Woods Equipment TBW150C manual Safety & Instructional Decals, Be Careful

Page 9

SAFETY & INSTRUCTIONAL DECALS

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!

Replace Immediately If Damaged!

1 - 1002940 YELLOW FRONT REFLECTOR

2 - 57123 RED REAR REFLECTOR

4 - 18864

DANGER

ROTATING DRIVELINE

CONTACT CAN CAUSE DEATH

KEEP AWAY!

DO NOT OPERATE WITHOUT-

ALL DRIVELINE GUARDS, TRACTOR AND EQUIPMENT SHIELDS IN PLACE DRIVELINES SECURELY ATTACHED AT

￿BOTH ENDS

DRIVELINE GUARDS THAT TURN FREELY

ON DRIVELINE

18864B

 

3 - 15503

DANGER

ROTATING BLADES AND

THROWN OBJECTS

Do not put hands or feet under or into mower when engine is running.

Before mowing, clear area of objects that may be thrown by blade.

Keep bystanders away.

Keep guards in place and in good condition.

BLADE CONTACT OR THROWN OBJECTS CAN CAUSE SERIOUS INJURY OR DEATH.

15503-C

BE CAREFUL!

Use a clean, damp cloth to clean safety decals.

Avoid spraying too close to decals when using a pressure washer; high-pressure water can enter through very small scratches or under edges of decals causing them to peel or come off.

Replacement safety decals can be ordered free from your Woods dealer. To locate your nearest dealer, check the Dealer Locator at www.WoodsEquipment.com, or in the United States and Canada call 1-800-319-6637.

MAN0765 (12/5/2008)

Safety 9

 

 

Image 9
Contents Turf Batwing To the Dealer IntroductionSpecifications Table of ContentsGeneral Information Safety Rules SafetyTraining PreparationOperation TransportationMaintenance Storage Be Careful Safety & Instructional DecalsShield Missing Rotating Blades Thrown Objects 33347E Operation OperationAttaching Mower to Tractor Attaching Hydraulic Hoses Cutting Height AdjustmentInterference Check CV Driveline Turning LimitsTransport Starting and Stopping MowerOperating Operating Tips Operating TechniqueUneven Terrain Removing Mower from TractorCheck that all shields and guards are properly Owner Service Owner ServiceLubrication Information Description Frequency Blade Servicing Belt ServicingChain Shielding Blade InstallationCleaning TroubleshootingAfter Each Use Periodically or Before Extended StorageBelt Conditions Dealer Service Dealer ServiceBlade Spindle Repair Seal Installation Seal ReplacementVertical Shaft Seal Replacement Horizontal Shaft Seal ReplacementRemove Gearbox from Mower Disassemble GearboxReassemble Gearbox Gearbox Assembly Install Drive Sheave Install GearboxJoint Disassembly Universal Joint RepairJoint Assembly Assembly Instructions AssemblyDealer SET-UP Instructions Optional EquipmentChain Shielding Installation Hydraulic Latch Release InstallationMulch Kit Installation Mulch Kit InstallationDealer Check Lists Dealer Check ListPRE-DELIVERY Check List DEALER’S Responsibility Delivery Check DEALER’S ResponsibilityDealer Check List Parts Parts IndexMain Frame Assembly Part QTY Description Main Frame Assembly Parts ListDeck Assembly Gearbox see Deck Assembly Parts ListTrailer Assembly Gearbox Assembly Blade & Spindle Assembly Wing Driveline Assembly REF Part QTY Description Rear Driveline AssemblyHUB & Axle Assembly CV Driveshaft AssemblyCaster Wheel Assembly Hydraulic Cylinder Hydraulic Release KIT Optional Rear Chain Shielding OptionalMulch KIT Optional SAE Series Torque Chart Bolt Torque ChartAppendix Metric SeriesAbbreviations Bolt Size ChartIndex IndexWarranty Warranty