Assembly Instructions

DEALER SET-UP INSTRUCTIONS

Assembly of this cutter is the responsibility of the WOODS dealer. It should be delivered to the owner completely assembled, lubricated and adjusted for nor- mal cutting conditions.

The cutter is shipped partially assembled. Assembly will be easier if components are aligned and loosely assembled before tightening hardware. Recommended torque values for hardware are located on page 76.

Select a suitable working area. A smooth hard surface, such as concrete, will make assembly much quicker. Open parts boxes and lay out parts and hardware to make location easy. Refer to illustrations, accompany- ing text, parts lists and exploded view drawings.

Complete the check list on page 45 when assembly is complete and cutter is delivered to the customer.

Before working underneath, carefully read Oper- ator’s Manual instructions, disconnect driveline, raise mower, securely block up all corners with jackstands, and check stability. Secure blocking prevents equipment from dropping due to hydrau- lic leak down, hydraulic system failures, or mechanical component failures.

Do not disconnect hydraulic lines until machine is securely blocked or placed in lowest position and system pressure is released by operating valve levers.

CAUTION

Always wear relatively tight and belted clothing to avoid entanglement in moving parts. Wear sturdy, rough-soled work shoes and protective equipment for eyes, hair, hands, hearing, and head; and respirator or filter mask where appropriate.

Fill Gearboxes

1.Remove top and side plugs from gearbox.

2.Fill gearbox with SAE 80W or 90W EP oil until it runs out of side level hole. Install plug in the side hole and vented dipstick or vent plug in the top.

3.Allow oil to drain into the lower bearings and recheck oil level.

4.Fill all gearboxes.

Install Attitude Rod

1.Insert attitude rod (6) under splitter gearbox support and through pivot casting in wheel yoke arm assembly. The rod is a very tight fit; use care to prevent thread damage during installation.

2.Slide spacer (52) over rod and loosely install washer (107) and two nuts (109).

	Attitude Rod Length
Small Aircraft Tires	Beyond Nuts (34)

Tongue at 11"	3.5

Tongue at 18"	1.75

Large Aircraft Tires

Tongue at 11"	4.5

Tongue at 18"	2.5

6. Attitude Rod

52.1" x 3.75 Spacer, Pipe Schedule 40 107.1" Flat Washer

109.1" Hex Nut

Figure 24. Attitude Rod Installed on Wheel Yoke Tube

Install Spring Arm

Refer to Figure 25.

1.Place spring arm (43), spacers (53), and spring

(44)on deck as shown.

2.Secure spring arm and spacers to lugs on deck using clevis pin (55) and two cotter pins (62).

3.Install retaining cap screw (85) and flange lock nut

(88).

MAN0962 (1/9/2012)	Assembly 33