Woods Equipment RB750-4, RB850-4 manual Transportation, Maintenance, Storage

Page 6

SAFETY RULES

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!

(Safety Rules continued from previous page)

„Never allow riders on power unit or attachment.

„Power unit must be equipped with ROPS or ROPS cab and seat belt. Keep seat belt securely fastened. Falling off power unit can result in death from being run over or crushed. Keep foldable ROPS systems in “locked up” position at all times.

„Always sit in power unit seat when operating controls or starting engine. Securely fasten seat belt, place transmission in neutral, engage brake, and ensure all other controls are disengaged before starting power unit engine.

„Look down and to the rear and make sure area is clear before operating in reverse.

„Do not operate on steep slopes.

„Do not stop, start, or change directions sud- denly on slopes.

„Use extreme care and reduce ground speed on slopes and rough terrain.

„Watch for hidden hazards on the terrain during operation.

„Stop power unit and equipment immediately upon striking an obstruction. Turn off engine, remove key, inspect, and repair any damage before resuming operation.

„Before changing positions of manual swing, tilt, or angle positions:

•Park tractor on level ground, apply parking brake, level implement boom, shut off tractor, and remove key.

•Make manual changes slowly and carefully to prevent hazardous movement of mecha- nisms.

•Never stand in positions where you could become entrapped during adjustment changes or if the 3-point hitch suddenly lowers.

„Always secure lock pins with safety pins to pre- vent lock pins from bumping out of the positioning holes. Failure to do so may result in accidents and/ or damage to blade.

TRANSPORTATION

„Before transporting, pivot the unit so red reflec- tors face the rear.

„Always comply with all state and local lighting and marking requirements.

„Never allow riders on power unit or attachment.

„Do not operate or transport on steep slopes.

„Do not operate or transport equipment while under the influence of alcohol or drugs.

MAINTENANCE

„Before dismounting power unit or performing any service or maintenance, follow these steps: disengage power to equipment, lower the 3-point hitch and all raised components to the ground, operate valve levers to release any hydraulic pres- sure, set parking brake, stop engine, remove key, and unfasten seat belt.

„Before working underneath, read manual instructions, securely block up, and check stability. Secure blocking prevents equipment from drop- ping due to hydraulic leak down, hydraulic system failure, or mechanical component failure.

„Always wear relatively tight and belted clothing to avoid entanglement in moving parts. Wear sturdy, rough-soled work shoes and protective equipment for eyes, hair, hands, hearing, and head.

„Do not modify or alter or permit anyone else to modify or alter the equipment or any of its compo- nents in any way.

„Make sure attachment is properly secured, adjusted, and in good operating condition.

„Never perform service or maintenance with engine running.

„Keep all persons away from operator control area while performing adjustments, service, or maintenance.

„Tighten all bolts, nuts and screws to torque chart specifications. Check that all cotter pins are installed securely to ensure equipment is in a safe condition before putting unit into service.

„Make sure all safety decals are installed. Replace if damaged. (See Safety Decals section for location.)

„Do not disconnect hydraulic lines until machine is securely blocked or placed in lowest position and system pressure is released by operating valve levers.

STORAGE

„Secure equipment parking stand(s) in park posi- tion before detaching.

„Keep children and bystanders away from stor- age area.

6Safety

RB750/850-4 SR (Rev. 2/22/2006)

