Woods Equipment RB750-4, RB850-4 manual Be Careful, Crushing Pinching Hazard

Page 8

SAFETY & INSTRUCTIONAL DECALS

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!

Replace Immediately If Damaged!

(Safety Decals continued from previous page)

3 - PN 1002941

WARNING

CRUSHING AND

PINCHING HAZARD

Be extremely careful handling various parts of the machine. They are heavy and hands, fingers, feet, and other body parts could be crushed or pinched between tractor and implement.

Operate tractor controls from tractor seat only.

Do not stand between tractor and implement when tractor is in gear.

Make sure parking brake is engaged before going between tractor and implement.

Stand clear of machine while in operation or when it is being raised or lowered.

FAILURE TO FOLLOW THESE

INSTRUCTIONS COULD

RESULT IN SERIOUS INJURY

OR DEATH.

1002941-A

4 - PN 1004250

WARNING

TO AVOID SERIOUS

INJURY OR DEATH:

Read Operator's Manual before operating, servicing, or repairing equipment. Follow all safety rules and instructions. (Manuals are available from dealer or call 1-800-319-6637.)

Operate from tractor seat only.

Lower equipment to ground, stop engine, remove key, and set brake before dismounting tractor.

Never allow children or untrained persons to operate equipment.

Never allow riders.

Keep bystanders away from equipment during operation. Keep all shields in place and in good condition.

FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN INJURY OR DEATH.

1004250

BE CAREFUL!

Use a clean, damp cloth to clean safety decals.

Avoid spraying too close to decals when using a pressure washer; high-pressure water can enter through very small scratches or under edges of decals causing them to peel or come off.

Replacement safety decals can be ordered free from your Woods dealer. To locate your nearest dealer, check the Dealer Locator at www.WoodsEquipment.com, or in the United States and Canada call 1-800-319-6637.

8 - PN 1003193

WARNING

Unit must not extend more than 4 feet left of center of the tractor when driving on public roads.

1003193-A

5 - PN 55121

WARNING

FALLING OFF CAN RESULT IN BEING RUN OVER.

„Tractor must be equipped with ROPS (or ROPS CAB) and seat belt. Keep foldable ROPS systems in “locked up” position at all times.

„Buckle Up! Keep seat belt securely fastened.

„ Allow no riders.

RAISED IMPLEMENT CAN DROP AND CRUSH.

„Never go underneath raised implement which can drop from equipment or tractor 3-point hitch hydraulic leak down, hydraulic system failures, movement of control levers or mechanical linkage failures.

„Service work does not require going underneath

implement. Read manual instructions.

FALLING OFF OR GOING UNDERNEATH IMPLEMENT

CAN RESULT IN SERIOUS INJURY OR DEATH.

55121--C

8 Safety

MAN0160 (Rev. 8/19/2005)

 

Image 8
Contents Rear Blades Introduction Table of Contents General InformationRB750-4 & RB850-4 Specifications ModelSafety Rules PreparationTraining OperationStorage MaintenanceTransportation Safety & Instructional Decals Replace Immediately If DamagedBe Careful Crushing Pinching HazardOperation Mount Blade to TractorBlade Angle Adjustment Reverse BladeTilt Adjustment Offset SwingPRE-OPERATION Check List BackfillingLeveling and Grading Cleaning LubricationBolts Blade Cutting EdgeDealer SET-UP Instructions AssemblyAssembly Table of Contents Main Assembly All Models Attach Blade to Pivot Assembly Attach Boom to Pivot AssemblyInstall Manual Tube Attach A-FrameInstall Slow Moving Vehicle Sign Refer to FigureModels M & MT Install Offset Linkage Manual ConfigurationAngle Kit Installation Models MT & TA Install Hydraulic Tilt Kit Tilt Kit Installation with Manual Angle ControlModel TA Install Hydraulic Tilt Kit Hydraulic Tilt and Angle Kit Hose RoutingOffset Angle Model H Install Hydraulic Cylinders OffsetInstall Relief Valves and Hoses OffsetInstall Selector Valve Kit 1004873 Optional Selector ValveInstall Selector Valve Kit Optional Cont’d Handle Kit Installed Route hoses as shown in FigureInstall Pneumatic Tailwheel 28775 Optional Optional Equipment ALL ModelsInstall Skid Shoe Kit 18296 Optional Skid Shoe InstallationDelivery Check List Install End Plate Kit 22658 OptionalPRE-DELIVERY Check List Assembly Parts Index Rear Blades RB750-4 RB850-4 Main Assembly RB750-4 RB850-4 Main Assembly Parts List Part QTY DescriptionRB750-4 RB850-4 Models M & MT RB750-4 RB850-4 Models MA, SA, & TA RB750-4 RB850-4 Model H RB750-4 RB850-4 Model H Parts List RB750-4 RB850-4 Hydraulic Tilt KIT For Models MT & TARB750-4 RB850-4 Hydraulic Offset KIT For Model SAHydraulic Angle KIT Selector Valve KIT Selector Valve Relief Valve Relief Valve Cartridge 1600 psiHydraulic Cylinder Assembly & Parts List Seal Kit 3-1/2 Hyd CylinderPneumatic Tailwheel Assembly Wheel HUB, Tire & Wheel Assembly Skid Shoe KIT END Plate KITMetric Series Bolt Torque ChartSAE Series Torque Chart Bolt Size Chart AbbreviationsWarranty Warranty

RB750-4, RB850-4 specifications

The Woods Equipment RB850-4 and RB750-4 are two powerful and efficient rotary tillers designed for serious lawn and garden care. Both models embody rugged construction and advanced technology, making them ideal choices for homeowners and professionals alike.

The RB850-4 offers an outstanding working width of 85 inches, enabling the user to cover a significant area in a shorter time frame. This model is equipped with four durable, cast iron gearboxes that facilitate smooth operation and prolong the lifespan of the equipment. The adjustable tilling depth allows operators to customize the soil preparation according to specific needs, whether for seedbed preparation or incorporating organic matter into the soil.

On the other hand, the RB750-4 features a slightly narrower working width of 75 inches, providing agility in tighter spaces without compromising performance. It also employs the same four cast iron gearboxes for reliable power distribution. The robust tines of both models are specifically designed for efficient soil mixing, turning and aeration, enhancing soil structure and health.

One of the main features of both the RB850-4 and RB750-4 is the innovative Quick-Connect attachment that streamlines the process of interchanging with other implements. This design principle enhances productivity, allowing users to quickly switch tools without wasting time. Moreover, both models are engineered for compatibility with a broad range of tractors, enhancing their adaptability across various farming and gardening applications.

The advanced technologies incorporated into these tillers also include a protective shield that reduces the risk of debris getting stuck in the tines. This not only extends the operational capability of the tillers but also enhances user safety during operation. Additionally, the rear roller on both models ensures a smooth finish, leveling the soil after tilling.

In summary, the Woods Equipment RB850-4 and RB750-4 rotary tillers combine power, efficiency, and versatility into a high-performance package. With their robust design, adjustable features, and advanced technologies, these tillers stand out in the market, promoting healthier soil and contributing to successful gardening and landscaping outcomes. Whether for intensive tilling or light garden maintenance, both models offer unparalleled value and reliability, making them a worthy investment for both amateur and professional users.