1.Install chain shielding plate (3) to rear mower frame as shown.
2.Secure with carriage bolts (14) and flanged lock nuts (15).
3.Insert carriage bolts from bottom upward as shown.
1.1/4 Pin
2.
3.Shield, chain plate
4.Sleeve 1/2 x 3/4 x 1/2
5.3/8 NC x
6.3/8 NC Flanged lock nut
Figure 19. Chain Shielding Installation
Hydraulic Latch Release Installation
1. | Release base | 8. | Bushing |
2. | Release slide | 9. | Elbow |
3. | Cylinder | 10. | Hose, 108” |
4. | Spring | 11. | Vent plug |
5. | Pin, 1 x 4.08 | 12. | Flat washer, 1” |
6. | Pin, 1 x 5.08 | 13. | Washer, |
7. | Cotter pin |
| 1 x |
|
|
|
|
1.Remove rope lever from the top of front latch.
2.Remove plugs from front and rear ports on cylinder and extend cylinder rod.
3.Install vent plug (11) in port near rod end.
4.Place release slide (2) over clevis on rod end of cylinder (3) and secure using pin (5) and two cotter pins (7).
5.Attach base end of cylinder to release base (1) using pin (6) and cotter pins (7).
6.Extend cylinder and align release slide (2) with release base (1). Insert pin (6), two washers (13) and secure using two flat washers (12) cotter pins
(7) on the out side.
7.Attach springs (4) between base (1) and slide (2).
8.Install bushing (8) and elbow (9) into port at base of cylinder.
9.Remove the four bolts and washers from the top of gearbox shield.
10.Place latch assembly over gearbox shield, align holes and secure using the hardware previously removed.
11.Remove latch rope from between front latch and tractor.
12.Attach hydraulic hose (10) to elbow (9). Attach male quick coupler to opposite end of hose. NOTE: quick coupler is not included in this kit.
Figure 20. Hydraulic Latch Release Installation | Figure 21. Latch Release to Trailer Connection |
(Rev. 2/6/2009) MAN0765 (12/5/2008)