drive Belt, Idler Idler, Flat2530 TransaxlePulley 106932X Mower Lift LeverClip, Fuel Line STD560907Mower Deck Mower Deck FOOTE/DANA Transaxle Model Number 2631 2732FOOTE/DANA TRANSAXLE- Model Number 3O7 Briggs & Stratton Engine Model Number 283707, Type Number265 219 422224 138 445 66S42.1 310 80193805 490450399265 Bearing, Cylinder Requires Special 224061 391086635 66538 Mounting224546 Sighting Guide Only Ride UP and Down HILL, not Across Hill Sight and Hold this Level with SKY Line or TreeMAX HOW to Order Repair Parts Model Number 917,25746219.91

917.257462 specifications

The Sears 917.257462 is a well-known lawn tractor that has earned a reputation for its reliable performance and robust build. Designed for homeowners with medium to large yards, this model combines functionality and ease of use, making it an excellent choice for both novice and experienced gardeners.

One of the standout features of the Sears 917.257462 is its powerful engine. Equipped with a reliable, air-cooled, four-stroke engine, it offers ample horsepower to handle various mowing tasks. The engine's efficient design ensures that it provides consistent power while maintaining fuel economy, allowing owners to tackle extensive lawn areas without frequent refueling.

The cutting system of the Sears 917.257462 is designed for efficiency and versatility. It boasts a durable, reinforced mowing deck that allows for multiple cutting heights, accommodating different grass types and lawn conditions. This adaptability makes it easy to achieve a clean, even cut, regardless of the lawn's terrain. Additionally, the tractor features a bagging system that aids in collecting grass clippings for a tidy finish.

Ergonomics play a crucial role in the design of the Sears 917.257462. The operator's seat is adjustable, providing comfort and promoting good posture during extended use. The steering system is responsive, facilitating easy maneuverability around obstacles in the yard. The controls are intuitively placed, making it simple for users to operate the tractor while focusing on the task at hand.

Another key characteristic of this tractor is its durability. Constructed with high-quality materials, the Sears 917.257462 is built to withstand the rigors of regular use. Its robust frame and fortified components contribute to its longevity, minimizing the need for frequent repairs or replacements.

Furthermore, the tractor’s maintenance requirements are straightforward. Users will find that routine upkeep is manageable, thanks to accessible engine compartments and clear instructions for oil changes and blade sharpening. This ease of maintenance not only saves time but also contributes to the tractor's overall longevity.

In summary, the Sears 917.257462 is a formidable lawn tractor that combines a powerful engine, versatile cutting capabilities, ergonomic design, and durable construction. Its user-friendly features, coupled with low maintenance requirements, make it an ideal choice for those looking to maintain their lawns with efficiency and ease. Whether grooming a small yard or tackling larger landscapes, this model remains a reliable partner in lawn care.
Top Page Image Contents