Woods Equipment RB850-4, RB750-4 manual Tilt Adjustment, Offset Swing

TILT ADJUSTMENT

1.	Tilt Lock Pin
	CD5980-1	1

Figure 4. Mechanical Configuration - Tilt

Mechanical

The blade may be tilted 15 and 30 degrees up and down.

To tilt blade:

1.Remove tilt lock pin (1),

2.Rotate the blade to the desired position, and

3.Replace the pin.

NOTE: Additional tilting may be obtained by adjusting the draft links of the 3-point hitch.

4. Hyd Cylinder 3.5 x 1.25 x 8
5. Hyd Cylinder 3.5 x 1.5 x 16
	5
	Swing
	1
Angle	CD5999-1
5
4	Tilt

Figure 5. Hydraulic Configuration - Tilt

Hydraulic

The blade may be tilted 22 degrees up or down and to any position in between.

To prevent damage to the blade and hydraulic cylinder, do not use lock pin (1, Figure 4).

NOTE: In some cases it may not be possible to fully tilt and angle and still be able to raise the blade high enough to clear the ground. In this case, use less tilt.

NOTE: It is possible for the blade to contact other com- ponents if the blade is tilted when angled. Operate blade slowly when angling blade.

OFFSET (SWING)

Mechanical Adjustment

The blade may be offset 12" (305 mm) and 24" (610 mm), either side from the center position.

To offset the blade:

1.Park the tractor on level ground.

2.Apply parking brake and raise blade 2" (51 mm) above the ground.

3.Shut off the engine and level the boom.

4.Remove safety pin (10) and lock pin (16), swing the boom to the desired position and replace the pins.

10.	3/16 Safety Pin
16.	Lock Pin
	10
	16
	CD5980-1

Figure 6. Mechanical Configuration - Offset

Adjustment with Hydraulic Swing Cylinder

The swing cylinder rotates the boom 30 degrees right or left or to any position in between, resulting in a max- imum of 24" (610 mm) offset to right or left.

MAN0160 (Rev. 2/22/2006) Operation 11