Troy-Bilt 30331 manual Assembly, Unpack Generator, Shipment Contents, Install Wheel Kit

Page 7

Assembly

Read entire operator’s manual before you attempt to assemble or operate your new generator.

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended fuel and oil level is verified.

If you have any problems with the assembly of your generator, please call the generator helpline at

(888)611-6708. If calling for assistance, please have the model, revision, and serial number from the data tag available. See Features and Controls for data tag location.

Unpack Generator

1.Set the carton on a rigid, flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top to bottom.

4.Leave generator on carton to install wheel kit.

Shipment Contents

The generator is supplied with:

•Engine oil bottle

•Operator’s manual

•Adapter cord set

•Wheel kit

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use.

You will need the following tools to install these components:

•13 mm wrench

•Socket wrench with a 13 mm socket

•Pliers

•Safety glasses

Install the wheel kit as follows:

1.Tip generator so that engine end is up.

2.Slide axle (A) through both mounting brackets.

3.Place a wheel (B) on each side as shown.

 

 

 

2a

 

 

 

B

 

 

 

A

 

 

 

C

 

F

A

 

 

 

 

E

 

B

D

 

 

 

G

 

 

4.Place a washer (C) on axle and then place an e-ring (D) in axle groove.

5.Install e-ring with pliers, squeezing from top of e-ring to bottom of axle.

CAUTION

E-rings can cause eye injury.

E-rings can spring back and become airborne when installing or removing.

•Always wear eye protection when installing/removing e-rings.

6.Repeat steps 4 and 5 to secure second wheel.

7.Tip generator so that engine side is down.

8.Line up holes in support leg (E) with holes in generator frame.

9.Attach support leg using two short capscrews (M8 x 16 mm) (F) and two locking hex nuts (G). Tighten with a 13 mm socket and wrench.

10.Return generator to normal operating position (resting on wheels and support leg).

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Questions? Help is just a moment away Failure to read and followCall Generator Helpline Engine Where to Find Us GeneratorDate Purchased Table of Contents Safety alert symbol is used with a signal word Operator SafetySafety Rules Hazard Symbols and MeaningsBroken bones, fractures, bruises, or sprains could result Engine exhaust from this product containsContact with muffler area can result in serious burns When Testing for Engine SparkUnintentional sparking can result in fire or electric shock Unpack Generator AssemblyShipment Contents Install Wheel KitFuel must meet these requirements Add Engine OilAdd Fuel Replace oil fill cap and fully tightenSpecial Requirements Connecting to a Building’s Electrical SystemSystem Ground Generator LocationOil Drain Plug Drain engine oil here Features and ControlsUsed to supply electrical power for the operation Volt AC, 20 Amp, Duplex Receptacles May beVolt AC, 20 Amp, Duplex Receptacles Cord Sets and ReceptaclesGenerator Adapter Cord Set Property damageStarting the Engine OperationStopping the Engine Connecting Electrical LoadsMove fuel valve to Off position Wattage Reference Guide Don’t Overload GeneratorMaintenance Schedule MaintenanceGenerator Maintenance Oil Engine MaintenanceService Spark Arrester Service Air CleanerService Spark Plug Install spark plug and tighten firmlyAir Cooling System Carburetor AdjustmentStorage Troubleshooting Owner’s Warranty Responsibilities Emissions Control System WarrantyClaims and Coverage Exclusions MaintenanceTROY-BILT Portable Generator Owner Warranty Policy Common Service Parts Product Specifications888 Llame Línea directa del generador Preguntas? La ayuda es justa un momento lejosMotor Dónde encontrarnos GeneradorFecha de compra Controles y características Resolución de problemas GarantíasSeguridad de Operario MontajeSímbolos de peligro y sus significados Seguridad de operarioDescripción del equipo Reglas de seguridadCuando Transporte O Repare EL Equipo Cuando Anada Combustible O Vacíe EL DepósitoCuando Ponga EN Funcionamiento EL Equipo Cuando Opere EL EquipoCuando Pruebe LA Bujía DEL Motor Cuando Ajuste O Haga Reparaciones a SU Máquina GeneradorInstale el juego de ruedas MontajeDesembalaje del generador Contenido de la cajaGran altitud Agregar aceite al motorAgregue combustible El combustible debe reunir los siguientes requisitosRequisitos especiales Tierra del sistemaConexión al sistema eléctrico de un edificio Ubicación del generadorControles y características Juego de cables del adaptador del generador Juegos de cordones y enchufes conectoresTomas eléctricas dobles de 120 V CA y 20 a Amps o mayoresEncienda el motor OperandoGire la válvula de combustible blanca hasta la posición Off Conexión de cargas eléctricasParada del motor El motor podría petardear, incendiarse o dañarseControl de la energía No sobrecargar el generadorCapacidad EjemploPlan de mantenimiento MantenimientoMantenimiento del Generador Adición de Aceite del Motor Mantenimiento del MotorAceite Recomendaciones sobre el aceite Comprobación del Nivel de AceiteLimpie la Pantalla Apagachispas Servicio del depurador de aireLimpia B Servicio del bujíaSistema de refrigeración de aire Limpie e inspeccione el apagachispas de la siguiente maneraAjuste del Carburador Almacenamiento Problemo Causa Accion Resolución de problemasResponsabilidades de la garantía del propietario Garantía del sistema de control de emisionesServicio gratuito Política Para EL Propietario DE Generador Portátil TROY-BILT Servicio común despide Especificaciones del producto

30331 specifications

The Troy-Bilt 30331 is a powerhouse in the world of lawn care, combining advanced technology with user-friendly features to enhance the mowing experience. Designed for homeowners who prioritize efficiency and performance, this lawn mower is packed with features that make lawn maintenance easier and more enjoyable.

One of the standout characteristics of the Troy-Bilt 30331 is its powerful 382cc OHV engine. This engine delivers ample power and torque, making it efficient at tackling tough grass and uneven terrain. The engine is designed for durability and reliability, ensuring that homeowners can depend on it for years of high-quality lawn care.

A key feature of the Troy-Bilt 30331 is its 21-inch cutting deck, which provides a perfect balance between agility and coverage. The cutting deck is equipped with an adjustable height setting, allowing users to choose their desired grass length, ensuring that lawns look pristine after every mow. The mower also utilizes a tri-action system that allows for superior mulching, bagging, and side discharge functionalities. This versatility not only enhances the aesthetics of your lawn but also contributes to overall lawn health.

User comfort and convenience are top priorities in the design of the Troy-Bilt 30331. It comes with ergonomic handles that reduce fatigue during extended use, and its self-propulsion feature allows users to maintain control while effortlessly navigating various terrains. This feature is especially beneficial for those with larger yards or hilly landscapes.

Another innovative technology incorporated in the Troy-Bilt 30331 is its easy-start system. This feature simplifies the starting process, allowing users to get to work quickly without the hassle of traditional pull-start methods. The mower also includes large rear wheels that provide excellent traction and maneuverability, making it easier to handle tight corners and navigate around obstacles.

Maintenance of the Troy-Bilt 30331 is straightforward, thanks to its accessible design. The cutting blade can be easily removed and sharpened or replaced, and the engine is equipped with a quick oil-change system to keep it running smoothly. With proper care, users can expect longevity and performance from this reliable lawn mower.

In summary, the Troy-Bilt 30331 is an impressive lawn mower that excels in performance, versatility, and user comfort. With its powerful engine, adjustable cutting deck, ergonomic design, and convenient features, it stands out as an excellent choice for homeowners seeking a dependable and efficient mowing solution.
Top Page Image Contents