Install Height Adjustment Cylinder | Install SMV Emblem |
Refer to Figure 25.
1.Attach base end of cylinder (45) to the spring arm (43) using clevis pin (54) and two cotter pins (62).
2.Extend cylinder rod and place transport lock bracket (46) over cylinder rod clevis.
3.Position cylinder rod and transport lock bracket between lugs on the wheel yoke tube and align holes.
4.Secure cylinder rod and transport lock bracket to the wheel yoke tube using clevis pin (56) and two cotter pins (62).
5.Install bushing (90), elbow, (69) and hose (59) to the base end of cylinder (45). See Install Hose Kit, page 39 for complete instructions.
Refer to Figure 25.
1.Attach SMV mounting bracket (48) to left side of center section as shown using two carriage bolts (81) and flange lock nuts (88).
2.Attach SMV socket (49) to mounting bracket (48) using two carriage bolts (70) and lock nuts (75).
3.Attach SMV emblem (51) to SMV bracket (50) using two round head cap screws (67) and hex nuts (68).
Insert SMV bracket (50) and emblem (51) into socket (49).
43.Spring Arm
44.Compression Spring, 3.25 x .69 x 9.5
45.Hydraulic Cylinder
46.Transport
48.SMV Mounting Link
49.SMV Socket
50.SMV Bracket
51.SMV Emblem
53.Spacer, 1"
54.1 x 2.72 Headless Pin
55.1 x 4.58 Headless Pin
56.1 x 5.08 Headless Pin
59.1/4 x 1/4 x 156 Hose
62.1/4 x
67.1/4 NC x 1/2 Round Head Screw
68.1/4 NC Hex Nut
69.1/4 NPT x 1/4 NPT Elbow w/Restrictor
70.5/16 NC x 3/4 Carriage Bolt
75.5/16 NC Flange Lock Nut
81.1/2 NC x
85.1/2 NC x 5 Hex Head Cap Screw
88.1/2 NC Flange Lock Nut
90.1/2 NPT x 1/4 NPT Reducer Bushing
Figure 25. Spring Arm and Cylinder Installation
34 Assembly | MAN0962 (1/9/2012) |
|
|