Woods Equipment TBW150C manual Storage

SAFETY RULES

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!

(Safety Rules continued from previous page)

„Tighten all bolts, nuts, and screws to torque chart specifications. Check that all cotter pins are installed securely to ensure equipment is in a safe condition before putting unit into service.

„Make sure all safety decals are installed. Replace if damaged. (See Safety Decals section for location.)

„Make sure shields and guards are properly installed and in good condition. Replace if dam- aged.

„Do not disconnect hydraulic lines until engine is stopped, power unit is properly secured, equip- ment and all components are lowered to the ground, and system pressure is released by oper- ating all valve control levers.

„When lubricating telescoping PTO drives, keep fingers out of shield access slots to prevent injury.

„Wear gloves when installing belt. Be careful to prevent fingers from being caught between belt and pulley.

„Use care when installing or removing belt from spring-loaded idler. Springs store energy when extended and, if released suddenly, can cause per- sonal injury.

STORAGE

„Block equipment securely for storage.

„Keep children and bystanders away from stor- age area.

™

8Safety

TBW Safety Rules (Rev.12/5/2008)