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Rear Blades Introduction Table of Contents General InformationRB750-4 & RB850-4 Specifications ModelTraining Safety RulesPreparation OperationMaintenance TransportationStorage Safety & Instructional Decals Replace Immediately If DamagedBe Careful Crushing Pinching HazardOperation Mount Blade to TractorBlade Angle Adjustment Reverse BladeTilt Adjustment Offset SwingBackfilling Leveling and GradingPRE-OPERATION Check List Bolts CleaningLubrication Blade Cutting EdgeAssembly Assembly Table of ContentsDealer SET-UP Instructions Main Assembly All Models Attach Blade to Pivot Assembly Attach Boom to Pivot AssemblyInstall Manual Tube Attach A-FrameInstall Slow Moving Vehicle Sign Refer to FigureModels M & MT Install Offset Linkage Manual ConfigurationAngle Kit Installation Models MT & TA Install Hydraulic Tilt Kit Tilt Kit Installation with Manual Angle ControlModel TA Install Hydraulic Tilt Kit Hydraulic Tilt and Angle Kit Hose RoutingOffset Angle Model H Install Hydraulic Cylinders OffsetInstall Relief Valves and Hoses OffsetInstall Selector Valve Kit 1004873 Optional Selector ValveInstall Selector Valve Kit Optional Cont’d Handle Kit Installed Route hoses as shown in FigureInstall Pneumatic Tailwheel 28775 Optional Optional Equipment ALL ModelsInstall Skid Shoe Kit 18296 Optional Skid Shoe InstallationInstall End Plate Kit 22658 Optional PRE-DELIVERY Check ListDelivery Check List Assembly Parts Index Rear Blades RB750-4 RB850-4 Main Assembly RB750-4 RB850-4 Main Assembly Parts List Part QTY DescriptionRB750-4 RB850-4 Models M & MT RB750-4 RB850-4 Models MA, SA, & TA RB750-4 RB850-4 Model H RB750-4 RB850-4 Model H Parts List RB750-4 RB850-4 Hydraulic Tilt KIT For Models MT & TARB750-4 RB850-4 Hydraulic Offset KIT For Model SAHydraulic Angle KIT Selector Valve KIT Selector Valve Relief Valve Relief Valve Cartridge 1600 psiHydraulic Cylinder Assembly & Parts List Seal Kit 3-1/2 Hyd CylinderPneumatic Tailwheel Assembly Wheel HUB, Tire & Wheel Assembly Skid Shoe KIT END Plate KITBolt Torque Chart SAE Series Torque ChartMetric Series Bolt Size Chart AbbreviationsWarranty Warranty

RB750-4, RB850-4 specifications

The Woods Equipment RB850-4 and RB750-4 are two powerful and efficient rotary tillers designed for serious lawn and garden care. Both models embody rugged construction and advanced technology, making them ideal choices for homeowners and professionals alike.

The RB850-4 offers an outstanding working width of 85 inches, enabling the user to cover a significant area in a shorter time frame. This model is equipped with four durable, cast iron gearboxes that facilitate smooth operation and prolong the lifespan of the equipment. The adjustable tilling depth allows operators to customize the soil preparation according to specific needs, whether for seedbed preparation or incorporating organic matter into the soil.

On the other hand, the RB750-4 features a slightly narrower working width of 75 inches, providing agility in tighter spaces without compromising performance. It also employs the same four cast iron gearboxes for reliable power distribution. The robust tines of both models are specifically designed for efficient soil mixing, turning and aeration, enhancing soil structure and health.

One of the main features of both the RB850-4 and RB750-4 is the innovative Quick-Connect attachment that streamlines the process of interchanging with other implements. This design principle enhances productivity, allowing users to quickly switch tools without wasting time. Moreover, both models are engineered for compatibility with a broad range of tractors, enhancing their adaptability across various farming and gardening applications.

The advanced technologies incorporated into these tillers also include a protective shield that reduces the risk of debris getting stuck in the tines. This not only extends the operational capability of the tillers but also enhances user safety during operation. Additionally, the rear roller on both models ensures a smooth finish, leveling the soil after tilling.

In summary, the Woods Equipment RB850-4 and RB750-4 rotary tillers combine power, efficiency, and versatility into a high-performance package. With their robust design, adjustable features, and advanced technologies, these tillers stand out in the market, promoting healthier soil and contributing to successful gardening and landscaping outcomes. Whether for intensive tilling or light garden maintenance, both models offer unparalleled value and reliability, making them a worthy investment for both amateur and professional users.
Top Page Image Contents