Woods Equipment RB750-4, RB850-4 manual Dealer SET-UP Instructions, Assembly Table of Contents

Page 14

ASSEMBLY

￿￿￿￿￿￿￿

CAUTION

„Before dismounting power unit or performing any service or maintenance, follow these steps: disengage power to equipment, lower the 3-point hitch and all raised components to the ground, operate valve levers to release any hydraulic pressure, set parking brake, stop engine, remove key, and unfasten seat belt.

„Before working underneath, read manual instructions, securely block up, and check stabil- ity. Secure blocking prevents equipment from dropping due to hydraulic leak down, hydraulic system failure, or mechanical component failure.

„Keep all persons away from operator control area while performing adjustments, service, or maintenance.

„Keep hands and body away from pressurized lines. Use paper or cardboard, not hands or other body parts to check for leaks. Wear safety gog- gles. Hydraulic fluid under pressure can easily penetrate skin and will cause serious injury or death.

„Make sure that all operating and service per- sonnel know that if hydraulic fluid penetrates skin, it must be surgically removed as soon as possible by a doctor familiar with this form of injury or gangrene, serious injury, or death will result. CONTACT A PHYSICIAN IMMEDIATELY IF FLUID ENTERS SKIN OR EYES. DO NOT DELAY.

„Always wear relatively tight and belted cloth- ing to avoid entanglement in moving parts. Wear sturdy, rough-soled work shoes and protective equipment for eyes, hair, hands, hearing, and head.

„Tighten all bolts, nuts and screws to torque chart specifications. Check that all cotter pins are installed securely to ensure equipment is in a safe condition before putting unit into service.

DEALER SET-UP INSTRUCTIONS

Assembly of this equipment is the responsibility of the Woods dealer. It should be delivered to the owner completely assembled, lubricated, and adjusted for normal operating conditions.

Assembly will be easier if components are aligned and loosely assembled before tightening hardware. Recommended torque values for hardware are located on page 47.

ASSEMBLY TABLE OF CONTENTS

MAIN ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15

MANUAL CONFIGURATION

OFFSET LINKAGE - MODELS: M & MT. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18

HYDRAULIC ANGLE KIT - MODELS: MA, SA, TA, AND OPTIONAL KIT 1004870 . . . . . . . . . . 19

HYDRAULIC TILT KIT - MODELS: MT & TA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20

HYDRAULIC OFFSET KIT - MODEL: SA AND OPTIONAL KIT 1004872 . . . . . . . . . . . . . . . . . . 22

HYDRAULIC CONFIGURATION

MODEL H . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 SELECTOR VALVE KIT 1004873 (OPTIONAL) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25

OPTIONAL EQUIPMENT - ALL MODELS

PNEUMATIC TAIL WHEEL (OPTIONAL) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 SKID SHOE KIT 18296 (OPTIONAL) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 END PLATE KIT 22658 (OPTIONAL) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 PRE-DELIVERY & DELIVERY CHECK LISTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29

14 Assembly

MAN0160 (Rev. 2/22/2006)

 

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Rear Blades Introduction Table of Contents General InformationRB750-4 & RB850-4 Specifications ModelTraining Safety RulesPreparation OperationStorage MaintenanceTransportation Safety & Instructional Decals Replace Immediately If DamagedBe Careful Crushing Pinching HazardOperation Mount Blade to TractorBlade Angle Adjustment Reverse BladeTilt Adjustment Offset SwingPRE-OPERATION Check List BackfillingLeveling and Grading Bolts CleaningLubrication Blade Cutting EdgeDealer SET-UP Instructions AssemblyAssembly Table of Contents Main Assembly All Models Attach Blade to Pivot Assembly Attach Boom to Pivot AssemblyInstall Manual Tube Attach A-FrameInstall Slow Moving Vehicle Sign Refer to FigureModels M & MT Install Offset Linkage Manual ConfigurationAngle Kit Installation Models MT & TA Install Hydraulic Tilt Kit Tilt Kit Installation with Manual Angle ControlModel TA Install Hydraulic Tilt Kit Hydraulic Tilt and Angle Kit Hose RoutingOffset Angle Model H Install Hydraulic Cylinders OffsetInstall Relief Valves and Hoses OffsetInstall Selector Valve Kit 1004873 Optional Selector ValveInstall Selector Valve Kit Optional Cont’d Handle Kit Installed Route hoses as shown in FigureInstall Pneumatic Tailwheel 28775 Optional Optional Equipment ALL ModelsInstall Skid Shoe Kit 18296 Optional Skid Shoe InstallationDelivery Check List Install End Plate Kit 22658 OptionalPRE-DELIVERY Check List Assembly Parts Index Rear Blades RB750-4 RB850-4 Main Assembly RB750-4 RB850-4 Main Assembly Parts List Part QTY DescriptionRB750-4 RB850-4 Models M & MT RB750-4 RB850-4 Models MA, SA, & TA RB750-4 RB850-4 Model H RB750-4 RB850-4 Model H Parts List RB750-4 RB850-4 Hydraulic Tilt KIT For Models MT & TARB750-4 RB850-4 Hydraulic Offset KIT For Model SAHydraulic Angle KIT Selector Valve KIT Selector Valve Relief Valve Relief Valve Cartridge 1600 psiHydraulic Cylinder Assembly & Parts List Seal Kit 3-1/2 Hyd CylinderPneumatic Tailwheel Assembly Wheel HUB, Tire & Wheel Assembly Skid Shoe KIT END Plate KITMetric Series Bolt Torque ChartSAE Series Torque Chart Bolt Size Chart AbbreviationsWarranty Warranty

RB750-4, RB850-4 specifications

The Woods Equipment RB850-4 and RB750-4 are two powerful and efficient rotary tillers designed for serious lawn and garden care. Both models embody rugged construction and advanced technology, making them ideal choices for homeowners and professionals alike.

The RB850-4 offers an outstanding working width of 85 inches, enabling the user to cover a significant area in a shorter time frame. This model is equipped with four durable, cast iron gearboxes that facilitate smooth operation and prolong the lifespan of the equipment. The adjustable tilling depth allows operators to customize the soil preparation according to specific needs, whether for seedbed preparation or incorporating organic matter into the soil.

On the other hand, the RB750-4 features a slightly narrower working width of 75 inches, providing agility in tighter spaces without compromising performance. It also employs the same four cast iron gearboxes for reliable power distribution. The robust tines of both models are specifically designed for efficient soil mixing, turning and aeration, enhancing soil structure and health.

One of the main features of both the RB850-4 and RB750-4 is the innovative Quick-Connect attachment that streamlines the process of interchanging with other implements. This design principle enhances productivity, allowing users to quickly switch tools without wasting time. Moreover, both models are engineered for compatibility with a broad range of tractors, enhancing their adaptability across various farming and gardening applications.

The advanced technologies incorporated into these tillers also include a protective shield that reduces the risk of debris getting stuck in the tines. This not only extends the operational capability of the tillers but also enhances user safety during operation. Additionally, the rear roller on both models ensures a smooth finish, leveling the soil after tilling.

In summary, the Woods Equipment RB850-4 and RB750-4 rotary tillers combine power, efficiency, and versatility into a high-performance package. With their robust design, adjustable features, and advanced technologies, these tillers stand out in the market, promoting healthier soil and contributing to successful gardening and landscaping outcomes. Whether for intensive tilling or light garden maintenance, both models offer unparalleled value and reliability, making them a worthy investment for both amateur and professional users.
Top Page Image Contents