Troy-Bilt Colt RZT warranty Deck Height Index, Deck Lift Handle, RH and LH Drive Control Levers

Controls and Features

N

C

M

L

F

K

4

B

AC

D

E

J

F

G

H

Figure 4-1

A.Deck Height Index

B.Deck Lift Handle

C.RH and LH Drive Control Levers

D.Ignition Switch

E.PTO Switch

F.Transmission Bypass Rod (Not Shown)

G.Cup Holder

NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that position on the tractor when facing forward while seated in the operator’s seat.

A. Deck Height Index

The deck height index consists of six index notches located on the front/right of the seat box frame. Each notch corresponds to a 1/2 inch change in the deck height position ranging from 1-1/2 inches at the lowest notch to 4 inches at the highest notch.

B. Deck Lift Handle

The deck lift handle is located on the front/right of the seat box frame, and is used to raise and lower the mower deck.

H. Storage Tray

J.Seat Adjustment Lever (Not Visible)

K.Fuel Tank Cap

L.Hour Meter/Indicator Panel

M.Throttle Control

N.Parking Brake Engagement Lever

Pull the handle to the left out of the index notch and push downward to lower the deck, or pull upward to raise the deck. When the desired height is attained, move the lift handle to the right until fully in the index notch.

C. RH and LH Drive Control Levers

The RH and LH control levers are located on each side of the operator’s seat. These hinged levers pivot outward to open space to permit the operator to either sit in the tractor seat, or to dismount the tractor. The levers must be fully opened out and in the neutral position to start the tractor engine.

10