Woods Equipment RB850-4, RB750-4 Install End Plate Kit 22658 Optional, PRE-DELIVERY Check List

Install End Plate Kit 22658 (Optional)

1.Attach end plates (3) to each end of blade assem- bly. Use two carriage bolts (4) and flanged lock nuts

(5) to each plate.

2.Torque to 85 lbs.-ft (115 N-m).

3.Plate, End

4.Bolt, Carriage 1/2 NC x 1-1/4 GR5

5.Nut, Flanged Lock 1/2 NC

	3
4	CD5856
	5

Figure 32. End Plate Installation

PRE-DELIVERY CHECK LIST

(DEALER’S RESPONSIBILITY)

Inspect the equipment thoroughly after assembly to ensure it is set up properly before delivering it to the customer.

The following check lists are a reminder of points to inspect. Check off each item as it is found satisfactory or after proper adjustment is made.

___ Check that all safety decals are installed and in good condition. Replace if damaged.

___ Check all bolts to be sure they are properly torqued.

___ Check that all cotter pins and safety pins are properly installed. Replace if damaged.

___ Check and grease all lubrication points.

DELIVERY CHECK LIST

(DEALER’S RESPONSIBILITY)

___	Show customer how to make adjustments.
___	Point out the safety decals. Explain their mean-
	ing and the need to keep them in place and in
	good condition. Emphasize the increased safety
	hazards when instructions are not followed.
___	Instruct customer how to lubricate and explain
	importance of lubrication.
___	Present Operator's Manual and request that
	customer and all operators read it before oper-
	ating equipment. Point out the manual safety
	rules, explain their meanings and emphasize
	the increased safety hazards that exist when
	safety rules are not followed.
___	Explain to customer that when equipment is
	transported on a road or highway, a Slow Mov-
	ing Vehicle (SMV) sign should be used to pro-
	vide adequate warning to operators of other
	vehicles.

MAN0160 (Rev. 2/22/2006) Assembly 29