DEALER CHECK LISTS
PRE-DELIVERY CHECK LIST (DEALER’S RESPONSIBILITY)
Inspect the equipment thoroughly after assembly to ensure it is set up properly before delivering it to the customer.
The following check lists are a reminder of points to inspect. Check off each item as it is found satisfactory or after proper adjustment is made.
___ Check that all safety decals are installed and in good condition. Replace if damaged.
___ Check that shields and guards are properly installed and in good condition. Replace if dam-
| aged. |
___ | Check all bolts to be sure they are properly |
| torqued. |
___ | Check that all cotter pins and safety pins are |
| properly installed. Replace if damaged. |
___ | Check that blades have been properly installed. |
___ | Check mower attitude and belt alignment |
___ | Check and grease all lubrication points as identi- |
| fied in lubrication information on page 18. |
___ | Check the level of gearbox fluids before delivery. |
| Service, if required, as specified in the lubrication |
| information on page 18. |
DELIVERY CHECK (DEALER’S RESPONSIBILITY)
___ | Show customer how to make adjustments and |
| select proper PTO speed. |
___ | Show customer how to make sure driveline is |
| properly installed and that |
| ing pin or collar slides freely and is seated in |
| groove on tractor PTO shaft. |
___ | Show customer how to determine the turning lim- |
| its of the CV PTO driveline. |
___ | Show customer the safe, proper procedures to be |
| used when mounting, dismounting, and storing |
| equipment. |
___ | Make customer aware of optional equipment |
| available so that customer can make proper |
| choices as required. |
___ | Instruct customer how to lubricate and explain |
| importance of lubrication. |
___ | Point out the safety decals. Explain their meaning |
| and the need to keep them in place and in good |
| condition. Emphasize the increased safety haz- |
| ards when instructions are not followed. |
___ Present Operator's Manual and request that cus- tomer and all operators read it before operating equipment. Point out the manual safety rules, explain their meanings and emphasize the increased safety hazards that exist when safety rules are not followed.
___ Explain to customer the potential crushing haz-
ards of going underneath raised equipment.
___ Point out all guards and shields. Explain their importance and the safety hazards that exist when not kept in place and in good condition.
MAN0765 (12/5/2008) | Dealer Check List 33 |
|
|