DEALER CHECK LISTS
PRE-DELIVERY CHECK LIST
(DEALER’S RESPONSIBILITY)
Inspect the equipment thoroughly after assembly to make sure it is set up properly before delivering it to the customer. The following check list is a reminder of points to inspect. Check off each item as it is found sat- isfactory, corrections are made, or services are per- formed.
___ | Check that all safety decals are installed and in |
| good condition. Replace if damaged. |
___ | Check that all shields and guards are properly |
| installed and in good condition. Replace if dam- |
| aged. |
___ | Properly attach implement to power unit and |
| make all necessary adjustments. |
___ | Check all bolts to be sure they are properly |
| torqued. |
___ | Check that all cotter pins and safety pins are |
| properly installed. Replace if damaged. |
___ | Check and grease all lubrication points. |
___ | Check the level of gearbox fluids before delivery. |
___ | Run unit immediately following |
| check systems operation including hydrostatic |
| neutral and safety switch system (page 12). |
___ | Check all fluid levels. See Owner Service section. |
___ Check tire pressure. See Assembly section.
DELIVERY CHECK LIST
(DEALER’S RESPONSIBILITY)
___ Show customer how to make adjustments.
___ | Instruct customer how to lubricate and explain |
| importance of lubrication. |
___ | Point out the safety decals. Explain their meaning |
| and the need to keep them in place and in good |
| condition. Emphasize the increased safety haz- |
| ards when instructions are not followed. |
___ | Present Operator's Manual and request that cus- |
| tomer and all operators read it before operating |
| equipment. Point out the manual safety rules, |
| explain their meanings, and emphasize the |
| increased safety hazards that exist when safety |
| rules are not followed. |
___ | Show customer how to make sure driveline is |
| properly installed and that |
| ing pin or collar slides freely and is seated in |
| groove on power unit PTO shaft. |
___ | Show customer the safe, proper procedures to be |
| used when mounting, dismounting, and storing |
| equipment. |
___ | Make customer aware of optional equipment |
| available so that customer can make proper |
| choices as required. |
❖
MAN0646 (Rev. 11/5/2007) | Dealer Check Lists 29 |
| |
|
|